X(+) = 5+6 Cosanxio +-8 Cos2nxit. find the followly. X(f). 2 Sketch the amplitude Specta 3 9 Pau, Bw. P2 Sketch the power spectul dany spart.
Q: The potential divider circuit shown in Figure 1 consists of two resistors: R1 and R2. Vin R1 R2 Vo
A: 4. a. Given circuit is shown below. i) Apply KVL in the loop Vin=IR1+R2I=VinR1+R2 The Vo is…
Q: A 3-phase Wye-Delta Connected source to load system has the following particulars: Load impedance…
A: The concept used here is that the line voltage and phase voltage for delta connected load is always…
Q: Design a 3-bit priority encoder. D7 is the highest priority. Include truth table and equation.
A: Design a 3-bit priority encoder : D7= highest priority(MSB) Priority encoder is a modified version…
Q: A 15mH inductor is in series with a parallel combination of an 80ohms resistor 20uF capacitor. If…
A:
Q: Q1/A 460 V, 74.6 kW, 50-Hz, 4-pole, 3-p Induction motor runs at a slip of 5%. Find :-(1) Synchronous…
A:
Q: capacitor is charged with 0.23 watt-sec of energy at a voltage of 48 volts. What is the capacitance?
A:
Q: 12V 30 Ω R3 5 Ω R8 + α ΑΜΕ Μ 15 Ω R₁ Μ 30 Ω R6 AMG 8 Ω R 18 V 20 Ω R4 + C 8V W 25 Ω R₂ M 50 Ω R₂ ΑΓ…
A:
Q: J 2) 3) of the Sketch the circuit of each fallowing component parts of describe. the functions ar…
A: Note: We are authorized to answer one question at a time since you have not mentioned which question…
Q: 11. The impedance on the Smith chart can be repeated for each half wavelength length of the…
A: From the Question The impedance on the Smith chart can be repeated for each half wavelength length…
Q: Problem 29: Write the analytical expressions of the waveforms shown below: AU (MV) Ai (mA) f=2 kHz 0…
A: We need to write equation for given waveform
Q: Problem 9: For the network shown below, find: a) The total admittance YT b) The source current I,…
A:
Q: Refer to Figure below. If gm = 4000 uS and a signal of 75 mV rms is applied to the gate, calcu the…
A:
Q: 3. The impedance which is constant at any point on the transmission line is * ZL. Zo. None of them…
A: We need to select correct option for given line .
Q: Q: Find the value of the starting capacitance for a 250 W, 120V, 60 Hz motor that is necessary to…
A: A motor which uses a capacitor to starting operation is mostly cage motor. The auxiliary and main…
Q: Sketch the root locus for the unity feedback system shownin Figure P8.3 forthe followingtransfer…
A: TRANSFER FUNCTION : A system, sub-system, or component's transfer function (also known as system…
Q: A linear dynamic system is governed by the following Laplace transformed equation. (3s + 5)X(s) = =…
A: This question is related to control systems
Q: Given: IE (dc)= 1.2mA, B =120 and r= 40 k ohms. In common-emitter hybrid equivalent model, convert…
A: In this question we will find common base hybrid parameter h ib with the help of common emitter…
Q: A circuit have following components and values: 6 of a bipolar transistor ranges from 12 to 75 Load…
A: For a bipolar transistor,β=12-75Rc=1.5 ΩRB=0.7 ΩVCC=40 VVB=6 VVCEsat=1.2 VVBEsat=1.6 V
Q: A 3-phase Wye-Delta Connected source to load system has the following particulars: Load impedance…
A:
Q: B с A D Z
A: Logic circuit: This circuit is created by connecting the different gates as our requirements. The…
Q: Suppose the spatial multiparticle wavefunction for 5 identical fermions Y(T1, T2, T3, T4, T5) is…
A: Given,For a single particle,The wavefunction in the state is given by,ψir→jHere,i ∈a, b, c, d, eandj…
Q: r Nodal Analysis.
