2Your friend is planning to ride his bike up a ramp and land on the roof of a building asshown below. The building is 6.00 m high and 8.00 m away from the ramp. The ramp is 3.00 mwide and 4.00 m tall.4.00 m1←3.00 m6.00 m8.00 mA. What is the minimum speed with which your friend needs to leave the ramp in order toland on the building?B. Another friend is going to use his motorized scooter for the same stunt. The maximumspeed of the scooter is 15.0 m/s. How close to the building should you move the ramp sothat your friend lands on the roof right at the front edge of the building?

Given-Distance of building from ramp Height of building from top surface of ramp Angle of projectile…

00 m 4 3.00 m 8.00 m 6.00 m A. What is the minimum speed with which your friend needs to leave the ra land on the building? B. Another friend is going to use his motorized scooter for the same stunt. T speed of the scooter is 15.0 m/s. How close to the building should you m that your friend lands on the roof right at the front edge of the building?

00 m 4 3.00 m 8.00 m 6.00 m A. What is the minimum speed with which your friend needs to leave the ra land on the building? B. Another friend is going to use his motorized scooter for the same stunt. T speed of the scooter is 15.0 m/s. How close to the building should you m that your friend lands on the roof right at the front edge of the building?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A string is wound around a pulley of diameter of 0.2 m. One of its ends is tied to the pulley and the other end to a weight hanging freely. The weight falls a distance of 4 m from the rest in 3 s. Determine the total distance through which the weight should fall so that the velocity of the pulley will be 400 rpm. OPTIONS: 1.Around 10 m 2.Around 15 m 3.Around 12 m 4.Around 6 m 5.Around 8 m 6.None
A jogger with mass m = 55 kg uses energy at a rate of P = 802 W when she jogs on horizontal ground at a constant speed of s = 3.5 m/s. The efficiency of her “human engine” however, is e = 0.27. (In other words, the power used for locomotion is e = 0.27 times the total power.) Q) Write an expression for the rate of energy expenditure whenshe jogs at the same constant speed up a slope of 4.99 degrees. Assume whatever frictional or drag forces are the same in each case. Your answer should be in terms of the symbols given in the problem statement and g(9.80 m/s^2)
1) We would like to design a wagon system as below when filling coal into the furnace at the Coke factory inside Kardemir. In this system, we want the wagon to reach a speed of v= 2 m/s in t=4 seconds. It will then shoot at constant speed. How much engine power is required to tow a wagon with W= 390 kgf under these conditions P=? (Losses will be ignored). (The slope angle of the ramp is α= 11 degrees.)
A drop hammer weighing 40 KN is dropped freely and drives a concrete pile 150 mm into the ground. The velocity of the drop hammer at impact is6m/sec. what is the average resistance of the soil in KN?
Qs: Two blocks are connected by a string. Block 1 is on a frictionless surface, while block 2 hangs freely. The string passes over a massless frictionless pulley. Find the acceleration of block 1, if the acceleration of block 2 is equal to 3.8m/s², and the tension in the string. 2.2 Kg 1.4 Kg
A block is pulled at constant speed along a rough level surface by a ropc that makes an angle of 30° with respect to the horizontal. The applied force along the rope is P . The force of kinetic friction between the block and the surface is 20 N. 30° Which one of the following expressions gives the magnitude of the force P in SI units? O 20(sin 30°) O 10(cos 30) O tan 30 O 20/(cos 30) O 30/(sin 30°) O O O O O
Khufra works at a spring factory and he was assigned to test a certain spring, whose constant is 50 N/m attached to a 50-kg block in an incline (©=30°). With the spring initially at equilibrium position, the block was pushed 0.3 meters up the incline by a 50-N external force applied parallel to the path. The coefficient of kinetic friction is 0.30. d) How much work is done by the block (in Joules) on the spring? e) How much work is done by the applied push on the block? f) How much work is done by friction?
Mechanical Engineering A turbine is running at rated power of 5 MW with the low speed shaft spinning at 12 RPM, with a wind speed of 10 m/s. The drive train has a polar moment of intertia of 50 million kg-m2. The wind suddenly increases in speed to 12 m/s for a 10 second period. What will be the speed of the rotor after that 10 second period, if no control changes are made to the turbine (i.e power delivered to the grid continues at 5MW, and no change in blade pitch angle, no change in Cp, etc.).
If friction is ignored, the time t (in seconds) required for a block to slide down an inclined plane (see the figure) is given by the formula t= 2a gsin@cos 8 where a is the length (in feet) of the base and g 32 feet per second per second is the acceleration due to gravity. How long does it take a block to slide down an inclined plane with base a 80 feet when 0-60? (Do not feet seconds feet per second Then round to two decimal places as needed.), MUS
You are called as an expert witness in a trial for a traffic violation. The facts are these: A driver slammed on his brakes and came to a stop with constant acceleration. Measurements of his tires and the skid marks on the pavement indicate that he locked his car’s wheels, the car traveled 192 ft before stopping, and the coefficient of kinetic friction between the road and his tires was 0.750. He was charged with speeding in a 45 mi>h zone but pleads innocent. What is your conclusion: guilty or innocent? How fast was he going when he hit his brakes?
A hollow steel ball weighing 4 pounds is suspended from a spring. This stretches the spring feet. The ball is started in motion from the equilibrium position with a downward velocity of 8 feet per second. The air resistance (in pounds) of the moving ball numerically equals 4 times its velocity (in feet per second) . Suppose that after t seconds the ball is y feet below its rest position. Find y in terms of t. (Note that the positive direction is down.) Take as the gravitational acceleration 32 feet per second per second. y =
The force exerted on a car by a prototype crash barrier crash is F=-(4400 + 50000S) N, where S in the distance in meters from the initial contract. Suppose that you want to design the barrier so it can stop a 2400kg car traveling at 100kph. Determine the average power transferred from the car during the impact if the duration of impact of the car is 0.33 sec.