intake vaive intake compression Tuel Injector power the temperature of the gas; exnaust vaive exhaust The diagrams show the cylinder of a petrol engine in 4 stages. Petrol vapour and air are drawn into the cylinder, The mixture is then squeezed together, and then exploded by a spark. The explosion pushes down the piston. The exhaust gases are then expelled from the cylinder. Use the first law of thermodynamics to analyse the energy changes during the process. At each stage explain what happens to i) the pressure of the gas; ii)

intake vaive intake compression Tuel Injector power the temperature of the gas; exnaust vaive exhaust The diagrams show the cylinder of a petrol engine in 4 stages. Petrol vapour and air are drawn into the cylinder, The mixture is then squeezed together, and then exploded by a spark. The explosion pushes down the piston. The exhaust gases are then expelled from the cylinder. Use the first law of thermodynamics to analyse the energy changes during the process. At each stage explain what happens to i) the pressure of the gas; ii)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The following parameters are recorded on a gas turbine test rig. Stage-1: Inlet temperature is 5000C, Inlet pressure is 650kPa. Exit gas pressure 150kPa. Determine the exit gas temperature for isentropic process. Stage-2 Gas is again heated to 4500C by constant volume process. Assume R=287 J/kg.K; Determine the heat added to the gas assuming Cp/Cv=1.4 and Cp/Cv=1.3; Draw the T-S diagram for the above process.
Methane is heated in a steady-flow process at approximately atmospheric pressure. 1000 kJ of heat is added to 10 moles of methane initially at 500.0K. Note: There can be more than 1 exiting temperature that can give a heat of 1000 kJ. For this one, the exiting temperature does not exceed 3500 K. 1. What is the entropy change of the gas? 12.89 J/K 128.93 J/K а. b. C. 1289.30 J/K d. 12893.00 J/K
An engine operates on methanol with an equivalence ratio of 0.9. The air and fuel enter the engine at 298 K, and the exhaust is at 527 °C. The heat rejected to the coolant is 340 MJ/kmol fuel. (a) What is the enthalpy of the exhaust combustion products in kJ/kg.fuel? (b) What is the specific work output of the engine in kJ/kg.fuel? (c) What is the thermal efficiency of the engine?
In a spark ignition engine C8H18 is used fuel. Air coefficient under full load operation is 1.1. Pressure and temperature of air at the start of ignition are 20 bar and 400°C. If combustion takes place at constant volume without any heat loss, calculate the temperature pressure at the end of combustion. The lower calorific value of C3H18 is 42286 kJ/kg. Values of heat capacity at constant pressure for gases are and Gas CO2 H2O O2 N2 Cp (kJ/kg) 0.8624 1.96 0.908 1.029
During the compression stroke of a certain gasoline engine, the pressure increases from 1.00 atm to 19.0 atm. The process is adiabatic and the air-fuel mixture behaves as a diatomic ideal gas. (a) By what factor does the volume change? Vfinal = Vinitial (b) By what factor does the temperature change? Tinal = Tinitial Assume the compression starts with 0.016 mole of gas at 28.5°C. (c) Find the value of Q that characterizes the process. (d) Find the value of AEnt that characterizes the process. (e) Find the value of W that characterizes the process.
2.016 kg/s of hydrogen gas at 298 K enters an isobaric reactor with a stoichiometric amount of air. The air is at an unknown temperature. The products exit the reactor at 1 atmosphere and 1,500 K. Additionally, the reactor gives off 100,142 kJ/s of heat and a turbine inside the reactor extracts 18.0 MW of power from the flow. Calculate the air inlet temperature to within ±15 K.
In a gas turbine plant, 1000 ° C from the combustion chamber and 1 MPa gases entering with pressure, the turbine with an isentropic efficiency of 90% expands up to pressure. Turbine well it is not insulated and the temperature of 25 ° C and 100 from the turbine during expansion It was determined that there is a significant heat loss to the environment at kPa pressure. has been. Characteristics of air for combustion products and the following using admissions; (a) The actual and reversible specific power output of the turbine, (b) Specific exergy of the air in the inlet and outlet conditions, (c) Second law efficiency, (d) Heat transfer between the turbine and its surroundings and the work produced by the turbine Exergy transfer amounts with, (e) Calculate the irreversibility of the whole process. Assumptions: (i) The power generated by the heat transfer from the turbine to its surroundings is 18% (ii) Consider variable specific heat
RP-1 is highly refined form of kerosene used for many first stage rocket engines. The average composition of it is indicated by CH1.9 a. What is the stoichiometric mixture ratio (MR) for RP-1 and oxygen? b. Now, you have a mixture of air and RP-1 with three times more air (in terms of moles) than is needed to burn all the fuel. How high is the final temperature? The heats of formation are given in the table below. In molar quantities, assume 1 mole of air is (O2+3.76N2). The reactants have a temperature of 25°C before combustion. You may use the average values of the specific heats for each constituent. C. Would the adiabatic flame temperature be lower or higher for a rocket engine that uses pure oxygen instead of air? Explain. Constituent Qf kJ/kmol @ 298 K Cp kJ/kmol K CH19 9,358 CO2 (g) -393,522 51.9 O2 (g) 0 34.0 N2 (g) 0 31.6 H₂0 (g) -241.827 40.6
Identify if the property of the following steam: Pressure Specific Enthalpy Specific Entropy MPa kJ/kg kJ/kg-K 13 2483 ?
Identify if the property of the following steam: Temp Specific Entropy Quality C kJ/kg-K % 202 5.798
Steam enters the turbine at a pressure of 10 bar (absolute pressure) and a temperature of 600oC. Slightly leaving turbine at 1 atm pressure and 90% purity. Looking for the breath to give turbine to it born 1.5 106 kW of work
Identify if the property of the following steam: Temp Internal Energy Specific Entropy kJ/kg kJ/kg-K 322 1915 ?