Suppose you have a three-phase generator that provides 120 Vac per phase and works at afrequency of 60 Hz, this generator can be connected in both delta and star. Also consider thefollowing 6 load impedances, which will be connected at the same time to the generator asfollows: ZA, ZB and Zc are connected in star, while Zp, Zg and Zp are connected in delta.j20j3nZaj20ZAj30j3n-j20j 30-j20Zo-j20ZEj30-j2nj 3n.ZFAssume the generator is star-connected with neutral, calculate total system power, totalpower factor, and current in neutral.

Here in this solution the concept power & power factor for the delta & star connected 3…

Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA. ZB and Ze are connected in star, while ZD. ZE and Z are connected in delta. 10 -j20 j30 Z₂ -j20 j30 j3n mn ZA Zc N ww Z₁ 10 10 -j20 H -j20 ww 10 j3Q Zo -j20 10 j30 -j20: j30 Z Assume the generator is star-connected with neutral, calculate total system power, total power factor, and current in neutral. ww m

Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA. ZB and Ze are connected in star, while ZD. ZE and Z are connected in delta. 10 -j20 j30 Z₂ -j20 j30 j3n mn ZA Zc N ww Z₁ 10 10 -j20 H -j20 ww 10 j3Q Zo -j20 10 j30 -j20: j30 Z Assume the generator is star-connected with neutral, calculate total system power, total power factor, and current in neutral. ww m

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.41P

See similar textbooks

Similar questions

two generators supplying a load. Generator I has a no-load frequency of 62.5 Hz and a slope Sp1 of I MW/Hz. Generator 2 has a no-load frequency of 62.0 Hz and a slope sp2 of I MW/Hz. The two generators are supplying a real load totaling 2.5 MW at 0.8 PF lagging. (a) At what frequency is this system operating, and how much power is supplied by each of the two generators? (b) Suppose an additional I-MW load were attached to this power system. What would the new system frequency be, and how much power would Gl and G2 supply now? Generator 1 VT V2 Generator 2 VTí KVAR KVAR
The reactance of a generator is given as 0.25 per-unit based on the generator’s of 18 kV, 500 MVA. Find its per-unit reactance on a base of 20 kV, 100 MVA. a. 0.0505 b. 0.0605 c. 0.0405 d. 0.0606
two synchronous generators are connected in parallel, feeding a load together. the frequency of the first generator in the no-load State is 52 Hz and the slope of the characteristic is 1 MW/Hz. the total power of the load fed by these two generators is 2.5 MW and the power coefficient is 0.6 inductive. by drawing the characteristic curve of the system;a) what is the frequency of the system when the load in question is fed, and how do the two generators share the load between themselvesb) if a load of 0.5 MW is added to the system, find the operating frequency of the new system and the powers given by each generatorc) if a second load of 0.5 MW is connected to the system, the idle operating frequency of the second generator is increased by 0.5 Hz, what happens to the operating frequency of the system and the power values given by the generators
Draw a complete equivalent circuit of one phase only of a synchronous generator. Then draw the phasor diagram for a unity power factor. Assume the phase resistance is ignored
Two three-generator are parallel at 6.6 kV and delivering 3000 kW at 0.8 pf. The impedance for machine A is 0.5+j10 ohm and for B 0.4+j12 ohm. The excitation of A is adjusted to deliver 150 A at lagging pf. Determine the induced emf of machine A.
Q2) A 13.2-kV single-phase generator supplies power to a load through a transmission line. The load's impedance is Ztoad 500 236.87° ohm , and the transmission line's impedance is Zine = 60 253.1° ohm. To reduce transmission line losses to 0.0103 of its losses without using the transformers design and use two transformers T1 between the generator and the transmission line and T2 between the transmission line and the load.
3 X 0.1 1 2 XL = 0.2 to Eato oto O X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. (2 Marks) b) Find the bus voltages and line currents during the fault. (2 Marks)
If the load draws a current of 2727 A, in phase, from a generator, which of the following statement is true? O A. The reactive power is flowing from generator to the load and the real power is flowing from the load to the generator. O B. Since the current is in phase with the generator voltage, both the real and reactive power is flowing from the generator to the load. O .Since the current is leading the generator, both the real and reactive power is flowing from the load to the generator. O D. The real power is flowing from generator to the load and the reactive power is flowing from the load to the generator. O E. None of the other choices are correct
Qa1. The three phases of a generator can be connected in either delia (D) or wye (Y) connection. List two advantages of three phase system over a single phase system. Also write mathematical relationship between the phase voltage and the ine voltage, and the phase current and the line current for both delia (D) and wye (Y) connections. Please answer in typing format please..
What are the conditions in paralleling of these DC Generators:a. Shuntb. Seriesc. Compound
The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......
6.5% ans ex A so kvA. 2o00/20 V, So He single-phase transformar has impedance drof of8% and resistance drop of 4%. Caleulate. The Requlation of the Thams former at full- Load o8 P.s Legging. also find The Power factor at which Voltage requlation will Be Zero. Sols 0.5 leading. s alculate The % Noltege Requlation af atransformar in w hich the Percantage resistance drof is 1% and Percentage dre is 6% when The Power fador is 0.8 lagging ) > unity aMS 38 % ans 1 % (シ→ 0.8 leading . amS - 2.2%