.what is the total resistance ? 2. What is the current and volt

Q: A transformer supplies power to a feeder that has five customers. Daily maximum demands for these…

A: Given: Daily maximum demand of the consumers are 150 kW, 70 kW, 120 kW, 60 kW and 200 kW. Maximum…

Q: Determine the difference of the signals below, (both signals started at n = 0), x1(n)-x2(n). What is…

A:

Q: If the current i flowing in the straight conducting wire as shown in the figure decreases, find out…

A: Solution !! Solution From right hand rule, the magnetic field by the straight wire is directed into…

Q: 2. Determine lo using source transformation and resistance combination. 102 120V/ 2452 n 400 10 300…

A: We need to find out current by using of source transformation in the given circuit

Q: Shown below is the voltage waveform applied to a pure capacitor of 100 uF. Solve for the RMS value…

A:

Q: In the Internet of Things, which of the following is responsible for translating an electrical…

A: Internet of things Actual physical objects that include sensors, computing power, software, and…

Q: 4. The given system has NF- 8.74dB, has all impedances at 5002 and uses high side injection, a.…

A: According to the question, for the given system as shown below, We need to find, (a) Mixer…

Q: A system is used to transmit base3 PCM signal of 256 level steps, the input signal works in the…

A: Given number of levels L = 256 frequency of input signal ranges ⇒ ( 50 to 90 kHz) Formula to be used…

Q: 5 V 7. Find i, in the circuit in Fig. 3.46. ΤΑ www 4 A ww www 11.

A: The given circuit is,

Q: The armature of a 6 pole, 138 slots shunt generator is lap wound with four conductors per slot. The…

A:

Q: Feedback & Control Systems - State-Space Representation Write the state-space representation of the…

A: The set of all potential and recognized states for a system is known as state space. Each distinct…

Q: Simplify the following expression by applying one of the theorems. State the theorem used. (b) (AB'…

A: The given Boolean expression is, AB'+CDB'E+CD.

Q: For the op-amp shown in the following figure, if R1 = 100 2 and Rf = 1 k2, the overall voltage gain…

A: Given data, Circuit diagram is given as,

Q: From the following waveform, calculate the RMS value and the average value Choices for RMS value:…

A: In this question,  We need to choose the correct option We know, rms value of triangular waveform…

Q: Apply DeMorgan’s theorems to each expression:  [ A B’ ( C + D’ ) ]’ ( A + B’ + C + D’ )’ + ( A B C…

A: We need to simplify the given function by using of DeMorgan's theorem .

Q: load is connected to a 210 V, 50 Hz supply. If it has resistance of 300 and a capacitor of 0.25 mF,…

A: Given, V=210 V f=50 Hz R=30 Ohm C = 0.25 mF

Q: 1. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

A:

Q: If the current i flowing in the straight conducting wire as shown in the figure decreases, find out…

A: According to the right-hand rule, if we put our thumb in direction of the current then the magnetic…

Q: 3. A 10ohms resistor and an unknown inductance is connected in series. The series combination is…

A:

Q: 3. Minimize the following Boolean functions into sum-of-products form using a K-map (a) F(a, b,c,d)…

A:

Q: ID is a voltage controlled current source. I'm trying to find Vout.  I found: VG = 1.5V ID =…

A:

Q: In your own words, how does the Philippine Electrical Code contribute to the electrical designs,…

A: It is asked to describe the contribution of Philippine Electrical Code to the electrical designs,…

Q: In Boolean Logic, there are only two answers: True and False True False

A: Asking about Boolean logic output

Q: A rechargeable battery is capable of delivering 77 mA for about 13 hours. If the rechargeable…

A:

Q: Find the value of R₁ such that it consumes maximum power. 18 Ω Μ 5Ω Μ 18 Ω te Μ 18 Ω WW Μ 18 Ω 5Ω R₁

A: Solution !!   Concept:To transfer maximum power from the source to load the value of load resistance…

Q: A sensor interface circuit containing a light sensor (represented by the variable resistor Rx) is…

A: The input network is a voltage divider network and the input to the ADC can be calculated by using…

Q: Draw the expression below ¹(¹-2¹)-¹(²—³²) d. 211 1.5 +211 (t-3)

A:

Q: How many bits are approximately required in PCM for a SNqR of 72 dB? 16 08 12 24

A: We need to find select correct option for given problem.

