frequency
Q: X is a N (0,0²) random variable. This random variable is passed through a system whose input-output…
A:
Q: Q1/ Draw the Bode log-magnitude and phase plots for the system shown in figure below, where K=50,…
A: Given:a control system, with K=50we need to do: draw the Bode log magnitude and phase plots for the…
Q: In the circuit shown in Figure below, given İ =10 ∠0°A, calculate the values of İ1, İ2, and İ3
A: The RLC circuit diagram is shown below,
Q: Find out the indicated currents i, and i, in Figure below
A:
Q: 11. Voltage divider with additional capacitor The given voltage divider with R₁=9000 and R2=1000 has…
A: In this question, we need to determine the voltage U2 and phase shift between U2 and U. We know,…
Q: 14. Commercial FM band is from 88-108 MHz. Each FM station is assigned at 200 KHz apart and the peak…
A: Given Data:-The commercial FM band is from 88-108 MHz,Peak frequency deviation is set at 75 KHz,Each…
Q: 2. A circuit with R=2000, L = 230mH, C = 15μF. The voltage supply is v = 36sin 377t. Determine: a.…
A:
Q: 1-In Figure 1, if Hr1=1, Hr2-2, E1-3, E2-4, a=0, find the intrinsic impedance n₁=? a)69.28m b)60.00T…
A:
Q: How do you make this conversion?
A: The conversion of rectangular form into polar form needs to be briefed.
Q: Q2// For the three-phase power system shown in Fig. (1), the reactances of its elements are given in…
A: Find 3 phase symmetrical fault current = ?
Q: The latching current rating of thyristor is 50 mA. Minimum width of gate pulse to turn on the SCR is
A: Given data:Required information:
Q: Ē=3āxCos(110°t-17z)) faz hızını bulunuz. (find the phase velocity) a. 10^6 m/s b. 2x10^6 m/s c. 10^7…
A:
Q: Use repeated source transformation to find I, 4MA 34 $24 un LOK 4k 4MA 工。 12V
A: Given Data:A DC resistive circuit of,To Find:The current through the source.
Q: Q1/The complex magnetic field of a uniform plane wave is given by. 10-3 H = (ax - jaz)ej By 120m b)…
A: Polarisation holds significance in several domains such as physics, optics, and…
Q: Q1. The switch in the circuit shown below has been opened for long time and at t=0 the switch is…
A: In this question, we need to determine the voltage Vc(t) for time t>0. we know, inductor acts as…
Q: Q6 Given that the Boltzmann's constant is 8.617343 x 10 eV/K, with the thermal voltage at room…
A:
Q: What is the Fourier transform x(t): 4dx/dt + 3x = F(t) which shows the relation between x(w) and…
A: Given Data:The mathematic relation between is given below,Required Data:Here, we need to find the…
Q: Determine the transfer function of this system by reducing its shown block diagram U(s) Select one…
A: Given block diagram is,Asked to find the transfer function of the above system.Note: “Since you…
Q: Consider the Circuit shown below. Iy ↑ R3 2.2 ks 7.5 ΚΩ R4 R₁ 39.1 ΚΩ E₁18 V + R5 56.8 ΚΩ + E₂3V R₂…
A: The given circuit isWe need to determine the currents IX and IY using mesh analysis.
Q: Write the frequency response and phase response equation only for the system y(n) = x(n) … 0.5y(n -…
A: For the given system the magnitude response and the phase response needs to be obtained
Q: Problem 2. A sinusoidal message, m(t) = Am * cos(2fmt), is modulated via Conventional AM to obtain…
A: A sinusoidal message signal is given bym(t)=Am∗cos(2πfmt) ;The waveforms given areWe need to to…
Q: Vartz n Fem un R$ Vats roul Bm No Vout
A:
Q: Use Boolean algebra to simplify the following logic gate circuit: A B C Output
A: Given Data:A logic circuit is given in the figure.Required Data:Here, we need to use Boolean…
Q: 4. In circuit shown in fig. P3.5.4, the input voltage v, is 0.2 V. The output voltage v, is 10 ΚΩ ₂0…
A: Given Data:An operational-amplifier circuit is given in the figure.Required Data:Here, we need to…
Q: Solve for vo() in the following circuit using the superposition principle. 10 cos 3/ V 80 40 ΩΞΕ 4…
A: In the given circuit, two AC sources of frequencies 2 and 3 rad/s and one DC source are present. We…
Q: Power = P = 120011. Average Resistance of heating we need to determine, element R = 1052 a. RMS…
A: Given Data:Required Data:Here, we need to determine the RMS current drawn by the kettle.Here, we…
Q: 1-9 Describe the most important feature of an RLC circuit's frequency response. 1-10 Calculate the…
A: The third question is not possible because it is lab based.The inductor, The resistor, The…
Q: For a certain source-free parallel RLC circuit, R = 1 k , C = 3 μF, and L is such that the circuit…
A:
Q: Amplitude 0.6 0.575 0.55 0.525 0.5 0.475 0.45 0.425 0.4 0.375 0.35 0.325 0.3 0.275 0.25 0.225 0.2…
A: In this question, we need to determine the peak value of the response, peak time, relative…
Q: a) total current b) equivalent resistance
A: Given data:Required Information:
Q: 02: Sketch the root locus for the system with open loop transfer function: K(s+4) G(s) = s(s² + 2s +…
A: Sketch the root locus for the given system with OLTF:
Q: CHAPTER 6 Wiring Methods 10. What is the minimum cubic in. volume that is permissible for the…
A: An enclosure in an electrical wire system that provides access to conductors for connecting,…
Q: For the magnetic system given below, assume infinite permeability for the core. * 1=0.5 A 6 cm-…
A: The core of the transformer is given asHere the permeability of the core is infinity.
