1- Answer with true or false and explain the statement below MOV CS, DS 2. A 16-bits address bus can generate. a) 32767 b) 25652 c) 65536 d) None of the mentioned _addresses.
Q: RS232 connection has one start bit, one stop bit, and even parity. If 1000 bytes of data is…
A: We are authorized to answer one question at a time. Since you have not mentioned which question you…
Q: Q1: Implement a H.A logic equation for sum and carry using NAND gates only then verify the truth…
A:
Q: COMPLETE SOLUTION Derive the truth table, simplified Boolean function (equation), and draw the…
A: NAND gate is the complement of AND gate. NAND gate is combination of AND gate and not gate. Figure…
Q: 4. FIGURE 1 shows how a 3 to 8 line decoder (TTL 74138) can be used in conjunction with NAND gate…
A: From the above question, we need to calculate a Address of the address bus in order to read the…
Q: Subject: Computer Networks Note: Please answer in own words. copy from internet will very unhelpful…
A: The timing diagrams of two different connection of TCP:
Q: clock signal frequency for a 4-bit up counter is 20kHz. What is the frequency of the most valuable…
A: Option :b Answer
Q: Design a combinational circuit, using the block diagram of Decoders and external gates to accept…
A:
Q: Design a 3Bit Odd Parity Detector using :a) Multiplexer b) Decoder, and appropriate gates?
A: To design a 3 bit odd parity detector, we will use 3 bits A, B, C & output will be Y Therefore…
Q: Derive the truth table, simplified Boolean function (equation), and draw the logical diagram:…
A:
Q: RS232 connection has one start bit, one stop bit, and even parity. If 1000 bytes of data is…
A: We are authorized to answer one question at a time. Since you have not mentioned which question you…
Q: 2- Draw the logical diagram of a 2 line to 4 line decoder using NOR 1- Draw the circuit for 3 to 8…
A: Demultiplexer is many to one logic circuit. It is also known as distributor or serial to parallel…
Q: 1- BCD equivalent of 0101 ? 2- Using Laws of algebra, ?̅ + ?̅ ?̅ = ?
A: Since you have asked multiple questions in a single request, we will be answering only the 1st…
Q: 1. a) Explain parity method for error detection for 8-bit data transmission using necessary circuit.
A: When a message or signal is forwarded, it may be resolved by noise or data is corrupted. To avoid…
Q: 6. Calculate the check bits (find the codeword) for the bit-pattern (100101011), using Hamming code…
A:
Q: 18)What is the bit pattern in the Destination for this XOR operation? A)11101011 B)10100010…
A:
Q: If the 7-bit Hamming code word received by a receiver is 1011011. Assuming even parity, state…
A: If the 7-bit Hamming code word received by a receiver is 1011011. Assuming even parity,state whether…
Q: Complete the blank In the standard POS expression, the binary words are formed by representing each…
A: Non complemented variable 0 for POS
Q: 4. Draw 3-bit synchronous counter and write its truth table?
A: We need to design 3 bit synchronous counter . We will Design the 3 bit up counter by using of T flip…
Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders with enable. Use block diagrams.
A:
Q: Q.3 If the 7-bit Hamming code word received by a receiver is 1001011. Assuming even parity, state…
A:
Q: Construct the following Boolean expressions using PROM device and show the size of PROM required.…
A: According to our rules , we will solve only the first three parts . If you want solution for the…
Q: Write the vhdl code for 4-bit parallel- parallel-out register using d flip flop
A: Parallel - in Parallel - out Shift Register(PIPO); Parallel - in parallel - out shift register(PIPO)…
Q: What are the minimum required gates (example: how many of what kind: like 5 of 2 inputs OR gates,…
A: DECODER: A decoder is a combinational circuit that converts binary code into decimal output. A…
Q: Assume a three-story hospital is built at Expo Center Karachi, and you are hired to design the logic…
A: The state diagram for the required counter is given by:
Q: 1 the minimum signal to noise ratio (SNR) to receive the symbols bability of bit error 106 or less?…
A:
Q: Given the boolean expression (X+Y). (X+Z) = X.Z+X.Y Which common functional unit (i.e. standard…
A: In the given questions, one terms is missing in right hand part. We need to find that one.
