Answered: Four conductors meet at a junction. the…

Four conductors meet at a junction. the current are i1= 5sinwt, i2= 3sin(wt + 90) and i3= 2sin(wt-90). calculate the rms value of i4.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.25MCQ

See similar textbooks

Related questions

Q: 6. In the balanced 3-phase system of Figure 2, determine the RMS phase and line voltages and…

A: For Three phase balanced load system The calculations are straight forward

Q: A load consists of R=99 , XL=52 and XC=30 . All the elements are connected in parallel across 140…

A: For resistive voltage and current in phase with each other. For inductor Current lag voltage by 90…

Q: Question 3: i) Identify the type of circuit shown and justify your answer. ii) Establish the line…

Q: 6. Transformers have the capability to step up or step down AC voltage True False

Q: a) why is there a wattmeter reading when the load is purely inductive

A: Given that a) why is there a wattmeter reading when the load is purely inductive b) why is there no…

Q: Given a single phase inductance Lm.1) ,1phase = 12 mH, what is the mutual inductance between stator…

A: Given:Single phase inductance Lm,1 phase=12 mH

Q: Impedance, inductance, and reactance are all measured using ohms. a) True b) False

A: IMPEDANCE-Impedance is a combinational of resistance and reactance.It is a measure of the ability…

Q: a) The total voltage drop. b) The real power (P) per phase for each load. c) The reactive power (Q)…

A: As per our guidelines we are supposed to the first 3 subparts,if a student asks multiple subparts.…

Q: 22 (a) Three-phase generator consist of three set of single-phase generators, with voltages equal in…

Q: Loads can be classified according to the Nature of the Load. Which among these is not included as…

A: There are three types of loads based on the nature of loads They are Resistive ,inductive and…

Q: Determine the inductance per km per phase of a single circuit 460 KV line using two bundle…

A: Bundled conductors are used as they result in less voltage drop and has less reactance. They even…

Q: Three single-phase transformers are connected into a three-phase bank. The primary is connected as a…

A: In this question we need to find a phase voltage of primary.

Q: Current 450 Problems 9.8 A three phase Ihe be tween phase conductors of 4 m. Each con ductor has has…

Q: The single phase AC sinusoidal current i=/2 I sin(wt+ 0) then the peak value of the current is Ims O…

A: Given: i=2I sin(wt+θ)i=Imsin(wt+θ) Im = peak currentPeak current =2I Option D

Q: Single phasing happens when one phase of a three phase source becomes unavailable. True False

A: Given A true or false question based on single phasing condition. Please find the answer below.

Q: 1. Three loads, units A, B, and C are connected in parallel and take currents that are 12, 10, and…

A: Given, Three loads A, B & C are connected in parallel and take currents, with Ia as reference.…

Q: Refer to series-parallel ac circuit of Figure 1. The reading on the voltmeter is 185.5Z-230V at 60…

A: here ammeter(ideal) short circuit the impedance Z3 . Now current from source is voltmeter readingR2…

Q: Manufacturers usually specify the impedances of machines and transformers in O Percent O Per-unit O…

A: Need to Find correct option

Q: Single Phase and Three Phase Principles

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Define the parts and functions of AC Generator - Define the working principle of AC Generator. -…

A: AC Generator A machine that converts mechanical energy to electrical energy is called AC generator.…

Q: Find the no load line voltage of a star connected 4 pole alternator from the following: Flux per…

A: Given, A star connected alternator has, Number of poles (P)=4 Flux per pole= 0.12 wb Slot per pole…

Q: Which statement is wrong ? High load factor of a generating equipment Ogives more profit to owner…

A: LOAD FACTOR :- The Load Factor is defined as a ratio of the average load…

Q: In a 3-phase overhead system. each hne is suspended by a string of 3 insulators. The voltage across…

A: Given, A 3-ph overhead transmission line has, Number of insulator= 3 Voltage across the top unit…

Q: 1. (a) Which parameter is the most important in case of determining the rating of a circuit breaker…

A: (a) In a power system, the rating of a circuit breaker is usually defined by its capacity to handle…

Q: A complex voltage v=30+50sin 1000t-40sin2000t Volt, is applied across the circuit shown in figure…

A: Given: A complex source of different frequencies is given as vT=30+50sin1000t-40sin2000t Volt.…

Q: Draw Wye- Delta three phase transformers connection ( no-load and full-load) in Lt-spice

Q: 72. In 132 kV system, the phase to ground ca- pacitance is 0.01 µF and inductance is 6H. The voltage…

Q: A- Consider the system shown below. Phase b is open due to conductor break. Calculate the sequence…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: For performing dielectric-strength tests on insulating materials, two transformers are connected in…

A: Dielectric strength test is one of tje important tests to be performed on transformer. In this test…

Q: 25/. A three phase loads each resistance of 100 Ω and capacitance of 10 µF are given, with 415 V, 50…

Q: Two single phase transformers A and B with equal turns ratio have reactance of j3.2 and j19.2…

Q: Can you explain the theory behind why the inductor in phase R and phase B become in series when…

