What is the load resistance value RL across a and b for maximum power transfer to the load in the circuit shown in this figure: R₁ 12 V 12 ΚΩ R₂ 36 ΚΩΣ RL = 6.3 KQ RL = 6.9 KQ RL = 6 KQ RL = 6.6 KQ R3 12 ΚΩ R4 9 ΚΩ « RL

Q: Problem 3: For what emf & does the 200 S2 resistor in Fig.3 dis- sipate no power? Should the emf be…

A:

Q: -2 x[n] -1 y(1) + t

A:

Q: Unsimplified Boolean expression and truth table pls

A:

Q: 3) Given H(s) = 5 s (s+2)(s+1) and u(t)= t²3(t) and y(0) = 1 and y'(0) = 1, find y(t).

A:

Q: Question No.17 If the OC test data on delta side of a three phase Y-A transformer is 66 kV, 11 A, 45…

A: Given: The open circuit test data on the delta side of a three-phase Y-∆transformer, Line voltage,…

Q: Find the steady-state error for input of 2u(t) to the system below. The function u(t) is the unit…

A: Steady state error = s→0 LTSRs1+GsHs. Where R(s) is the input and G(s) is the transfer function .

Q: ex) X(t) = 3 Cos (100 Ft) أتي مباشرة اوهل I find the minimum Sampling rate required to cubie…

A:

Q: Identify the 3rd order transfer function ?(?) of the op amp from the Bode plot of the open-loop…

A:

Q: Find the current io in the circuit below by making a succession of appropriate source…

A: A

Q: H.W 1. a. Determine the thermal voltage for a diode at a temperature of 20°C. b. For the same diode…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: VIN ww R₁ R₂ m -Vcc + VBE Vcc Rc - VOUT RE -Vcc VCE,sat = 0.2 V VBE,Q = 0.7 V B = 75 Vcc = 9 V Rc =…

A:

Q: In a three-phase inductive motor circuit, I want the name of each element and the symbol in this…

A:

Q: 19. Apply Thevenin's theorem to find Va ЗА Μ 4 Ω 16 Ω 5Ω 1Ω www 12 V 10 Ω

A:

Q: Determine vo using superposition theorem. зл M +1 Vo = 22 ↑) 4A 50 W + lov

A: The given circuit is:

Q: The antenna used for AM receivers is the Blank 1 antenna. The highest possible dynamic range in…

A: .                              SOLUTION  ANSWER  Ferrite Rod Antenna  EXPLANATION  Generally…

Q: _etwork in Figure. ww 6 ΚΩ 12V Use the differential equation approach to determine io(t) for t> 0 in…

A:

Q: Question 1 v(1) R-2502 L = 20 mH C-50 µF Compute for the phase angle of the phasor current i(t) if…

A: We need to find out phase angle for current .

Q: Compute and plot the convolution y[n] = x[n] * h[n], where: -n (²) u[ − n − 1] x[n] = h[n] = u[n −…

A:

Q: Problem 3: For what emf & does the 2002 resistor in Fig.3 dis- sipate no power? Should the emf be…

A: The given question can be analysed by using the kirchhoff's law and mesh analysis. The power…

Q: P5.1 What is the minimum sampling frequency needed to sample the following signals to prevent…

A: In this question 5.1 part b.,  We need to determine the sampling frequency.  We know,  Sampling…

Q: Which polynomial related to a pair of poles would yield a 2% settling time of approximately 0.5…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: 1. What is the S/N at the output of an amplifier whose NF = 10 dB and the input S/N = 25 dB? 2. A…

A: We need to find out the signal to noise at output for given noise figure .we need to find out loss…

Q: Complete the timing diagram for the given circuit. Assume that both gates have a propagation delay…

A: Complete the timing diagram for the given circuit : Propagation delay of each gate tpd=5 sec

Q: 2. Which polynomial related to a pair of poles would yield a percent overshoot c less and a 2%…

