. A Chann el of treap zoidal Section has bottom width of smand side slopes at 2 horizontal to I Vertical.The depth of Plow is l-som. Betermine the glope requiredto dis charge 36 m*/s. Take Manning's aN)=0·028.A Channel of trapzoida section, with sides gloping atLPS°, Conveys water to ea depth of o-75 m. Find thewidth of the base and the Channel gradient to discherge1-2m3/s with a mean relocity of o8mls.take the Chezy Constent as 66m'Scanned with CamScanner

Answered: Image /qna-images/answer/f54b2ba9-5bcb-41b7-a039-123446188686.jpg

. A Chann el of trapzoidal Section has bottom width of 5m and side slopes at 2 horizontal to I Vertical. The depth ef Plow is l-5om. Betermine the slope required to dis charge 36 m%/s. Take Manning's N) =0 028.

. A Chann el of trapzoidal Section has bottom width of 5m and side slopes at 2 horizontal to I Vertical. The depth ef Plow is l-5om. Betermine the slope required to dis charge 36 m%/s. Take Manning's N) =0 028.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: SOLVE ALL EXTERNAT SUPPORT REACTIONS FOR THE BEAMS

A: Reactions at the supports of the frame Ra , Rd , Hd

Q: A steel rod with length equal to 7.5 ft, has a diameter of 0.78 inches in quarter of its length and ...

Q: What

A: Volume of soil ,V = 29cm3 weight of soil = 48 g dry weight = 42g Gs = 2.6 percentage of air in void...

Q: a. Determine the hydrostatic force acting on the gate. b. At what distance from the centroid of the...

Q: Question 1 The given data shows a sieve analysis of a soil sample. Classify the soil using AASHTO Me...

Q: What is the location of the Maximum moment from A in meters. Given: w1 = 44, %3D w2 = 12, a = 3, b =...

A: Given a simply supported beam with udl as shown below w1 = 44 w2 = 12 a=3 b=2 c=3 The location of t...

Q: bar of a certain material has 50 mm x 50 mm cross-section. When it is subjected to an axial pull of ...

Q: Express the answers in the nearest three decimal numbers. NOTE: Refer to MM = 08 and DD = 26

A: The bulk specific gravity of the soil is defined as the ratio of the unit weight of the bulk soil to...

Q: What is the location of the Maximum moment from A in meters. Given: w = 17, a = 2, b = 6, and c = 2....

Q: 100 kg 200kg/m A. C - 3m. 6m Rq. R,

Q: The footing supports the load transmitted by the two columns. The reaction of soil pressure on the f...

Q: A5 m-thick clay (Gs = 2.65, water content = 0.28) is overlain by a 4.50m-thick layer of sand (Gs = 2...

Q: What is the location of the Maximum moment from A in meters. Given: w = 12, a 2, b = 5, and c 2. w k...

Q: Draw the moment diagram for girder PQRST and column BGLQ of

Q: A falling head permeability test was run on a soil sample 12.5 cm. in diameter and 11.7 cm. long. Th...

Q: A simply supported one way reinforced concrete slab has a thickness of 175 mm. It is reinforced with...

A: Solution: SS beam t-175mm Dia - 16 mm

Q: If the resultant of the forces shown passes through point A, determine the magnitude of the unknown ...

A: For the given braked pulley,

Q: The following data shows the difference in elevation between A and B. Difference in No. of Trial Ele...

Q: A simply supported one way reinforced concrete slab has a thickness of 175 mm. It is reinforced with...

Q: For a given sandy soil, the maximum and minimum dry unit weights are 16.63 kN/m3, and 14.37 kN/m3, r...

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of understandin...

Q: nestion 34 A consolidated-undrained tri-axial test was conducted on a normally consolidated clay sam...

Q: Determine the maximum deflection

Q: Gate AB in figure below is a homogenous mass of 180 kg, 1.2 meter wide into the paper, resting on sm...

A: For what water depth h in meters will the force at point B be zero?

Q: What is the location of the Maximum moment from A in meters. Given: w = 19, a 1, b = 6, and c = 1. w...

Q: Question 44 The given data shows a sieve analysis of a soii sanple. Classity the sodi using AASHTO e...

Q: A flanged bolt coupling consists of 9-16-mm-diameter steel bolts on a bolt circle 500 mm in diameter...

Q: The rigid bar AB, attached to two vertical rods as shown is horizontal before the load P=50kN is app...

A: Determine the deformation of aluminum Determine the deformation of steel Determine the vertical mov...

Q: Mention two types of soil survey and state the advantages and disadvantages of each

A: Aerial photo interpretation is a two-step process that begins with (1) obtaining information from th...

Q: A square hollow steel strut with a wall thickness, t_{1} = 10 mm is pin connected to two gusset plat...

A: Given data:t1=10 mmt1=12mmDiametr of pin=16 mm P=48 KNθ=30°

Q: A simply supported one way reinforced concrete slab has a thickness of 175 mm. It is reinforced with...

Q: The data shown below are the results of a liquid limit test done on a soil. Moisture Content (%) Co...

A: The liquid limit of the soil is defined as the boundary water content, at which the soil changes fro...

Q: d formation pressures of 12, ottom temperature is 17 °C.

A: Solution to keep a diminished tension in part of circuit

Q: GIVEN: W= 215N/m a = 5m El is constant A. Draw the shear and moment diagram. B. Determine the slope ...

Q: A rigid bar ABC is supported by three identical wires A, B, and C as shown in the figure. The bar AB...