A: As, the given circuit is Currently the inductors are in star connection and they are supplied with…

Q: Q2: A 24 kVA ,400 V, 50 Hz synchronous generator has Ra=0.6 Q/ph. Xd%3D2XQ%3D5 0/ph. Calculate…

Q: In the circuit in the figure; L1 load draws 15 kVA with lagging power factor 0.6. The L2 load…

Q: 14. In AC circuits, voltage and current are always in same phase. (a) True (b) False

A: IN AC circuit, voltage and current are always

Q: How do we generate 3 phase voltages with different phase angles? Explain it by using maximum 80…

A: The 3-phase voltage is generated by the alternator. The 3-phase voltage is generated by the…

Q: Q4. Define three cases on which real and reactive power flow gets affected. Draw the phasor diagrams…

A: Active power- The power is utilized or consumed in an AC circuit. It is known as real power, True…

Q: what are the advantages and Disadvantages Connecting transformers 3 Phase between (delta to Star)

A: Star to delta connection. In this connection, the start connection is at the primary side and the…

Q: In general, a three-phase induction motor isdesigned for wye connection operation. However,…

A: Calculate the power for wye connection operation,

Q: a. Write a table consists of well- known power capacity of distribution transformers

A: As per the rules we can answer only one question, please post the remaining questions as the…

Q: Figure below shows a power system. The rating of generators and transformers are:G1:25MVA, 6.6KV,…

A: base value 30 KVA and 6.6 KV=0.03 MVAXpu(new)= Xpu(old) ×(MVAnew)(MVAold)×(KVoldKvnew)2

Q: If all impedances in Figure Q2 are 15+j45 Ω. Calculate the neutral line current

A: The electrical circuits comprise voltage and current sources, along with the impedances. The…

Q: When connecting the circuit in the figure to an AC voltage generator, it is possible to say that L O…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: e = 0 Q1: What does happen if we change two currents? Q2: What does happen if we have a three-phase…

A: 1)It is not possible that , current can flow in two directions at same time. However if we apply two…

Q: A parallel combination of a 24- ohm resistor and a 32-ohm inductor will result to a total impedance…

A: In this question we will find vertical component of impedamce of parallel RL circuit....

Q: is the opposition of the line conductors to the flow of current through them. Select one: O a.…

A: The property of resistance is that it opposes flow of electron in a material. When voltage applied…

Q: Determine the line currents for tle folbwing triphasic arcult. 1+j2 Q A 100/0° V C B Z, = 12 + j2 Q…

Q: 1. Three 3.33 Q resistance are connected in delta across 220 V, 3 phase supply. The equivalent wye…

A: In this question, Choose the correct options What is equivalent of the resistance R in the star.…

Q: Figure below shows three loads connected in parallel across a 1000-V (RMS), 60-Hz single-phase…

A: The solution can be achieved as follows.

Q: and inductance of 100mH is connected in a star with a 3-phase supply. The frequency is 50 Hz. Line…

A: The star connected load may have three wire or may have four wire as one wire is neutral. The…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Four conductors meet at a junction. the current are i₁₌5sinwt, i₂= 3sin(wt + 90) and i₃= 2sin(wt-90). calculate the rms value of i₄.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated sheets of alloy steel (ii) Eddy current loss (b) Can be reduced by the use of special high grades of alloy stl as core material.
An ac resistance is higher than a dc resistance. True False
For the circuit given in Figure 1, a) Find the Thevenin equivalent circuit with respect to terminals a-b b) When a 5000 resistor is connected to terminal a-b, find the voltage on the resistor wwwwwwmm c) It will be connected to a-b terminals and its voltage on 5000 load will be 132 kV rms. What should be the capacitive reactance value that will increase it? wwwwwwwww d) What happens to the short-circuit current when the a-b terminals are short-circuited? 2+1202 000 m da 127/6 kV rms ob 1.5 +/902 000 w 12725 kV ms
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
Need asap pls help. Solve for the voltages across and currents through each component. Show the complete solution and explain. The total power should be zero..
What will be the value of the twiddle factor: W42
A 400 MVA synchronous machine has H, = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two machines operate in parallel in a power plant. Find out H relative to a 100 MVA base.
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
Calculate the RMS current through R2 in the diagram IR1 = 6.06mA peak, R2 = 2.7 kohms, total current is 9.522mA RMS 3.25mA RMS 5.24mA RMS 7.41mA RMS 9.0mA RMS
In the figure: R1 = 1439.170, R2 = R1 and R3 =2R2, then determine the value of the voltage source E. a 8 mA 10 mA 2 mA RT R1 R2 R3 O 25.33 11.51 O 17.27 15.43 13.82 +
X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R = 10 ohms, L = 20mH and frequency of 1000rad / s, the current measured is 2.2361A at 89.44 leading power factor. A) Determine the initial capacitance. B) However, a fault occurs on the capacitor branch making its capacitance 20% lower and a resistance of 5 ohms is detected. If this faulty circuit is rerun but at a frequency of 500 rad / s, determine the new current that will flow through the circuit.