1. Α 10 μ F, 20 μF, 22 μF, and 100 μ F capacitor are in parallel. The total capacitance is ® 2.43 μF ( ® 4.86 μ F 100 μ F
Q: Synchronous Motor taking a 40 kW is working in parallel with a load of 80 kW having a power factor…
A: The motor is taking real power of kW.Load is absorbing a real power of kW.The power factor of the…
Q: 4) In a data transmission Hamming coding is used for drug correction (n=5){(k=2) code word is…
A: In a Hamming code with n=5, k=2, data word is as, We need to determine:i) how many bit error can be…
Q: Evaluate the operation of Thevenin and Norton theorems used in the tasks 3 and 4, by firstly…
A: Thevenin's Theorem states that any linear electrical network with voltage and current sources can be…
Q: A 3-phase, 50 Hz transmission line with a total series impedance of 34 + j140 2 and shunt admittance…
A: In this question, we need to determine the sending end line voltage.
Q: Design a 5 elements Yagi antenna with operating frequency of 800MHz and dipole as driven element.…
A: The objective of the question is to design a 5 elements Yagi antenna with an operating frequency of…
Q: Q2\ perform arithmetic operation for each the following: 1- (074B) 16 (587C) 16 2- (7602)8+ (5771)8…
A: we need to perform arithmetic operation for:
Q: What is the skin effect in conductors? How does it impact the performance of high-frequency AC…
A:
Q: The current wave form is shown in the figure below. What is the average value over the time interval…
A: Given data:Required information:
Q: In the figure, the value of resistor R is (25 + 1/ 2) ohms, where I is the current in amperes. The…
A: Given data:Resistance, Voltage, V = 300 V.Required information:
Q: Q2/ The three-phase power and line-line ratings of the electric power system shown in the figure…
A:
Q: Shar esign a ten-stage impulse generator generate a 1.2/200 (usec.) lighting impulse. Assume that…
A:
Q: Figure 1 shows the Nyquist plot of an open loop transfer functions G(s)H(s) of a feedback control…
A: Given a Nyquist plot of an open loop ptransfer function, G(s)H(s),we need to do:a) Comment on…
Q: 3. Considerar la señal r(t) y su señal modulada xm (t) = x(t) cos (wet). Se asume que r(t) es de…
A:
Q: A Synchronous Motor taking 40kW is working in parallel with a load of 80kW having a power factor of…
A: The objective of the question is to find the power factor and the reactive KVA of a synchronous…
Q: Describe the construction and operation of a DC Motor. How is speed controlled and can the motor be…
A: Asked to explain the construction of DC motor?Operation of DC motor?Speed control and motor reversal…
Q: b) A PCM system uses 2 bits per codeword. No codeword spans the 0 volt level. The quantization gap,…
A: According to the question, the given PCM system uses 2 bits per codeword. The quantization gap is .…
Q: 3. A source of information produces equaiprobable blocks of 4-bits. The encoder circuit adds an even…
A: The input-output relationship of an encoder circuit is represented by an encoder table. This makes…
Q: . What do you mean by aperture antenna? Explain the construction, working principle and the feeding…
A: An aperture antenna is a type of antenna where the size of the antenna is significantly larger than…
Q: Surge impedance of 3 Phase, 400 kV transmission line is 200 Q. The surge impedance loading of the…
A: Given data:Required information:
Q: A CMOS inverter is to be designed to have mid-point voltage V₁ equal to half of Vdd. Given the…
A:
Q: You are required to design a PID controller for the following system. All of the calculations must…
A: The objective of the question is to design a PID (Proportional-Integral-Derivative) controller for a…
Q: of 1 200 0 ww ww 100 (1 75 mH Part A At t=0 s, the current in the circuit in the figure is Io. At…
A: Given circuit,At t=0 the current is IoAsked to find at what time the current becomes 0.5Io = ?
Q: Three resistors are connected in series namely R1, R2 and R3. It is impressed by a voltage source E.…
A: The objective of the question is to determine which resistor among R1, R2, and R3 will have the…
Q: Compute the value of DC resistance and AC resistance of a Germanium junction diode at 250C with…
A:
Q: A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a…
A: Given data:Required information:
Q: 3. Given the information appearing in Fig. 4.120, determine: a. lc. Voc b. Vcc c. B. d. Rg. Es la=…
A: For transistor emitter current Ie = collector current Ic + base current Ib.Use above equation to…
Q: There are three branches namely Branch A, Branch B and Branch C. Branch A consists of resistor with…
A: In this question, we need to choose the correct option. What is power absorbed by 10 ohm resistance.…
Q: (Note: this is the same circuit as the previous question) Which of the following is the correct…
A: Given circuit,Asked to find the transfer function
Q: Figure Q2 shows an RLC circuit with an input voltage v() and an output voltage v, across the…
A: In this question, we need to determine the state space equation. Variables are Vc and current iL .
