Discuss the Principle of Operation of the PLC.
Q: We have a nonlinear resistor that is approximated by a piecewise linear model, as is shown in Fig.…
A:
Q: Segments of two sinusoids are shown in the plot below. Determine the phase difference between the…
A: We need to find out the phase difference between given waveforms .
Q: 3A 252 3.55L + Vo 352 4A
A: We need to find out the Vo for given circuit by using of nodal analysis .
Q: What surface must a capacitor have if its plates are separated by a dielectric of constant 8 y and 2…
A:
Q: B- Choice the correct answer 1. The energy storage capacity of a cell is determined by the:…
A: Battery, A battery is the device which is use for conversion of chemicle energy in useful electrical…
Q: At a 220 kV substation of apowersystem, it is given that the three-phase fault level is 4000 MVA and…
A: Given: Substation = 220kV Three Phase Fault Level = 4000 MVA Single-line to Ground fault Level =…
Q: The current in the circuit below is 3V Select one: ΟΠΟΙΑ Ο Α.Ο.Σ.Α. σε ΦΠΑ Ο ΦΟΒΑ (+1 4Ω ww 6Ω www…
A: The basic kvl problem is solved below.
Q: Find the number of poles required, when the frequency is 50Hz and speed of the motor is 500 rpm?
A: Given, Frequency, f = 50 Hz. Speed of motor, N = 500 rpm. The number of pole, P =?
Q: How am I getting the wrong answer?
A: It is given that: Vs=4.5 VR1=3 kΩR2=2.7 kΩR3=3.6 kΩR4=3.1 kΩ
Q: A 3-phase, 16-pole alternator has the following data: Number of slots = 192; conductors per slot =…
A: Given: 3 phase, Pole, P=16 Number of slots =192 Conductors per slot = 8 Coil span = 160° Speed of…
Q: Vac के 1=0 If C www
A:
Q: The effective resistance of a 2,200 V, 50 Hz, 440 kVA, 1-phase alternator is 0.5 ohm. On short…
A:
Q: (a) What is Reg for the circuit?
A: It is given that: R1=100 ΩR2=200 ΩR3=300 ΩV=12 V
Q: The book says I should have found 46amps. Is this a misprint?
A: as the given explanation in the previous is correct.
Q: A loss-less transmission line having characteristics impedance Zo is terminated in a load of Z₂. If…
A: Given, A lossless transmission line having, Characteristics impedance = ZO. Terminated to load…
Q: In Photovoltaic system, Explain the function of power electronics to harness electrical energy?
A: Photovoltaic system A photovoltaic (PV) system is made up of one or more solar panels, an inverter,…
Q: If the penalty factor of a plant is 2, its incremented transmission loss will be A) 1 B) 0.5 c) -…
A: Given, The penalty factor of the pant, L=2. Incremented transmission loss, ∂PL∂P=?
Q: In the circuit give below, find R Reg eq 10Ω 8Ω `eq. 8Ω 4
A: Given circuit,
Q: discribe the key step in the design a Contral System
A: There are basically 4 step to design a desirable control system. The block diagram of the control…
Q: Solve for V0 using mesh analysis Step-by-step, please. I need to understand the process.
A:
Q: If the output power of an amplifier is 55mW, what is the output power of the amplifier in dBm?
A: Given, The output power of an amplifier is P0=55 mW.
Q: vo voltage. (₁) For Single-phase half-controlled bridge rectifier shown in the figure : 1- Derive a…
A:
Q: A 100 kV, 50 Hz supply is fed to a rectifier ammeter (using a bridge rectifier) through a capacitor.…
A:
Q: Q4: Using Current Divider Law, Calculate the current flowing through A and B branches. IA = IB = 24…
A: Given,
Q: In the circuit of Fig. 27, find the branch current I, which flows through R₂, when R₂ has the…
A:
Q: 26. Determine the current through R₂ in the following circuit. Consider using the current divider…
A: Given circuit:
Q: A current of 20A flows through a load having a resistance of 2 ohm. Determine the power dissipated…
A: Current I = 20 A Load resistance RL= 2 Ω Coil resistance Rc = 0.01 Ω We have to find the the value…
Q: Find the value of all the currents (ia-if). B. Find the magnitude of the total power developed in…
A: In this question, We need determine the currents ia to if using the mesh analysis. We know Power…
Q: If the output power of an amplifier is 55mW, what is the output power of the amplifier in dBm?
A: The output of power amplifier is given by Po = 10log(Po/1mw)
Q: Question 4 A load within a circuit absorbs 3 kW of average power with a lagging power factor of 0.2.…
A: In this question, We need to determine the reactive power Q? If active power P= 3kW And power…
Q: For a 4 pole induction motor find the synchronous speed if its running at 440V, 50 Hz A.C. supply.