Q: or a uise litude modulated (PAM) transmission of voice signal having maximum frequency equal to fm =…

A:

Q: Which of these can be installed without needing an electrical permit first? A. Hot tub B. Bank of…

A: Electrical permit:- Evidence that an electrical contractor was in charge of the electrical work can…

Q: If Es = 10 ej4x ay, which of these is not a correct representation of E?(a) Re(Esejωt )(b)…

A: It is given that: Es=10 ej4x ay

Q: The exchange of data between two devices via some form of transmission medium such as a wire cable…

A: We need to select correct option for given statement .

Q: 2.63. Consider a discrete-time system with input x[n] and output y[n]. When the input is 1-(1) ¹4…

A:

Q: Find the total external armature current of a dc machine which has the following specifications: 120…

A: Torque = 12π flux ×number of armature conductors ×number of poles number of parallel paths…

Q: 3. Determine the voltage across the 40-ohm resistor. 60V 250 M 4052 12.0 8n 18 18 18

A: We will find out the voltage across the given resistor by using of voltage division rule .

Q: 2. A switch with the following characteristics controls power to a 25-kW load as shown in Fig. P2.1.…

A: Since it is asked to solve questions (a) to (c) o we are solving these subparts only. The given…

Q: Yız (G₁ Z-4% 20MVA X, -15% X₂=18% X-3% If: T1: 11kV-138 kv T2: 11kV-138kV T3: 20 kV-138 kv G1: 11kV…

A:

Q: 3. A short shunt compound generator delivers 100 amperes at a terminal voltage of 200 V. Armature…

A:

Q: An analog signal is to be coded by an ADC. The signal contains significant frequencies up to 6MHz.…

A: We need to find out the number binary digits per sample for given quantization error for given ADC .

Q: Find the total external armature current of a dc machine which has the following specifications: 120…

A: Using torque equation of DC motor calculate armature current.  Torque of DC motor  =12π×∅×Z×Ia×PA.…

Q: Determine the Laplace transforms of (a) 2 cosh 3t (b) e−2t sin 3t

A: In this question We need to determine the Laplace transform of the given signals.  We know

Q: 4. Find the Total Resistance below. R₁ 15 Ω Γαλλί V₁: 100 V R₂ 30 Ω w R₂ 10 Ω = = A Μ B (a) R₁ 4 Ω R…

A:

Q: Question No.22 Skipped What is the resistance of a wire of length 100 m, uniform cross-section area…

A: Given, Wire length, l = 100 m. Uniform cross section area, A=0.01 mm2=0.01×10-6 m2. Resistivity,…

Q: 9 = B(-1-j2.829) (-1-j2.829 + 1-j2.829) 9 = B(-1-j2.829) (-j5.658) 9 = B(-16 + j0.1768) B =…

A: This is a basic problem of complex equation. The detailed explanation is given in the next step.

Q: 1. Determine the spectral components of the FM signal below. VFM 100 [sin (204.6mx106) t+…

A: According to the question, we need to analyze the equation of the FM signal.

Q: A series R−L circuit has a step input V applied to it. Use Laplace transforms to determine an…

A:

Q: нечел ь @ and ☺ - -(50+)зоп) + $(8.s[+sL)+E(\Lot[+os) + cz7.0cd. usni tog = 150 Z135

A: This is a basic problem of complex equation. The detailed solution is given in the next step.

Q: G₁ H₂₁ G₁ H₂ G₂

A:

Q: A transformer supplies power to a feeder that has five customers. Daily maximum demands for these…

A: Given:  Daily Maximum demands: 150kW, 70kW, 120kW, 60kW, 200kW   The maximum demand is150kW…

Q: 2. Find Ix.

A: It is given that:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.