In this week’s reflection assignment the required viewing material was a video that addressed the topic of hand swaging bullets.
The video gave an overview of the projectiles themselves and also showed the method in which they are to be loaded.
The video began by stating that the projectiles were sent to him to be tested and he did not swage the swaged projectiles that are being shown in the video. The projectiles were unique in the fact that the person that swaged them used a die that would allow the used brass from a .40 S&W to be formed into a jacket for a .451 caliber projectile that are to used to load .45 ACP. The video states that it will give the user a greater amount of versatility when using the projectile as opposed to using a cast bullet. There were two different types of projectiles to be tested in the video. The first being a standard lead core projectile and the second projectile has a .30 caliber gas check in the nose of the cartridge. These swaged bullets were very comparable to factory ammunition in terms of diameter and weight.
…show more content…
The video states that his main purpose for showing to loading method is to determine whether or not the loading of these projectiles will differ from loading normal commercial projectiles. In the video the barrel of the pistol being used to test fire the loaded round was removed to be used as a length gauge in the reloading process. To use the barrel to check the length the loaded bullet will need to be placed in the chamber to ensure that it will seat fully and also that is will fall free of the chamber. The reloading press being used in the video was a Lee classic reloading press. Even while loading these swaged projectiles the reloader chose to keep the amount of powder the same as if he were loading factory
The fact that it covered the proper approach for maintaining the feeding source is amazing to see. With all the general guidelines out there, I feel this one is almost always overlooked. If you’re firearm(s) is well kept and properly lubricated, why take a shortcut on doing preventative maintenance on those magazines? After all, it consequences could be as innocent as a simple failure to feed, but on the opposite side of the spectrum, this type of negligence could cost the user there life in a combative scenario. The two videos offered some valuable information, so at this point i’m going to
The video starts with some cool, Ted Nugent sounding rock and roll (I'm a fan), TiborasaurusRex is shown seated at a reloading press. He is going to give a demonstration on how to properly adjust the bullet seating, and crimping die. He takes the die out of the device, and shows what exactly it is. He states that a bullet's proportional seating is based on where the nut/screw is located on the end. The lock ring will make your crimp, based off of how far it is placed in the press. He shows a quick out of the die example on the physics to crimping a bullet. Whenever I hear crimp, I can't help but think of the blank ammunition we would train with in the Army. A bullet with cannelures (grooves outside the bullet) you want to place a crimp to ensure the projectile is secured during it's employment.
Rifles with Minié bullets were easy and quick to load, but soldiers still had to pause and reload after each shot. This was inefficient and dangerous. By 1863, however, there was another option: so-called repeating rifles, or weapons that could fire more than one bullet before needing a reload. The most famous of these guns, the Spencer carbine, could fire seven shots in 30 seconds.
Another side arm that was popular among the Union forces was the Starr Revolver. The .44 caliber six shot weighed almost three pounds and could be shot multiple ways. The Starr could use a combustible cartridge or could be fired by use of loose gun powder and ball. The government threatened the company (Starr) by saying they were going to move to a cheaper model of sidearm if the weapons price did not reside. Starr complied and began manufacturing the weapon for twelve dollars; the Union forces purchased 25,000 of these revolvers.
One main theme present in the work "The Scarlet Lette" is that of sin and guilt. Nathaniel Hawthorne attempts to show how guilt can be a form of everlasting punishment. The book represents sin and guilt through symbolism and character development. In his novel, "The Scarlet Letter", Nathaniel Hawthorne explains how the punishment of guilt causes the most suffering among those affected.
The Book "Fist Stick Knife Gun" by Geoffrey Canada is a biographical account of his childhood in the south Bronx. He and his 4 brothers were raised by only their mother. She would survive on no more than ten dollars a week. He moved several times as a child until finally landing on union avenue, the place were many of his life lessons were learned and at times applied. He learned about the ranking process of kids on union Ave. and how the only way to improve your status was to use your fists to fight your way up the chain. Looking back Geoffrey Canada notices the major shift in attitudes concerning the rules of the streets. What once was
Although, the Glock is famous, it still needs the proper ammunition. As indicated in Campbell’s article, I also experienced the difference between poor and quality ammunition as well as reloaded. The quality impacts an officer’s confidence and shooting record. Although the situation was saved due to quality ammunition, hand-loads aren’t incompatible. Certain rules need to be adhered to in order to; function properly, save money, have specific tolerances to avoid overpressure and avoid blow ups.
