Please help me make these two circuits on TinkerCAD. Not understanding how to do it

Q: For the circuit attached, calculate the current I by finding the equivalent resistance.

A: It is given that:

Q: 3. The role of mixer in the Armstrong modulator is to. a) raise the carrier frequency b) lower the…

A: Since you have posted the questions with multiple subpart and so we are supposed to answer 3…

Q: 8.3. Find a set of state equations for each of the systems described by the following differ- ential…

A: Since you have posted a question with multiple subparts we will provide the solution only to the…

Q: motor A 3-Phax 4 pole, Sota, 11 kv, SG supply a 3-phase, 11kV, 1500rpm S.M. if the syn. reactance is…

A: Given that a synchronous generator is driving a synchronous motor and given values of the system is…

Q: A source voltage is given by the equation é connected to a 10 Q2 resistor, the rms value of current…

A: Voltage equation is, e=277sin314t V. Resistance R=10 Ω.

Q: Step input of 3 units was applied to a system and the response of this system is shown in Figure…

A: In this question we need to find the transfer function of the given system.

Q: Referring to the given circuit, what is ZTH (when RL is open) if R₁ is changed to 220 ohms? VS 0 Hz…

A: Circuit diagram is given as,

Q: 20. It is desired that the impedance Zr of the high-Q circuit of Fig. 20.59 be 50 kn 20° at…

A: ZT of the high Q circuit = 50 kΩ at resonance ( fp).   Need to calculate the a. Find the value of…

Q: Refer to the circuit below, Which of the following is true about the voltage across R₁? RGI Ra 800…

A: Apply kvl in the circuit.

Q: A series circuit with L = 0.12 H, C = 0.48 mF and R = 25 2 is connected to a 220 V variable…

A: We need to find out frequency at which current through given circuit is maximum.

Q: Which statement best describes creating a circle? A. A place slices a double-napped cone parallel…

A: Given Statements: A plane slices a double-napped cone parallel to the side (generator). A plane…

Q: 1- The type of Frequency Modulation that its bandwidth similar to the bandwidth of DSB- AM signal is…

A: Answer: NBFM   The bandwidth of DSB-AM is 2Fm, Similarly, the bandwidth of the NBFM is also 2Fm The…

Q: 2. Find an expression for the frequency response, H(f), for each of the circuits shown below. Also…

A: In this problem we need to find the types of filter and transfer function H(f) Circuit:-

Q: Imaginary Axis 15 10 5 O 5 Nyquist Diagram

A:

Q: For the network below I=9A R₁ ww 10 Ω 마 units R₂80 Using superposition, find the voltage across, the…

A:

Q: Example: The circuit below was in steady state before the switch opened at t = 0. Find i(0), i(0*),…

A:

Q: 2. Two point charges 3 µC and 5 μC are located at (1, -2, 3) and (2, -4, -2), respectively. Find the…

A:

Q: Given the following RLC circuit, which form does the particular solution take when ex- pressing the…

A: The question is about parallel RLC circuit.

Q: A 230 V DC shunt machine has an armature resistance of 0.5 22. and a field resistance of 115 92.…

A: 230 V DC shunt machine- Armature resistance Ra=0.5 ohm, Field resistance Rf=115 ohm, Line current=50…

Q: What is the input resistance, Rin, in the circuit in Figure 4 when n=2 Rin 100 S2 n:1 Figur 4 4Ω

A: n=2

Q: q9-  Calculate the (approximate) data rate to bandwidth ratio (R/B)  if the energy per bit (E0) is…

A: Noise power per Hz; No=12 Energy per bit; Eo=13 Signal-to-noise ratio; SNR=10 dB To find out We have…

Q: For the circuit given below, the approximate value of reactance, impedance, current and power factor…

A: We need to find out the reactance,. Impedance, current and power factor for given circuit.