A: Determine the tension in wire B

Q: What is the porosity of a soil having a void ratio of 1.326? Round off to two decimal places.

A: Minerals, organic matter, water, and air are the four fundamental components of soil. The average so...

Q: A homogeneous bar AB is supported at either end by a cable as shown in the figure. Calculate the lar...

Q: Question 38 Yiren was given a soil sample which yields the following passing percentage for differen...

Q: he Bunsen burner in your labs are fueled by natural gas, which is mostly methane, CH4. The thermoche...

A: Given, chemical reaction, CH4(g) + 2 O2(g) ➔ CO2(g) + 2 H2O (g) ΔH = –...

Q: The given data shows a sieve analysis of a soil sample. Classify the soil using AASHTO Method. Table...

A: AASHTO soil classification system is also called as HRB or Highway Research Board soil classificatio...

Q: stion 17 Dry Sand H, Groundwater Table Clay H, Refer to the soil profile shown. Given H1 = 8.93 m., ...

A: Given H1 = 8.93 m H2 = 5.32 m G1 = 2.56 G2 = 2.72 e1 = 0.65 e2 = 0.87 To Determine Difference in eff...

Q: The common tangent AB of a compound curve is 76.42 m with azimuth of 268°30! The vertex V being inac...

Q: Question 42 The following are results from the liquid and plastic limit test for a soil. 1. Determin...

A: GIVEN Cone penetration test data for liquid limit. Moist unit weight and dry unit weight for plastic...

Q: A 12-kN sphere is attached to a 4-kN sphere by a cable. Both sphere have the same diameter of 1.2 m ...

Q: Small packages traveling on the conveyor belt fall off into a 1-m-long loading car. If the conveyor ...

A: The origin is shown with x & y axis in the figure

Q: PROBLEM 1: A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 12 inch...

A: As per guidelines of bartleby, experts are allowed to solve only first three subparts. Please post...

Q: 6 m 5 m 4 m B hc = 2m Ayi D 600 N 450 N

Q: The elements of a reverse curve are as follows: I1 = 18.7˚ I2 = 24.3˚ D1 = 2.4˚ D2 = 4.5˚ I...

Q: Determine the moment of inertia (in4) of the transformed section. M=250 k-ft and n=9. Area for each ...

Q: Given below is the result of a sieve analysis done on a soil sample. Sieve No. Diameter Percent...

A: GIVEN Seive no. Sieve diameter, Percentage Passing through each seive size. To Determine Coefficient...

Q: For a falling head permeability test, the following values are given: Length of specimen = 38.5 cm, ...

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

. A Chann el of treap zoidal Section has bottom width of sm
and side slopes at 2 horizontal to I Vertical.
The depth of Plow is l-som. Betermine the glope required
to dis charge 36 m*/s. Take Manning's aN)=0·028.
A Channel of trapzoida section, with sides gloping at
LPS°, Conveys water to ea depth of o-75 m. Find the
width of the base and the Channel gradient to discherge
1-2m3/s with a mean relocity of o8mls.
take the Chezy Constent as 66m'
Scanned with CamScanner

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

the Frictionless prame below with at Poi nt A and Determine following unfor m a) The internal Point A at in terms of w 6.) The teter nal reac tion at Point D in of C in terms of Internal ve at d.)External at Point runt v! ¢ -0.6m HE
SHOW SOlution Ans. F= 733.16kN 1.844m from the bottom of the tank parallel to the gate
Q/shows a hycreaulic structur thut was built on opm channel . The residunl head at point f calculated by using Lon's theory is equal to 1.25m. Thi suk o + and G2.5. bydraulic gradient is equal to : 50 Lon's VIs WIL h, = 125 - +4, G.2.5 12465 15m 12m 15m
2. Analyah below, Suffort B Support D setth = 2mm the bem Settes E h00 Gpa 80 kN 20 kN/m A.
Probl A submerged rectangular gate holds back water. Gate is 2 m. wide. Compute force (F=?) to open the gate? 2 m-wide gate Water Hinge РА 3 m 4 m D [1 m 3 2 m-wide gate Hinge Wate Pave P y Fep 3 have y Yep 1 4
5. Determine dp and 0p. Let q = 15 kN/m and L = 6m. B L L L 3 3 3
A beam is shown in the figure below, and the flexural stiffness of the beam section is constant El: (a) Use the Moment-area Method to find the Slope after point A is deformed.
Tank filles with water as shown in fig. fing the hevi Zental and vertical hydrostatic Force on the Part CD, BC . AB. use The informution :- Cylinder radiug R= 0,5m %3D Reading of 5=1S KPa The hidh CH) = 3.5 m %3D The width of the ey linder = ym G Tank Full of Water Width = b H R
SOLUTION. Wo = 6.16 kN/m L = 5.17m EI y = ? A 7/2 LLLLLLLL Wo 4 4₂
10 kN Calculate Moment abou -0.6 m - -0.6 m- 1. Point A 2. Point B A 277 15 KN 60 0.8 m 60° 0.4 m B
Quiz Q: A quarter circie gate AB of 2m radius and 1 m wide, hinge at B, find the horizontal force F exerted on A WATER SURFACE 3 m AE F R=2 m hinge B.
oblique surfoce Aprismaie bor is'under tenstan, 24N 24N bar has a sief (3cm X 4CM) in width ond depth repectively. 30° Determine the normal stress on the given ablique sur fore.