A: For mesh analysis equations- Summation of voltage drops in a closed loop is always zero. For nodal…
Q: Determine the value of the current i for the circuit shown below. 200 Ω 150 Ω 40 V 500 Ω 600 Ω
A:
Q: figure the S-parameters for an ideal transformer with turn ratio N = N1:N2 where N1 is the no. of…
A: S- parameters is a scattering parameter it describe the linear behaviour of electrical network .…
Q: A10 microfarad capacitor has 250 milliamperes of current flowing through it. How much voltage at 60…
A:
Q: V₁ If A(s) = 2000 (1+₂50)(1+ S 10000 A(s) solve the following: Vo
A:
Q: Find i and Req ab if Vab = 40 V in the circuit shown bel b 6 ww 3 2 Rega-b 12 W 20
A:
Q: using The Venin's Theorem, find resistor in figure. The current in [6] below ил, 55 MA 4.5 65
A: We need to find out current for given circuit by using of thevenin equivalent circuit
Q: Let w=800rad/s in the circuit. Find the input impedance,Zin 2 μF @O www 300 (2 ho 600 2 0.6 H
A:
Q: The transfer function of discrete time system is given by: H[2] = -2²+0.82-0.8 z²-1.19 a) Sketch…
A: Transfer function is mathematical function which give theoretical model of output for each possible…
Q: 1. Calculate the input and output power for the circuit. The input signal results in a base current…
A: Transistor: A transistor is a device that functions as an electrical signal switch or gate that…
Q: 2. The sequence component of phase a current are: Zero sequence current = = Positive sequence…
A: Types of sequence current in unbalanced system Zero sequence current ( finite value ) Negative…
Q: Briefly explain what you mean by discrete system and by continuous system.
A: Consider the objective is to determine the discrete system and the continuous system.
Q: A total current of 10A flows through parallel combination of three impedance: (2 - j5), (6+j3) and…
A: We are authorized to answer only one question at time since you have not mentioned which question…
Q: ww 10Ω +25/-30° V- 25 Ω 20 mH
A:
Q: Problem 12: For the network show below, find: a) The total impedance Z b) The value of C in…
A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…
Q: A 2MVA, 2.3kV 3 Y-connected alternator operates at rated kVA at a power factor of 80%. The DC…
A:
Q: Function of BJT DC Analysis? What is it important?
A: DC analysis of BJT : DC analysis of BJT is done for determining the value dc values of the…
Q: Q1/ By using thevenins theorem for the circuit shown in Figure below, to find the current in the 3…
A:
Q: analyze the difference and the significance specially in the voltage of the radial and loop…
A: Types of power transmission system Radial system Loop system Network system
Q: The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH…
A: Given: Series RLC circuit with,R=8ΩL=32mHC=800μFe=120sin125t
Q: Q2: A distributor (d.c ring distributor) of ABCDA is fed from point A with 250 v and has a…
A:
Q: (b) Figure 2 shows a rectangular magnetic core with relative permeability of the core is 4000. The…
A: The given information about the magnetic circuit is, Number of turns is N=500. Cross sectional area…
Q: 4. The propagation constant consists of two terms. the first term is the attenuation constant, and…
A: We need to find out attenuation constant for lossless transmission line
Q: Give the minimal expression for the output f in the following circuit: 0 1 1 2 1 3 0 f 4 5 6 7 S2 X…
A:
Q: Determine the value of the current i for the circuit shown below www www 200 £2 150 £2 40 V (+ 500…
A: In this question we will find unknown current value i in given figure...
Q: Given the circuit below, find the values of the following: a. Ic b. Rc Vcc = 3V c. RB Re 1B= 20 μA…
A: In this question we will find unknown currents and resistances....
Q: Find I in the circuit shown in the figure below using superposition.