A:

Q: 240-volt self-excited shunt DC motor has field resistance Rf=200ohms and armature resistances…

A:

Q: Example. A power station is to supply three consumers. The daily demand of three consumers are given…

A: Given,

Q: 4-The following sequence represent one period of a sinusoidal sequence of x[n] = Acos(w。n + p).…

A:

Q: Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If…

A:

Q: Use the mesh-current method to solve for v in the circuit below. Give your answer in Volts (V).…

A: The processes used to compute the current flowing through a planar circuit. A planar circuit is…

Q: 14 Find the Fo. To of the following Signals using 2 2 2 +t Ans differentiation prop. F(w) = 4(…

A: The answer provided by you is not correct. Here, I am providing original solution i e using…

Q: A signal g(t) is produced by switching on a continuous-time signal v(t) for a limited time -0.5T ≤ t…

A:

Q: 1) Figure below shown the schematic diagram of 3-phase radial transmission system. The ratings and…

A:

Q: x [n] = cou[ + n) + √²₁ ( # ") sin

A: We need to find out exponential Fourier series coefficient of given sequence .

Q: why capacitance voltages dividers are not preferred for high d.c. voltage measurments ??

A: Capacitor: The term "capacitor" refers to a device without a unit. The ratio of the charge held in…

Q: H.W 1. a. Determine the thermal voltage for a diode at a temperature of 20°C. b. For the same diode…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: A and the unregulated dc input varies from 24 V to 33V. The Zener voltage is 9.3 V which required at…

A: Given circuit,

Q: Find the transfer function, G(s) = Vo(s)/Vi(s) of the operational amplifier below. v(t) 4μF 600 ΚΩ…

A: We  need to find out the transfer function for given amplifier circuit.

Q: 4. Find the per unit value for each component and draw the impedance diagram. Y Generator 10 kV 100…

A:

Q: Find the magnitude of F = 2xyz a x – 5 (x + y + z) a z in cylindrical coordinates at P ( p= 2, Ø =…

A: It is given that: F=2xyzax-5x+y+zazP=r=2,ϕ=60°,z=3

Q: Draw the timing diagram for V and Z for the circuit. Assume that the AND gate has a delay of 10 ns…

A:

Q: what is ripple ? how to minimize the rippl , draw the circuit and show ??

A: It is one of the important parameter which is taken into consideration while designing any power…

Q: (a) Use the mesh-current method to find vo in the circuit shown below. (b) Find the power delivered…

A: Solution:

Q: Use adders, multipliers, integrators, and delay units to draw the block-diagrams of: 1 dy(t) 2 dt 1)…

A:

Q: 4. Determine the total impedance. ZT 202 M 452 WIE -j62 M 3.12 m j42

A:

Q: A 600 meters copper wire is to be used for a three loads that dissipates 1600W, 795W, 1560W power…

A: Dissipation of power is the process through which heat is produced by electric or electronic…

Q: OBTAIN THE TRUTH TABLE OF THE FUNCTIONS REQUIRED TO ACTIVATE THE COMMON ANODE 7- SEGMENT DISPLAY,…

A:

Q: Problem 2: A lightbulb is in series with an R = 2.0 2 resistor. The lightbulb dissipates P = 10 W…

A: The electric potential variations around a loop add up to zero, according to Kirchhoff's loop rule.…

Q: Given: 10 = 6 amperes, V1 - 7 volts, and V2 = 93 volts. Find the value of Vy (in volts). 5V, 1Ω Ig…

A: Given, The circuit diagram will be,

Q: • Find out currents through all the resistors and voltages all resistors Using mash analysis Vp=12v…

A:

Q: The armature of a d.c. The machine has a resistance of 0.25 ohm and is connected to a 300V supply.…

A: Resistance (R) = 0.25 Ω Voltage (V) = 300 V Ia = 100 (When it runs as a generator) Ia = 100 (When it…