1) Find the true magnitude and direction of the forces at the supports A and B in the case of static equilibrium. Fig 2.1 -200lb 100lb +y 100lb/ft 6' 7.5- 9' 12 20- Fig 2.1 FREE BODY DIAGRAM

Q: There is a pulley keeping the 30 lb force in balance. Find the forces at C keeping the whole unit in…

A:

Q: Find the true magnitude and direction of the forces at the supports A and B at static equilibrium…

A: Given data Given force system

Q: Answer the following questions: 1. Draw a Free Body Diagram with forces and reactions. 2. What are…

A:

Q: W 30 A.

A: given:

Q: 4000 N 1.0m 2.0 m 20m 2000 N

A: ∑Fx=0Fcosθ+4000=0Fcosθ=-4000N .....(1)∑Fy=0Fsinθ-2000=0Fsinθ=2000 ........(2)

Q: 900 lb 600 lb 4 ft +4ft 4 ft 3 ft B If the truss shown above is in static equilibrium as loaded,…

A:

Q: Select the best answer) The plate is supported by a hinge at B and a roller at A. The hinge is usty.…

A: The plate is supported by hinge at B and Roller at A. What are the support reactions?

Q: 2) Find the true magnitude and direction of the forces in all the members of the truss AB AND AC at…

A: Solution:

Q: Draw the free-body diagram for the frame shown in Fig. 3. The frame is in equilibrium case.

A: Free-body diagram for the frame shown in Fig. 3 is as follows

Q: Two farmers are pushing on a gate with forces FA and FB, applied at locations A and B respectively.…

A:

Q: review engineering statics Take d1 = 600 mm, d2 = 800 mm, θθ = 45° and F = 500 N (a) Show that…

A: To find support reaction at point A,B,D

Q: olve the q on top

A:

Q: Situation 3: Use method of section: Find the force in member BH? *

A: Consider the force diagram of the truss as, Now consider the equilibrium equation, for x and y…

Q: 18 ft 24 ft 10 ft 6ft

A: Given that, Weight of each light, W= 65 lb, Drawing the FBD of the light, The angle θ…

Q: 1) Find the true magnitude and direction of the forces at the supports A and B in the case of static…

A: Static Equilibrium: A body is said to be in static equilibrium if it satisfies the following…

Q: #4 A small winch is used to raise a 120 Ib load. Determine the reaction forces at points A and B. -…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: 1. A traffic light hangs from the cables as shown in the figure. If T₁ = 100 N, how much is tension…

A:

Q: aring at its contact point B for equilibrium. b) Determine the magnitude of the normal

A:

Q: Determine the force in each member of the loaded truss. All triangles are 3-4-5. Enter a positive…

A: To find: The forces in each member of the truss. Free body diagram: The free body diagram of the…

Q: The mass of the wheelbarrow and its load is 50.0 kg. The upward force to lift the wheelbarrow has a…

A: Given data , m= 50 kg  So wt. W= mg= 50*9.81= 490.5 N  d1=0.95 m  d2= 0.08 m

Q: 0.5 P 4 ft B 4 ft -3 ft Given P = 300 lb what are the reactions at the pin support E?

A: given- P=300 lbfind- reaction at E

Q: - Neglecting friction forces, and the radius of the pulley. Determine the following: 1- The tension…

A: Given

Q: In the structure below, member AB is attached to the wall with a fixed support at A and is attached…

A:

Q: Each spring has an unstretched length of 2 m and a stiffness of k = 330 N/m .(Figure 1) Figure ▼…

A:

Q: Where must the 2.2 kN force be enforced so that the bar A whose mass is insignificant will be in…

A:

Q: Find the true magnitude and direction of the forces in all the members of the truss AB and AC at…

A:

Q: P: 2 KN 0.Sm OF o.cm - -o. 3 m→ The 0.5 m long rods AC and BD are made of Aluminum and each has a…

A: AC=0.5M ,         BD=0.5M A=200MM ,      (C/S  AREA) AC  & BD made of aluminum

Q: 1. Fig. 1 shows a simple six bar linkage held in static equilibrium while a force P= 750 N is…

A:

Q: Draw the free- statement. You are NOT required to write or solve any equilibrium equation should…

A: Given-Information:- Length AD, l = 4.5 m To-Determine:- 1. Reaction at pin A. 2. Force in the cable…

Q: A bag of cement with a mass of 100kg hangs in equilibrium from three wires as shown in the figure…

A: Given data  mass of cement bag (m) = 100 kg  θ1 = 40o θ2 = 30o To determine  Tension in string 1…

Q: review engineering  statics  Take d1 = 600 mm, d2 = 800 mm, θθ = 45° and F = 500 N (a) Show that…

A: Given data  Given force system

Q: The members of the truss are pin connected at the joint O in Figure 1 i. Determine components of the…

A: Let F1=Fx i+Fy j Where Fx is horizontal  and Fy is vertical component  In horizontal direction the…

Q: The steel beam shown has a weight of 375 ground by a hinge. It makes an angle of 60° with the…

A: we have to determine the tension in the string

Q: Question 3 When the structure shown in figure (3) below is supported at point P, it is in…

A:

Q: 14- Cold water (cp _ 4.18 kJ/kg · °C) leading to a shower enters a well- insulated, thin-walled,…

A:

Q: When the structure shown in figure (3) below is supported at point P, it is in equilibrium. If the…

A:

Q: Find the support reaction below. Ax,Ay,By

A:

Q: Question 3 äbäi 35 The frame A B C shown in the Fig. below, the frame is attached with cable at D…

A: Given data: -  The angle of AB is θ = 60o. The angle of CB is θ' = 30o. The downward force acting…

Q: 1) Find the true magnitude and direction of the forces at the supports A and B in the case of static…

A: Given, Load 1 = 100 lb Load 2 = 200 lb UDL= 100 lb/ft

Q: Three force P=255, F=510, and Q=510 KN, P 2.4 m F B 2.4 m D E 2.4 m F G - 4.5 m the vertical…

A: We are suppose to solve only 3 subparts so please post other parts as separate question.

Q: a) If d = 1.0 m, 0 = 20°, and P = 1400 N, determine the magnitude of the normal reaction between the…

A: According to the given data d=1m P=1400N θ=20° We need to find (a) Normal reaction at A (b)Normal…

Q: The 0.5 m long rods AC and BD are made of Aluminum and each has a cross- sectional area of 200 mm2…

A:

Q: Find the tension in the cables and reaction force at point O.

A: