Part A An electron is fired through a small hole in the positive plate of a parallel-plate capacitor at a speed of 1.2 x 10'm/s. The capacitor plates, What is the capacitor's charge? which are in a vacuum chamber, are 1.8-cm-diameter disks spaced 3.0 mm apart. The electron travels 1.5 mm before being turned back. Express your answer with the appropriate units. μΑ Q = Value Units Submit Request Answer

Part A An electron is fired through a small hole in the positive plate of a parallel-plate capacitor at a speed of 1.2 x 10'm/s. The capacitor plates, What is the capacitor's charge? which are in a vacuum chamber, are 1.8-cm-diameter disks spaced 3.0 mm apart. The electron travels 1.5 mm before being turned back. Express your answer with the appropriate units. μΑ Q = Value Units Submit Request Answer

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter7: Electric Potential

Section: Chapter Questions

Problem 79P: (a) Will the electric field strength between two parallel conducting plates exceed the breakdown...

See similar textbooks

Similar questions

(a) What is the final speed of an electron accelerated from rest through a voltage of 25.0 MV by a negatively charged Van de Graff terminal? (b) What is unreasonable about this result? (c) Which assumptions are responsible?
Two parallel conducting plates, each of cross-sectional area 400 cm2, are 2.0 cm apart and uncharged. If 1.01012 electrons are transferred from one plate to the other, (a) what is the potential difference between the plates? (b) What is the potential difference between the positive plate and a point 1.25 cm from it that is between the plates?
(a) Will the electric field strength between two parallel conducting plates exceed the breakdown strength of dry air, which is 3.00106 V/m, if the plates are separated by 2.00 mm and a potential difference of 5.010V is applied? (b) How close together can the plates be with this applied voltage?
A long cylinder of aluminum of radius R meters is charged so that it has a uniform charge per unit length on its surface of . (a) Find the electric field inside and outside the cylinder, (b) Find the electric potential inside and outside the cylinder, (c) Plot electric field and electric potential as a function of distance from the center of the rod.
Two parallel plates are charged with a battery. The battery has a voltage of 10 volts. O On the figure, draw in the direction of the electric field between the plates and indicated which plate have the higher voltage. If the electric field between the plates is 7.5 X106 V/m, what is the distance between the plates? At what distance from the negative plate is the voltage drop 8.0 volts? O A negatively charged pi meson, or pion, () is released from rest halfway between the plates. A pion has a mass of 2.49×10-28 kg and the same charge as an electron. What is the speed of the pion when it is at a potential of 8.0 volts? + + + π 1
Problem 2: Consider the parallel-plate capacitor shown in the figure. The plate separation is 5.9 mm and the the electric field inside is 24 N/C. An electron is positioned halfway between the plates and is given some initial velocity, v₁. Randomized Variables d = 5.9 mm E = 24 N/C + + + + + + + + d Otheexpertta.com Part (a) What speed, in meters per second, must the electron have in order to make it to the negatively charged plate? Part (b) If the electron has half the speed needed to reach the negative plate, it will turn around and go towards the positive plate. What will its speed be, in meters per second, when it reaches the positive plate in this case? select part Vf,b=1
A parallel-plate capacitor is charged to 5000 VV. A proton is fired into the center of the capacitor at a speed of 4.0×105 m/sm/s as shown in (Figure 1). The proton is deflected while inside the capacitor, and the plates are long enough that the proton will hit one of them before emerging from the far side of the capacitor. What is the impact speed of the proton?
A parallel-plate capacitor has the capacitance of C = 10 µF when the distance of the two plates is d = 5 cm. A battery with the emf = 3 V is used to charge the capacitor. %3D 1. How much charge can be put on the parallel-plate capacitor? (in the unit of pC) Q = Submit Answer Tries 0/2 Now, consider the following two cases separately: Case 1: if the emf stays connected, but the distance of the parallel plates is changed to d = 80 cm. 2. What is the new capacitance C1 and how much is the charge Q1in the capacitor? C1 = µF %D Q1 = %3D Submit Answer Tries 0/2 Case 2: After the initial charging, the emf is removed. Therefore, the amount of charge you calculated from the question #1 remains in the capacitor. Now, again, the distance of the parallel plates is changed to d1 = 80 cm. 3. What is the potential difference V1 across the capacitor? V1 = %3D
... Path of trajectory AV w An electron is fired at a speed v¡ = 3.4 x 106 m/s and at an angle 0; = 30.5° between two parallel conducting plates as shown in the figure. If s = 1.5 mm and the voltage difference between the plates is AV = 98 V, determine how close, w, the electron will get to the %3D %3D bottom plate. Put your answer in meters and include at 6 decimal places in your answer. Do not include units. The x-axis of the coordinate system is in the middle of the parallel plate capacitor. Round your answer to 6 decimal places.
Two square, conducting plates each contain charge of magnitude Q = 35.4 nC. The plates have side length l = 20 cm and are separated by a distance d = 40 mm. Electrons are fired at speed v throgh a tiny hole in the positive plate toward the negative plate. (Remeber that E = Q/Ep0A for parallel plates) a. what is the potential difference between the plates b. if the electrons are stopped halfway between the plates, what is their initial speed, v? c. what is teh minimum speed the electrons must have if they are to make it all the way to the negative plate?
Problem 2: Consider the parallel-plate capacitor shown in the figure. The plate separation is 4.7 mm and the the electric field inside is 26 N/C. An electron is positioned halfway between the plates and is given some initial velocity, v₁. Randomized Variables d=4.7 mm E = 26 N/C Vi,a + + + + + + + + Part (a) What speed, in meters per second, must the electron have in order to make it to the negatively charged plate? d
P1. A plane parallel capacitor, whose plates are eadh of area A and separation d, is ch arged with a bat tery of E MF V. How much work is done if a large met allic slab with thickness d/3 is in serted in side the capacitor? The slab is parallel with the plates. The capacitor is connected to the battery while we move the metallic slab, so the potential of the capacitor is fixed. metal d/3 d A