1-a Sub-cooling of the liquid can takes place either inside or outside the condenser, discuss in detail the statement by the aid of P-h diagram. Whether large sub-cooling is desirable?

Q: A flat plate is cooled with a fluid with a Prandtl number very small (Pr << 1). Plate surface…

A:

Q: We experimentally investigated the dependence of cooling rates of ductile cast iron during the phase…

A: Rule to determine whether there is a statistically significant linear relationship that exists or…

Q: Show that h,dx h 2hx=L 3DL dx 0,

A: When a fluid flows over a cod or heated surface (plate), temperature field is set up in the region…

Q: explain the relation between thermal diffusivity and thermal conductivity. And why do we have two…

A: Thermal conductivity is defined as the ability of a material to conduct heat. It is the heat…

Q: m, n + 1 Ay (2Tm-\ + Tmn+1 + Tmp-1) + 2h Ax T. – 2 т, п + 2) Tmn= 0 k m - 1, n m, n-1 Case 3. Node…

A: The figure for the node present at the plane surface of a solid with convection is given as:

Q: An ice cube is transferred from the refrigerator into boiling water at atmospheric temperature. What…

A: Introduction A quasi-static process is a thermodynamic process that happens slowly enough for the…

Q: Derive an expression for the heat exchange between two black bodies

A: Consider two black radiating bodies of area A1 and A2 . Heat exchange between two elementary areas…

Q: Problem 1: Find the equilibrium temperature attained by a porous surface soaked in Benzene. Assume…

A: Given :The pressure The temperature The emissivity of the porous surface Latent heat of…

Q: Steady-state temperatures at selected nodal points of the symmetrical section of a flow channel are…

A: Given, The convection coefficient, hi= 500 W/m2.K ho= 250 W/m2.K

Q: 1. _Give the Dimensional Analysis to explain the three cadres of the Mass Transfer and their…

A: Dimensional analysis in mass transfer  Mass transfer stands for the net movement of mass from one…

Q: 63. Consider two blocks of nickel, treated as semi-infinite solids. Initially, one block is at 0 C…

A: Given : Thermal diffusivity of nickel Initial temperature of left block Initial temperature of right…

Q: дт The Joule-Thomason coefficient of a gas is given by = 3.17- atm K др )н The gas was initially at…

A: The temperature of the gas is to be determined after it passed through the throttle.

Q: 3. The kinematic viscosity of helium at 15 °C and standard atmospheric pressure (101 kPa) is…

A: Given: The inital temperautre of helium is To = 15oC = 288 K, The final temperautre of helium is T =…

Q: 12. Plunging heated metal to water for annealing is an example of

A: For Annealing process ,plunging heated metal to water

Q: What is the physical significance of irreversibilities in heat engines? Please explain very well.

A: Basically, a heat engine is a device that which is converts heat into the work whereas It takes heat…

Q: Calculate the change in molar entropy of the system associated with transforming a supercooled water…

A: Given that the temperature of supercooled water(T)=-10oC…

Q: Fig. Q2 is a 2-D projection diagram from the 3-D phase diagram of a substance. B C A D E Fig. Q2-2-D…

A: As per the guidelines we can solve the first three subparts. for last part please repost it as a…

Q: Explain in your own words the phase change process at latm condition for 1kg of ice at -30°C to 1kg…

A: A phase change is the physical transformation of a material from one state to another. The phrase is…

Q: The thermal conductivity of a gas is larger than that of a liquid. O no O yes

A: Thermal conductivity:

Q: How many phases are at point: A B X

A: The graphical representation of phases is phase diagram. A phase diagram gives the transition…

Q: Convert the following temperature. a. T=-40⁰F to ˚R, K, ˚C b. ∆T=-40⁰F to ˚R, K, ˚C

A:

Q: In a desert chemical plant, the operator wishes to store chilled water underground in a spherical…

A:

Q: Carnot efficiency of a heat engine between the temperature limits of TH (Higher temperature) and TL(…

A: Carnot engine is a thermodynamic cycle that gives the maximum possible efficiency of a heat engine…

Q: Find and reference a semi-empirical correlation for convective heat transferfrom the literature.…

A: The objective of the question is to find a semi-empirical correlation for convective heat transfer,…

Q: If a beaker of water is placed in a bell jar, and the water is maintained at constant temperature…

A: Introduction A bell jar is a glass jar, similar in shape to a bell , often used in laboratories to…

Q: Gases inside a cylinder are ignited causing a reaction with a heat loss of 1000 joules. The…

A: Heat loss to the surrounding, dQ=-1000joules (heat transfer to the system possitive, heat transfer…

Q: 2. Atmospheric pressure water boils in a stainless steel kettle with Tx = 8C. Estimated heat flux…

A: The water boiling heat transfer coefficient is calculated by empirical relations. These are given by…

Q: Q 3) A) What is the physical significance of the two constants that appear in the van der Waals…

A: Since you have posted multiple independent questions in the same request, we will solve the first…

Q: A 8.7 kg of lead initially at 210∘C is dropped into an insulated basin containing 21.9 kg of water…

A: Given Information: Mass of lead dropped in the water basin, mL = 8.7 kgInitial temperature of the…

Q: For heat transfer, We have thermal diffusivity and thermal conductivity. But For mass transfer, We…

A: Thermal conductivity is defined as the ability of a material to conduct heat. It is the heat…

Q: A spherical tank of outer diameter Do = 1.5 m fabricated with t= 9.5 mm thick aluminum (kal = %3D…

A: Given that, Outer diameter Do = 1.5 m Outer radius ro = Do2 = 1.52 = 0.75 m Thickness t = 9.5 mm =…

Q: Point d is a two phase region Vapor b liquid solid gas P.

A: A phase diagram basically tells that what phase is possible or what phase transition has happened…

Q: 1- Both heat and mass do not exchange between the system and its surrounding in system.

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: Q1// A steel cylinder at 80 °F of length 12" is placed in a liquid nitrogen bath (-315 °F). If…

A:

Q: 3. The region inside the inversion curve has and the region outside the inversion curve has…

A: joule thompson coefficient =(∂T∂P)H=μj   joule thompson coefficient(μj) is just the slope in T and P…

Q: The expansion of a hypothetical closed system takes place at a constant pressure with no change in…

A: We know that, Enthalpy: (H) is the sum of the internal energy(U) and the product of pressure(P) and…

Q: Convert a thermal conductivity of BTU 0.03- to s. K.m °hr. °F.ft Given: 0.03- BTU hr.F.ft Required:…

A: ⇒1 btu=1055.056 J⇒1 hr=3600 sec⇒∆°F=∆K⇒1 ft=0.305 m⇒thermal conductivity, K=𝓠.∆xA.∆T

Q: The system is considered to be what when there is a transfer of mass and heat? a. a system that is…

A:

Q: Choose the correct option: 6. To which concept does the following definition belong? "Energy that is…

A: Asked; Energy is transferred from hotter object to colder one, which defination justify above…

Q: Explain with a sentence in the framework of a strategy why a correction factor is used in…

A: The concept of correction factor (CT) is for the case of multiple pass shell and tube heat exchanger…

Q: What is the role of high temperature and pressure in the making of petroleum? a. For decreasing the…

A: Explanation If we are providing high temperature and pressure, it creates a good suitable condition…

Q: Heat transfer takes place as per - O Zeroth law of Thermodynamics

A: