0.8 m 3.58 As shown, a round viewing window of diameter D is situated in a large tank of seawater (S = 1.03). The top of the window is 1.2 m below the water surface, and the window is an- gled at 60° with respect to the horizontal. Find the hydrostatic force acting on the window and locate the corresponding CP.

0.8 m 3.58 As shown, a round viewing window of diameter D is situated in a large tank of seawater (S = 1.03). The top of the window is 1.2 m below the water surface, and the window is an- gled at 60° with respect to the horizontal. Find the hydrostatic force acting on the window and locate the corresponding CP.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

3.78 This dome (hemisphere) is located below the water surface as shown. Detemine the magnitude and sign of the force compo- nents needed to hold the dome in place and the line of action of the horizontal component of force. Here y, = 1 m and y2 = 2 m. Assume T = 10°C. Water Hemi- 2 spherical dome Atmospheric pressure PROBLEMS 3.78, 3.79
In the cage system below; It is under the effect of a P=250 kN load acting at an angle of θ=30° from the point C. Calculate the horizontal displacement (cm) to the right at point C. (E=2000 kN/cm² and A=50 cm² will be taken for all bars.)
Can you please solve these three questions?
SAMPLE PROBLEM 1. A square plate having a length of 3 m and width of 2 m is immersed in water. Determine the hydrostatic force in kN acting on the plate and the location of the center of pressure measured from the water surface if: a. The top of the plate coincides with the water surface. b. The top of the plate is located 5 m below the surface. c. If the plate is inclined at an angle of 30° with respect to the horizontal. a) Fin = 2m Pog: A %3D 1-5m h Yp Pg (981. Sm 1. Peg= 14.72 Kla %3D
A 1 m wide and 3 m long flat plate, held stationary, parallel to the flow direction of a uniform on coming stream of water velocity 3 m/s, leaves a velocity profile, at its trailing edge, varying linearly from zero at the plate to the free stream velocity of 3 m/s at 5 cm away from the plate. The water flow is only on one side of the plate. Assuming the pressure to be the same everywhere in the flowing water, the drag force on the plate will be: 2071
A vertical rectangular plane surface is submerged in water such that is top and bottom surface are 1.5 m and 6.0 m respectively below the free surface. The position of centre of pressure below the free surface will be at a distance of
80mm Q2/ 20mm 70mm IF : N.A I= 15.52 mm V=10 KN 160 mm |110mm Compute the shear at horizontal layer 20 mm apart from bottom to top depending on the calculation of the area up of the taken layer. 20mm
ASAP dont round off initial values pls, round off in final ans only tyy
A 1m x 2m inclined plate is submerged as shown. The normal force acting on the upper surface of the plate due to the water (when taking atmospheric pressure into account) is most nearly (A) 68kN (B) 91kN (C) 203kN (D) 294kN Answer is 294kN. Use paper sheet to solve with diagrams
Q- The staff reading taken on a workshop floor using a level is 0.645 m. The inverted staff reading taken to the bottom of a beam is 2.960 m. The reduced level of the floor is 40.500 m. Find the reduced level (expressed in m) of the bottom of the beam
11 A cylindrical caisson having an outside diameter of 9 m floats in sea water with its axis vertical and its lower end submerged 9 m, below the water surface. If its center of gravity is on the vertical axis and is 3.6 m above the bottom. a. Determine the value of ??? b. Find the true metacentric height. c. Find the righting couple when the caisson is tipped through an angle of 8°