A:
Q: What is the impedance of an AC series circuit with a resistance and reactances for which R = 300…
A: given an AC series circuit with R = 300 ohms , C=11microF, L=0.200H and f = 500/pi Hz. so here the…
Q: 3) It It Jui Jun R₂ R₂ RV Vo Ru is used to vary the gain. Show that So is given by: Vo = 2 R₂…
A:
Step by step
Solved in 2 steps with 1 images
- C1 L1 R1 V1 Vout V1 contains the fundamental and its harmonics (fo, 2fo, 3fo, ...). The amplitude of the harmonics is inversely proportional to the harmonic number. V(fo) = 10 mV V(2fo) = 10mv/2 = 5 mV V(3fo) = 10mv/3 = 3.33 mV V(4fo) = 10mv/4 = 2.55 mV a) What is the minimum value of Q for the circuit that will attenuate the third harmonic (3fo) in Vout to be less than 1% of the fundamental? b) What is the amplitude of the fifth harmonic (5fo) as a percentage of the fundamental?Any non-sinusoidal wave can be represented by a . . with harmonic frequencies. * ... of sine waves ..... ..... O non-of-them O add O difference sumA certain impedance is given by 1012° N. Does the current lead or lag the voltage, and by how many degrees? Fill in the blanks. The current the voltage by
- Problem: In electronics device laboratory, you need to use the function generator to use different types of signals e.g., sinusoidal wave, square waves, sawtooth waves and so on. Imagine you are planning to make an approximate square wave generator from a sinusoidal wave having peak voltage of [three digits before last digit of your ID] mV to use the produced square wave to study the clamper circuit. You can consider any frequency. You need to avoid using any dc power supply to save the energy. Also consider the amplitude of the produced square wave must be greater than the PIV of the diode. 1. Identify which circuit is necessary for making the generator. Illustrate input-output signals with appropriate labeling. 2. Lift the produced square wave above the x axis by the amount of [your last digit of your ID] V explaining appropriate steps. + Sinusoidal PIV2-A resultant current is made of two components: a 10 A D.C. component and a sinusoidal component of maximum value 14.14. The average value of the resultant current is amperes (a) 0 (b) 24.14 (c) 10 (d) 4.14 and r.m.s. value is - amperes (e) 10 (f) 14.14 (g) 24.14 (h) 100-Consider the following DT sequence, Is this signal as Power Signal or Energy signal? Determine it. * 0Snくs X [n ]= lo-n 55.n510 • ther wise Power Signal, P=85 Energy Signal, E=85 O Neither energy nor Power O Both, P=30 E=55 -Is the following signal is X(4) - Sin 3t + Sin 大t Periodic AperiodicUsing MATLAB, plot a sine wave of angular frequency of 50 rad/s and having an amplitude of 10. Plot exactly 10 cycles of the wave. I am beginner is MATLAB. No need to explain the code. Provide me with the output graph.A sinusoidal signal is applied to a system. The output is a clipped sinsusoid ( at 90 % of its peak from top). Find the THD in the output signal and show that it is approximately equal to 0.122 %In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 16 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is doubled? Select one: O 16 Vrms 32 Vrms O 8 Vrms . 8 Vrms ..... O 5.657 Vrms 5.657 Vrms ....... O 8 Vrms . 16 Vrms O 16 Vrms 8 Vrms ......can you please give me the comple solution for this question, thanks. A certain voltage function contains a constant term, a fundamental and third harmonic. The maximum value of the fundamental is 85 % of the constant term and the maximum value of the third harmonic is 55 % of the constant term. If the effective value of this function is 180.3V, find the magnitude of the two harmonics. A.IstHarmonic = 75 V , 3rd Harmonic = 120V B. Ist Harmonic = 80 V , 3rd Harmonic = 125V C. IstHarmonic = 120 , 3rd Harmonic = 75V D. Ist Harmonic = 125 V , 3rd Harmonic = 80V E. NOTAIn an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 10 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is reduced to the half value? 3.536 Vrms . 3.536 Vrms O 5 Vrms . 1.7677 Vrms O 3.536 Vrms. 1.7677 Vrms O 5 Vrms . 5 Vrms ...... O 10 Vrms . 10 Vrms ......A step up chopper is used to feed a load at 400 V dc from a 250 V dc source. The inductor current is continuous. If the off time of switch is 20 microsec, the switching frequency of the chopper in kHz is ?SEE MORE QUESTIONS