7)This MCQ QUESTION FROM BASIC POWER ELECTRICAL ENGINEERING course.just write for me the the correct answer. The 3-phase power and line-to-line voltage ratings of the electric power system shown in the followingfigure are as follows:Generator G160 kVA22 KVX= 9%Z= 2 + j5 2X= 10%X= 8%Line22 KVTransformer T200 kVA22/0.5 KVMotor M40 kVA0.4 KVLineOn a 100-kVA base power and 22 kV base voltage at the generator side,The impedance of the transformer in per-unit is equal to:O a. 0.05 puO b. 0.5 puOc.0.56 puO d. 0.144 puO e. 0.2 puO f.0.056 puO g. None of these answers is correct

Answered: Image /qna-images/answer/21956fb5-6c77-4f23-b65d-5b22bfb7a8b5.jpg

The 3-phase power and line-to-line voltage ratings of the electric power system shown in the following figure are as follows: Generator G 160 kVA 22 кV X-9% Z= 2 + j5 2 Line 22 KV Transformer T Motor M 200 kVA 40 kVA 22/0.5 KV X= 10% 0.4 KV X= 8% Va Line On a 100-kVA base power and 22 kV base voltage at the generator side, The impedance of the transformer in per-unit is equal to: O a. 0.05 pu O b. 0.5 pu O c. 0.56 pu O d. 0.144 pu O e. 0.2 pu Of. 0.056 pu O g. None of these answers is correct

The 3-phase power and line-to-line voltage ratings of the electric power system shown in the following figure are as follows: Generator G 160 kVA 22 кV X-9% Z= 2 + j5 2 Line 22 KV Transformer T Motor M 200 kVA 40 kVA 22/0.5 KV X= 10% 0.4 KV X= 8% Va Line On a 100-kVA base power and 22 kV base voltage at the generator side, The impedance of the transformer in per-unit is equal to: O a. 0.05 pu O b. 0.5 pu O c. 0.56 pu O d. 0.144 pu O e. 0.2 pu Of. 0.056 pu O g. None of these answers is correct

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base Voltage is 600 V and Base Power is O 6000 VA O 2000 VA O 4000 VA 8000 VA
The actual impedance of a load is 10 OHM. The new per-unit impedance of the load is 0.5 pu when Base Voltage is 200 V and Base Power is O 4000 VA O 8000 VA O 6000 VA O 2000 VA
The actual impedance of a load is 10 OHM. The new per-unit impedance of the load is 0.5 pu when Base Voltage is 200 V and Base Power Is O 4000 VA CO 8000 VA O 6000 VÀ O 2000 VA
ings of a 40 kVA, 6 m respectively. The le- ate (i) the primary vol ced (ii) the full-load re
15) Kirchhoff's Voltage Law (KVL) states that A) the product of the phasor voltages around any closed path must equal zero. B) the sum of the phasor voltages around any closed path does not have to equal zero. C) the sum of the phasor voltages around any closed path must equal zero. D) the sum of the phasor voltages around a closed path cannot include "through the air."
Determine the short-circuit current ISC3,0.4kV for a 3-phase short- circuit fault at F. Give your answer up to 2 decimal in kA but do not enter the unit in your answer. Transformer T1 Transformer T2 Cable C1 Isc3,6.6kV Isc3.0.4kV O + j0.150 F 1 MVA 2 MVA 22/6.6kV 25 MVA fault level 6.6 kV/400V Z=3% 6.6 kV switchboard 400 V switchboard
A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
Does an open- operation, the kVA rating compared to that of the original thr-phase bank is (a) 2/3 (b) 58 (c) 1
Three single-phase transformers, each rated 10MVA,66.4/12.5kV,60Hz, with an equivalent series reactance of 0.1 per unit divided equally between primary and secondary, are connected in a three-phase bank. The high-voltage windings are V-connected and their terminals are directly connected to a 115-kV three-phase bus. The secondary terminals are all shorted together. Find the currents entering the high-voltage terminals and leaving the low-voltage terminals if the low-voltage windings are (a) Y-connected and (b) - connected.
Determine the positive- and negative-sequence phase shifts for the three- phase transformers shown in Figure 3.36.
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......