Q: Q1: For the unity feedback system of figure shown below, 100 Where, G(s) = = s² (5+15) Find ess for…
A: In this question, we need to determine the steady state error for unit step input and unit ramp…
Q: For the circuit shown below, if each diode has a cut in voltage of 0.7 V and v₁ = 6 V and ID₁…
A: Given Data:Required Data:Here, we need to find the value of resistance Here, we need to find the…
Q: Find time 't' (m sec). When the transistor enters saturation |VBE = 0.7V,VCE = 0.2V, Blarge (ON)…
A: Given Data: Required Data:We need to find time "t" when the transistor enters saturation region.
Q: This figure shows the block diagram representation of a compensator U(s)/E(s). E(S) U(s) Ko K Tis 1+…
A:
Q: Assume that at the instant the 60 mA dc current source is applied to the circuit in Figure P3, the…
A: The given circuit is shown below.The value of resistance is .Initial conditions are Volts…
Q: 4. If voltage v = 6 cos( 100t-30°) is applied to a 50µF capacitor, calculate the current through the…
A: First calculate impedance of the capacitor, using ohms law calculate current through…
Q: Example 16.12. The load current in the transmitting antenna of an unmodulated AM transmitter is 8A.…
A: According to the question, the load current in the transmitting antenna of an unmodulated AM…
Q: a) b) Consider the Circuit shown below. 60 ΚΩ www R₁ + EΞ 21 V 30 ΚΩ 마 R2 10 ΚΩ www R3 a ic position…
A: The given circuit isThe switch in the circuit has been in position '1' for a long time and it moves…
Q: Q1: Find the Laplace transform of the following: 1. f(t) = etsin²t PES 2. f(t) = cos 2t u(t)- e-³t…
A:
Q: Identify and label the the (4) FETS in "Ţ C₁ Ro +V₂0 Ro R₂ G₂ o out C₂ out C₁ ню Ro D C₁ +V₂₂ R₂ R₂…
A:
Q: (b) Determine the coefficients of complex exponential for Fourier Series for a continuous time…
A: A Fourier series is a way to represent a periodic function as the sum of simple sine and cosine…
Q: x(t) = rect(t/4)cos (60nt)
A:
Q: F=CD + BCD+ABD+AD + BD 1- draw The logic cct from the equation 2-write the Truth table (T.T) 3- give…
A:
Q: Figure Q5(b) shows a Bode magnitude plot for a stable second order system described by the following…
A: For the given second order transfer function and its frequency response, the labeled value needs to…
Q: Problem2) The switch in the circuit in Figure P2 has been open for a long time before closing at t =…
A: Given:A circuit,the switch has been closed for long time before t=0. we need to find:
Q: 12/30⁰ A + √x 2012 10.2 = 4022
A:
Q: (B): Design a Moore FSM to detect the sequence (00) using T-FFs. Q4/ (A): Design a Mealy FSM for odd…
A:
A resistor of 20ohms and a capacitance of unknown value when connected. In in parallel across a 100V, 50Hz supply take a current of 6A. The combination is now connected across a 100V supply of unknown frequency and the current falls to 5.5A . What is the frequency?
Step by step
Solved in 5 steps with 4 images
- An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
- A resistor of 20 Ohms and a capacitance of unknown value when connected in in parallel across a 100V, 50Hz supply, take a current of 6A. The combination is now connected across a 100v supply of unknown frequency and the current falls to 5.5A. What is the frequency?An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coila resistor and and capacitor are connected in parallel to a 277 v 60 hz power source. the resistor has a value of 50 ohms and the capacitor has a value of 40 uf what is the circuit power factor.
- What is the equivalent resistance ?? and what is the total inductance ??I need answer with explaination In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltageStep 1 : Show that the voltage division rule for two capacitors in series as in the figure Step 2: For two capacitors in parallel as in the second figure, show that the current division rule is:
- Three capacitors 6, 10 and 15 uF are connected in series across a 100 volt supply. Find the voltageacross the 10uF capacitor.A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.ASAP 30 MINUTES LEFT What is the total capacitance of a circuit with 3 capacitors of .6mF connected in series? a. 0.5mF b. 1.8mF c. 0.2mF d. 0.6mF