Q: A balanced load is connected in star across a 3 phase 415V 50Hz supply. The load consists of a coil…
A: Given data,3 phase Supply voltage V=415V Frequency (f)=50Hzload consists of a coil of resistance…
Q: D 4.7 For the logic gate of Fig. 4.5(a), assume ideal diodes and input voltage levels of 0 V and +5…
A: Given circuit is,Suppli
Q: TASK 2: Find the current flowing in the 6.2 resistor for the network shown below (fig 2). Find also…
A: circuit diagramwe have to findcurrent flowing through 6 ohm resistorpotential drop across 20 & 4…
Q: Q2. a) A four-pole, 415 V 50Hz induction motor supplies its rated power to a constant load. The…
A: Given dataNote: “Since you have posted question with multiple sub parts, we will provide the…
Q: a single-phase transformer serves a 7.2kw resistive loadlocated 200 ft from the transformer. each…
A: The objective of this question is to find the magnitude of the voltage at the transformer secondary…
Q: Given the circuit in Figure 3-2, how much current is flowing through the circuit? O 3.84 μA 0.26 mA…
A: In the given circuit the value of the unknown current needs to be calculated and the same can be…
Q: a) What is the maximum current at any time in the circuit? b) Write Equation of capacitor voltage in…
A: A capacitor is an electronic component that stores electrical energy in an electric field. It…
Q: Q1A If the signal 4 cos (2r10³t) is used to modulate 13 cos (27 10°t) carrier, (a) find the…
A: The objective of the question is to find the transmission efficiency, total and USB powers of an AM…
Q: Which of the following types of photodiodes has improved efficiency in creating external current and…
A: Given that ,Photo diodes are semiconductor devices which works by incidenting light(photons). These…
Q: A pulse width modulation (PWM) system uses a carrier frequency of 1 kHz and encodes 1s and 0s by…
A: A pulse width modulation (PWM) system uses a carrier frequency of fc=1 kHz and encodes 1s and 0s by…
Q: 4. Find the branch current analysis at the circuit shwon in figure R₁ loon E₁ 15 V R, 220 2 E₁20 V…
A:
Q: 6. Find the current I (mA) in the circuit shown below.
A: Given data:Required information:
Q: A 90 MW, 11 kV generator has an inertia constant H = 3s. The stored energy in the rotor at…
A: Given data:S = 90 MW,H = 3sV=11 kVRequired information:
Q: (a) Design and implement the give expression from given de voltage Vdc-10v using op-amp.R2=100ohm…
A: An operational amplifier, often abbreviated as op-amp, is a versatile and widely used analog…
Q: 1. Using the DC circuit trainer, Connect the circuit shown below: b 5V R₁ 100 Ω 120, O R2₂ R3. 5600…
A:
Q: Ali K. Abdul Abbas Q1] Select the correct answer: (9 Marks) 1- Which of the following statements is…
A: The objective of the question is to test the understanding of various concepts related to DC motors,…
Q: Q13) Plot the amplitude spectrum of the sampled signal X, (f) in the previous question with sampling…
A:
Q: Q1A If the signal 4 cos (2r10³t) is used to modulate 13 cos (27 10°t) carrier, (a) find the…
A: The objective of the question is to find the transmission efficiency, total and USB powers of an AM…
Q: A 480-V, 100-kW, 50-Hz, four-pole, Y-connected synchronous motor has a rated power factor of 0.85…
A: Given data:Required information:
Q: Q2) Answer the following questions: a) For the balanced bridge circuit shown find R4 RT IT E= 200V-…
A: In this question, we need to determine the resistance R4, equivalent resistance and equivalent…
Q: Q₁: A 4-pole, 460 V, 60 Hz, 3-phase induction motor star connected has the following circuit model…
A: As we have given :Asked to find the,Input current, Gross torque and efficiency.Maximum gross power…
Step by step
Solved in 3 steps with 6 images
- Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 45017 Three capacitors, C1 = 5 µF, C2 = 10 µF and C3 = 20 µF are connected in parallel across a 150-V source. Determine the charge on capacitor C2 1.5 mC 1500 C 150 C 15 mc 1.5 μC 15 C 1.5 C Ο 15 μεFor the inductor in the figure, find the inductance L in henries. 1 = 100 mm Air core d = 5 mm 200 turns A 39.87 uH B 19.87 µH c) 9.87 pH D 29.87 µH
- A 10 µF, a 15µF, and a 100µF capacitor are connected in parallel across 50V source. Determine the following: Total capacitance. Write the answer in µF G M k m Vμ K n Р 10⁹ 106 10³ 10-³ 10-6 10-⁹ 10-12 1 000 000 000 1 000 000 1 000 0,001 0,000001 0,000000001 0,000000000001Determine the equivalent inductance LAB (in mH) between terminals A & B. 350 mH 200 mH 700 mH كسر 400 mH 600 mH m A B 300 mHFind the equivalent inductance seen at the terminals of the circuit L3 30mH Lea L4 6mH L1 L2 18mH 36mH 9 mH NONE 36 mH O 18 mH
- Four 0.15 μF capacitors are in parallel. The total capacitance is 0.15 μ F 0.30 μ F 0.6 μ F 0.8 μF A. Β. C. D.The area of a Parallel plate capacitor is 20 in². Give the answer in m² O 12.9 x 10-4 m² O 12.9 x 10-3 m² O 6.452 x 10-4 m² O 12.9x10-³m²Question 5 What is the equivalent inductance between nodes a and b? 6 mH 3 mH 6 тH 6 mH ll 2.6 mH O 5.0 mH О 1.2 mH О 21.0 mH ll ll
- Refer to Figure If 50V is applied across the capacitors, determine Q. Write the answer in mC 30 μF 60 µF 20 µF ▬HE HE C₁ C2 C 3 -What is the equivalent inductance between nodes a and b? 6 mH 3 тH 6 тH 6 mH ll O 2.6 mH O 5.0 mH О 1.2 mH O 21.0 mH ll ll 10What is the capacitance of five capacitors connected in series with values of 0.01 uF? 0.05 uF 0.02 uF 0.005 uF 0.002 uF