Q: Draw 3-bit synchronous counter and write its truth table?
A:
Q: What is the decimal number equivalent of the largest binary number that can be obtained with 9 bits?…
A:
Q: Scenario: In a biased N-bit binary number system with bias B, positive and negative numbers are…
A:
Q: A series of catchers that capture with serial information coming in the form of '1011' ; A) Design…
A:
Q: What is the vhdl code for 4 bit shift register using d flip flop using logic gates(and ,or,...)?
A: Solution: Here is my vhdl code: LIBRARY ieee ; USE ieee.std_logic_1164.all; USE…
Q: Q3) A bit word 1010 is transmitted. Construct the even parity 7-bit hamming code for this data? If…
A: hamming code is a error correcting code. it can detect an error and correct it. 1. even parity for…
Q: Q4. Suppose we receive a bit sequence: 00000 00100 11110 10000, and suppose a repetition code with 5…
A: In the received bit sequence a repetition code with 5 total bits and 1 data bit is used that implies…
Q: Design don't-care conditions. (HDL-şee Problem 4.42.) an excess-3-to-binary decoder using the unused…
A: Solution - To design an excess-3 to binary decoder, assuming the excess-3 code inputs are WXYZ and…
Q: What byte value, when written to the INTCON SFR, will enable global interrupts AND the RBO external…
A: Timer 0 is a 8bit counter that consist of all devices with 8 bit, and it is only a timer. the timer…
Q: A call processor in exchange requires 240 ms to compute the call (call processing time). What is…
A: We are authorized to answer one question at a time, since you have not mentioned which one you are…
Q: What do you call this circuit? is this a carry propagation? Are those inverters or not? By…
A:
Q: 4. FIGURE 1 shows how a 3 to 8 line decoder (TTL 74138) can be used in conjunction with NAND gate…
A:
Q: An 8-bit displacement will not be sign extended to 16 bit displacement before adding to the base…
A: The above question is related to the subject of 8086 microprocessor The 8086 is a 16 bit…
Q: Q (A, B, C) = A̅ .B̅. C + A̅ .B. C + A .B. C̅ + A.B.C Using the Karnaugh mapping method, the…
A:
Q: vhdl code for 4bit shift register using d flip flop and or gates
A: library ieee; use ieee.std_logic_1164.all; entity D_FF is port(D,CP: in std_logic; Q, Qbar: buffer…
Q: Electronics Q What is the difference between a task and a function in verilog? What is the…
A: Verilog is Hardware Description language . The memory and array declaration in Verilog is static in…
Q: (b)How many 3-to-8 line decoders with an enable input are needed to construct a 6-to-64 line decoder…
A:
Q: What are basic forms of boolean expression?Realise X-OR operator using a)only NAND gates b)only NOR…
A:
Q: What do you understand by static data member and static member function?
A: Static data member: When a data member is declared as static, only one copy of the data is…
Q: (200)10 + (60)10=(?)2 numbers are 8 bits, and the addition process is done by using 7 and 8…
A: The detailed answer is solved below according to the given parameters and instructions in the…
Step by step
Solved in 2 steps
- : Choose the correct answer for the following (n. 1. .. . instructions is not valid. a. MOV DS, 3000H b. РOP СХ c. DAA 2. When the word is to be popped from the top of the stack, the value of stack pointer is... a. incremented by 1 b. incremented by 2 c. decremented by 2 3. A microprocessor has .. . Data Bus a. unidirectional b. bi-directional c. Both 4. A microprocessor requires... power supply. a. +10V b. +7V c. +5V 5. . . instruction is not conditional jump instruction a. JA b. JMP c. JE(B)- Choose the correct answer for the following questions (Choose FIVE Only) 1. Assume AL register 7FH, it would become. after executed NEG AL instruction. b. 18H 2. The unknown value for ????:B000H=25000H physical address is ... a. 8FH c. 81H a. 001A H с. 100АH b. 1A00H 3. A microprocessor has address bus a. unidirectional b. bi-directional с. Both 4. Instruction queue allows up to . . of instruction code to be pre-fetched. a. 16 bits b. 6 bytes c. 6 bits 5. To activate the address bus or data bus in AD,-AD15 signal the .. should be either logic 1 or 0. a. MN /MX b. RD c. ALE 6. According to Moor's Law... a. number of transistors on b. number of transistors on c. number of transistors on an integrated circuit an integrated circuit tripled an integrated circuit not doubles every two years every two years change.6. Given the number 0XA0BOCODOE0F0, a. How many bytes for this number b. How many bits for this number c. Store in 8-bit computer with little endian system, and the starting address is 0x123, please show thedata memory map d. Store in 8-bit computer with big endian system, and the starting address is 0x123, please show the data memory map