The solid ball was typically used against forts and other artillery pieces. The grape shot and canister shot were utilized as anti-personnel munitions. The Garrison Cannon used three different types of shells; hot shot, chain shot and bar shot. Hot shots were cannonballs that were heated until they were glowing red and then fired at ships to set them ablaze. Chain shot and bar shot consisted of two cannon balls connected by either a chain or bar. They were designed to destroy ships rigging. The mortar used only one type of shell, the bomb. The bomb was a hollow shell that was filled with black powder and had a fuse. The howitzer utilized hollow shot and anti-personnel munitions.
A firearm is one of the weapons that may be used when hunting. A firearm utilizes pressure produced from the burning of gunpowder to create gas. The pressure produced from the burning powder propels a projectile out of the barrel at a target. In rifles and most handguns the barrel has rifling on the inside of the barrel to make the projectile spin to travel better in the air. Rifling are groove that spin as they go through the inside of the barrel. Shotgun barrels are smooth and can fire “slugs”, a single projectile, or “shot”,
When the constitution was written the most advanced gun only shot one bolt at a time, and took 30 seconds to reload (Murphy). Now in the 21th century guns have “high-capacity magazines were used in at least 50% of the 62 mass shootings between 1982 and 2012. When high-capacity magazines were used in mass shootings, the death rate rose 63% and the injury rate rose 156%. David H. Chipman...stated that a high-capacity magazine ‘turns a killer into a killing machine.’ Some gang members use high-capacity magazines, such as 30 rounds or even 90 rounds, to compensate for lack of accuracy and maximize the chance to harm” (“Background of the Issue - Gun
In addition to advancements in smaller firearms, the US military also saw improvements in the sector of long range rifles. Muzzle loading muskets from the Revolutionary War were highly inefficient and and extremely dangerous to use. When on the battlefield, trying to load a muzzle loading musket became very complicated. If the soldier loaded a bullet but it got jammed, and they tried to fire, the musket would explode in their face, causing many unnecessary injuries to the soldier force (National Park Service, “Evolution of the Breechloader”). With the invention of the breech loader, loading a rifle became exceedingly simple. In a breech loading rifle, the soldier loads a cartridge containing the bullet and the gunpowder into a chamber. They would then proceed to fire the weapon. This method of loading a weapon was
There are three types of artillery used by the Continental Army, which consisted of cannons, mortars, and howitzers. The two main types of cannons are the field gun that was lightweight and mobile, while the heavy siege gun is larger and has limited mobility. The field gun fired a variety of rounds such as solid shot, grapeshot, and canister shot that has a flat trajectory. This would tear large holes in the opposing forces ranks, destroying personnel, and equipment. Solid shot was simply a solid cast-iron cannonball that had the least effective range unless it was rolling or bouncing. Grape shot was most commonly used for long range target with a kill zone of 600 yards. Grape shot was generally constructed out of a canvas bag, with lead or iron balls half the size of musket balls that has a wooden base, and center rod to help the artillery men handle the rounds. Canister shot is a thin metal cylinder filled with a massive amount
Muzzleloaders are the weapons that Davy Crockett and Daniel Boone carried afield with them during their bear hunts, Indian fights, and battles. Today there are two basic types of muzzleloaders used for hunting—primitive and in-line. Both are based upon the premise that the shooter pours powder down the end of the gun barrel, and then rams a slug or ball down on top of it to load the gun.
When choosing someone to interview who was working in the career that I wanted to have in 10-15 years, I immediately thought of a veterinarian. Not any veterinarian, though a small-town veterinarian who operates their own practice and is well known in their community. That’s why I chose Veterinarian Dr. Phillip C. Hubbard owner of the Countryside Animal Hospital in Montevallo, Alabama. Dr. Hubbard first opened his practice in 1980 with only have been out of school for one year. He obtained an undergraduate degree in journalism from Washington Lee University in 1970.
Matched the wrong TTH prescription which leading to dispensing to the different patient. Medications prescribed for patient A was dispensed to patient B. Confirmed patient B’s name and date of birth according to the prescription copy that patient B dropped at the pharmacy but dispense the medications according to the patient A’s TTH without realising it is a wrong match.