Q: *26. Design the network of Fig. 20.65 to have the following characteristics: a. BW= 500 Hz b. Qp =…

A: Given: a. BW =500 Hz b. Qp =30 c. . VCmax = 1.8V   Need to design the circuit by finding the values…

Q: 1. A 3-phase, 16 hp, 460V, 4-pole, Lottz, 1788 rpm induction motor delivers Full output power to a…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: For the continuous-time signals x(t) and v(t) shown in Figure 3, compute the convolution x(t)*v(t)…

A: In this question we need to find the convolution of signal x(t) and v(t) for all t>0

Q: A conventional amplitude modulator (AM), where m(t) is the analogue message, VDC is an offset…

A: Dear student, Since you have posted a question with multiple sub parts, we will provide the solution…

Q: Consider the circuit shown in (Figure 1). Suppose that R₁ = 40 ₁ R₂ = 80 N, R3 = 80 N, R₁ = 450 N.…

A:

Q: The figure shows a AC circuit having 3 sources with 2 different frequencies. Use superposition to…

A:

Q: of and 510 A 3-Phase 4 pole, Sota, 11 kv, S.G supply a 3-phase, 11KV, 1500rpm 10 for motor S.M. if…

A: Given that a synchronous generator is driving a synchronous motor and given values of the system is…

Q: FIGURE 7-74 6. Determine the output of a gated D latch for the inputs in Figure 7-75. FIGURE 7-75 EN

A:

Q: Find the steady-state expression for v if ig = 500 cos 2000t mA. a) Find the voltage that passes…

A: In this question,   We need to determine the voltage Vo and power factor.  We know Capacitive…

Q: να 5V R1 1 ΚΩ R5 300 Ω ww m R3 200 Q Μ R6 120 Ω

A: The question is from electrical circuits. The voltage is solved by using voltage division rule(vdr)

Q: The voltage across a 0.6 [F] capacitor is zero for all time less than zero, and then 40exp(-…

A: In this question we need to choose a correct option

Q: What is an integrated circuit and how is it used in electrical engineering?

A: An integrated circuit (IC) refers to a microchip or a micro electronic circuit or simply a…

Q: 2. An RLC circuit with L = 1 h of inductance, R = 2 of resistance, and C = 0.1 f of capacitance has…

A: As per the company guidelines the solution for first three subparts can be given please post rest…

Q: An FM modulator has a carrier frequency of 100 MHz, is frequency modulated by a sine wave signal at…

A: Since you have posted a question with multiple subparts we will provide the solution only to the…

Q: Determine the inductor current i(t) in the circuit shown in Figure.

A: Given: A network,  To find: Inductor current i(t).

Q: 2.16) A transmission line operating at 125 MHz has Z0 = 40 2, a = 0.01 (Np/m), and ß = 0.75 rad/m.…

A: In this question we need to find the value of line parameters R' , L' , G' & C'

Q: Q1) Get the transfer function of T12= in this system. (Note: you can use Mason's Rule) R2 R₁ + R₂ +…

A:

Q: A) Explain briefly the process of voltage control oscillator (VCO) for FM generation

A: Since you have posted the multiple questions so we are supposed to answer first one.

Q: For the system given in the figure on the right-hand side, where the input is four-unit step, r(t) =…

A:

Q: Using the Laplace transform, find the current i(t) in the circuit in the figure, assuming zero…

A:

Q: Could you please go more in depth about how to create the ac equivalant model? thank you

A: The AC equivalent model for the given JFET based amplifier circuit needs to be provided with…

Q: The magnetic moment for the circular loop with side a and current I is a. zero O b. ma2 | OC. 2π al…

A:

Q: Expand the logarithm. Simplify if possible. log_(7)xy

A:

Q: m(t) -m(t) Amplitude Modulator-1 Vc(t) Amplitude Modulator-1 Oscillator Sz(t) $₂(1) Sub. s (t) 1-…

A:

Q: IL 220230° Load P = 2 kW pf = 0.9 lag Assuming that the source is operating at 60 Hz, determine the…

A: e) The load resistance, f) The load inductance.

Q: Convert the following to an expression with cosine instead of sine. 100 sin(377t +150°) 100 sin(100t…

A:

Q: 2. A discrete-time filter is given as: Y[z] z+¹-z-1 H[z] X[z] 2 a. Write the difference equation…

A:

Q: 6- IF the modulation index of FM signal is 2, the number of significant sidebands which greater than…

A: Given, FM modulating signal is having Modulation index,β = 2. We need to find the number of…