A: Given, For an induction motor, Total number of poles, P = 4. Supply voltage, Vs = 440 V. Frequency,…
Q: 33. For the circuit shown in Fig. 29, calculate the current in the 62 - resistance by using Norton's…
A: Given circuit,
Q: x+y+xyz
A: Given: x¯+y¯+xyz¯ To find: Simplify expression using boolean expression simplification. Note:…
Q: Design a meter with voltage range of 0-30V, and ammeter with current range of 0-20mA from an ammeter…
A: In the given questions we need to design a voltmeter and ammeter of desirable rating.
Q: EXAMPLE 4.23 A 500 µH inductor, 80/² pF capacitor and a 628 resistor are connected to form a series…
A:
Q: R(S) 1 s+1 2 s+3 3 s + 4 1 s+2 Y(s)
A:
Q: The CMRR of a differential amplifier is 60 dB. If the differential mode gain is 1400, what is the…
A: Given, In a differential amplifier, CMRRdB=60 dB. Differential mode gain, Ad=1400.
Q: Problem Y A to Y Transforms 552 Re 两 Rb Ra. 4.323 Determine Ra R₁ Ri 1.25-26 R₂ 132212²23
A:
Q: :One kilowatt-hour is the power consumed by a 1kW- load during one hour.a None of the answers is…
A: Power: Work done by electrical energy is called power. represented by P.SI unit for power = watt…
Q: Q5: A signal s(t) band - limited to 4 KHz at a rate 50% higher than Nyquist condition the signal…
A: SOLUTION GIVEN fm = 4 KHz Peak amplitude = 12 & -12 Sub…
Q: 10. Find the Norton's current in the circuit shown below. 10 S 30430 A
A:
Q: to to t (a) (b) (c) (a) Phasor diagram for the wave E₁ = Eo Sin (wt). The phasor is a vector of…
A:
Q: Use the circuit shown in the image. Compute only the current though the 20 ohm resistor. 140 A 0.50…
A: Given, The circuit is,
Q: A three phase six pulse converter having input 430 V, 50Hz supply is controlling a de motor. Motor…
A:
Q: coil takes a current of 2A from a 12V d.c. supply. When connected to a 240V, 50 Hz supply the…
A: We need to find out inductance , reactance , impedance for given current and voltage for given coili
Q: Using Boolean algebra simplify the following expressions 1. A(A + B)
A: Given, The Boolean expression is AA+B.
Q: 3. The magnetic flux passing through a coil perpendicular to its plane is a function of time and is…
A:
Q: 12V 1+ 4.5 AM 252 M 3.5 Vo 3.2 M 121
A:
Q: R2 (s) 3 ya+ R1 (s) “င် း ာင်းနှင် + |H2 |3 | Y6 G₁ | G3 Y2 (s) + /ya + 7 G5 |s Y1 (s)
A: Given: A block diagram of a control system To find: Solve T11(s), T12(s), T21(s), and T22(s) Note:…
Q: 4Ω www 3A (Η 2 Ω ww 8 Ω + 3Ω να - +1 12 V
A:
Discuss the Principle of Operation of the PLC.
Step by step
Solved in 4 steps with 4 images
- By using modular PLC type LG write the PLC LIP that generates a square wave of 4 Hz and 70 % duty cycle. Use NO start Button and NC stop Button and a led as indicator.Describe DCS and PLC control systems.Hi expert.. Please do it correct and fast within 30 minutes. What do modern PLCs use to keep their real-time clocks and Static RAM alive, when without 24V DC feed?
- Groffel Tutorial. Question 1 : a) clearly explain what are the different components in PLC? b) Explain the advantages of plc than hard wired helay ? c) Explain what is the programmable longer age used PLC ?Write a Ladder Logic PLC program for each of the following scenarios. Label all contacts and coils in the PLC program.Enumerate the difference between the modular and compact PLC?
- Finally assume that the electrical circuit will be working through a PLC unit, state and justify how it will improve the circuit and makes it more reliable.Questions Define PLC? Explain the Parts of a PLC?A) What is a PLC? B) What is the difference between a SCADA, DCS and PLC? In your answer state where you would likely see each system deploy and why those areas are appropriate. C) Describe the operation of a SCADA D) Write a simple PLC program to control a pump in a water distribution plant
- 7. What is the difference between an electrical concept and a PLC concept?Question 6: Look at this PLC on-delay circuit and explain and describe how it will function, in detail, referencing to each component in the circuit shown and how each component will work together to give an off-delay.Industrial Motor Controls 15.a. A discrete input can be which of the following?A. −10–+10 VDCB. On or OffC. 4–20 mAD. 0–10 VDC 15.b. The PLC power supply provides power to theA. relay interface.B. programming terminal.C. CPU and I/O system.D. field devices.