- A memory location has a logical address where the segment address is 2019h and the offset address is the 0084h. Find the physical address of the memory location. please help me with those questions, those are from – Microprocessor and Interfacing, Electrical and electronics engineering.Give the equivalent value of the phrase IS IMPORTANT in decimal and binary number system so that the computer can understand. NOTE: The equivalent value of A in Decimal (Base 10) is 65 and Space is equivalent to 32.QUESTION 3 a) One of Medium Scale Integrated (MSI) circuit application is to compare between two input binary quantities and generates outputs to indicate which one has the greater, equal, or lower magnitude. Design the circuit to compare between two 2-bit inputs, you may choose only one output. Justify your design. b) Design an encoder to perform number conversion between two different numbering systems.
- Design the interfacing circuit shown below and write a program to display single digit (between 0 and 9) prime numbers followed by even numbers, the next odd numbers and repeats in 7-segment displays and its equivalent 8-bit binary value in LEDS. a) When displaying Prime numbers, the first 7-segment display must show "P" and the second 7-segment display must show prime numbers one by one b) When displaying Even numbers, the first 7-segment display must show "E" and the second 7-segment display must show even numbers one by one c) When displaying Odd numbers, the first 7-segment display must show "O" and the second 7-segment display must show even numbers one by oneA set of five readings is stored in maemory location starting at C060H. Devlop assembly language program (ALP) for 8085 microprocessor to sort the reading in descending order. draw the flow chart for the same.Solve these three MCQs. No need to explain the MCQs. Reference book Barry B Brey 8th edition. 1) During the DMA bus cycle the system bus is driven by the DMA controller, not by the MPUSingle choice. a) No b) Yes 2) There are _______ banks of data memory in 16F877.Single choice. a) 3 b) 4 c) 6 d) 2 3)There are total of ___________ instructions in PIC 16F877.Single choice. a) 39 b) 31 c) 43 d) 35
- a) 13–9 b) –13 –13 Perform the above decimal arithmetic problems by first converting the numbers to binary, 2’s complement form (using a 7 bit word in every case). Then perform the 2’s compliment addition. Show the result in binary indicating as in the problem above whether each result is positive or negative or overflowed (by writing “positive”, “negative” or “overflow” next to the binary answer) and then follow with the decimal value of the result if there was no overflow.1. Floating Point Numbersa. Show the difference between IEEE 16, 32, 64, 128-bit floating-point numbers.b. Express the following numbers in hexadecimal IEEE 32-bit floating-pointformat. i. 320ii. -622. Design a circuit that implements function p below using AND, OR, and NOT gates.DO NOT change the form of the equation. ?(?0, ?1, ?2, ) = {?2(?0?1 + ?̅0?̅1)}. (?̅2 + ?̅1)4. Show how the unsigned serial multiplication method would compute M × Q where M = 10110and Q = 01101. M and Q are unsigned numbers. For each step, describe in words what is happening (shift left, shift right, add/subtract M or Q into product, set a bit, etc.), and showthe product (or partial product) for that step. (Note: Q is the multiplier and M is themultiplicand.)3 Consider the combinational circuit shown below. The propagation delay for each unit is indicated in ns. Assume all other delays are zero. 8 ns C(x,y) X 10 ns 10 ns y - 7 ns 5 ns 5 ns a) What is the latency and throughput of the circuit as shown? b) Indicate where storage registers should be placed to create a two-stage pipeline with maximum throughput. c) What is the latency and throughput of the two-stage pipeline in part b? d) What is the best throughput that can be obtained by pipelining? How many stages would this pipeline have?