1. a bow uses a 16-gram arrow as its ammo, and its string behaves as an ideal spring. When the string is fulled back at 85cm, a force of 200 N is needed. Find the maximum height of the dovrow if shot upward if using this length. Neglect air resistance as the arrow travels.

1. a bow uses a 16-gram arrow as its ammo, and its string behaves as an ideal spring. When the string is fulled back at 85cm, a force of 200 N is needed. Find the maximum height of the dovrow if shot upward if using this length. Neglect air resistance as the arrow travels.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please solve the following
An engineer trying to determine whether her crane will tip over when attempting to lift a 29K load. Her crane has a 5K chassis and 50K counterweight. Assume all other parts of the crane have negligible weight. 5ft Answer all questions relative to the rotation point. How much torque is caused by the load? unit v How much torque is caused by the chassis? unit How much torque is caused by the counterweight? unit v counter BARNHART weight What would happen if the crane tried to lift the load? finalize (after completing ALL problems) check answers cannot be 16: rotational motion, review os Scientific Online Calculator
Q2/ The out – of - balance of a machine rotor is equivalent to 5 kg at 10 mm radius in one plane A, together with an equal mass at 15 mm radius in a second plane B. AB = 375 mm and the two radii are 120°. Find the mass required in third plane C at a radius of 125 mm and its angular position with respect to the given radii so that there is no resultant out - of - balance force. Find also the position of C along the axis for the residual couple to be a minimum and of this couple when the speed is 500 г.p.m.
A) A 1.2 kg block slides down a frictionless incline with a slope angle of 42°, starting from a height h =3.2 m above the bottom of the incline, as shown in Figure (2). The incline meets a frictionless horizontal surface, at the end of which is a spring in its equilibrium position (k = 460 N/m) used to stop the block. Find the maximum compression of the spring.
Find the gradient of a crawler tractor pulling a loaded rubber tire skimmer using the following information: The horsepower of the tractor is (180) horsepower. . Tractor weight (20.25) tons. The traction force of the crawler tractor in the first gear is (15300) kg. The weight of the loaded skimmer is (39.48) tons . The dirt road is not good. Rolling resistance of the tractor (73) kg / ton. The rolling resistance of the skimmer is (95) kg/ton.
A uniform horizontal beam with a length of 1.7 m and a weight of 200 N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of 35.0° with the horizontal. If a crate of mass (M) 87 kg hanged 1.7 m from the wall, find the tension in the cable, as well as the magnitude and direction of the resultant force exerted by the wall on the beam.
1. A force of 200N is used to stretch with a 0.75kg mass attached to it by 0.35m. (a) What is the value of the spring constant? 200 N 0.75kg
Q3. As shown on the right in image below, the force Facting on the box varies with displacement s, and the coefficient in the image, C = 14. Determine the work done by force Fto the box when the box has displaced s = 1.9 m. Please pay attention: the numbers may change since they are randomized. Negative sign must be included if the work done is negative. Your answer must include 2 places after the decimal point, and proper SI unit. F (N) F 5 3 S 4 C s (m) 1 2
Q2: A A body thrown vertically upward with velocity of 30 m/s. Find the distance it will cover in 4 second. B. A body of weight 200 N is lying on a rough horizontal plane having a coefficient of friction as 0.4. Find the magnitude of the force which can move the body while acting at an angle of 30* with the horizontal as shown in figure. 30 f W
Calculate the tensions in cables AC and AB needed to hold the ball. Assume the ball mass is 45 kg, the force F is 750 N and the dimension d is 1.75 m. 15m AC Tension is O 1300 N O 1.3 KN O 1379.66 N O 1.38 KN
A 25.5 kg mass (m) is suspended by the cable assembly as shown in the figure. The cables have no mass of their own. The cable to the left (T) ) of the mass makes an angle of 0.00 with the horizontal, and the cable to the right (T;) makes an angle (02) of 40.6. If the mass is at rest, what is the tension in each of the cables, T and T; ? The acceleration due to gravity is g = 9.81 m/s?. T T = 123.52 N 123.52 TOOLS x10
The automated drilling robot must withstand a 38 pound thrust at the tip of the bit. Determine the AC torque that the electric motor must develop to resist this thrust. A) force of the BE element: B) thrust moment of the AC electric motor: