Calculate the temperature in an unheated space (Tunc) adjacent to a conditioned room with three (3) common surface areas of 175-ft2, 190-ft2, and 210-ft² with an overall heat transfer coefficient of 0.21, 0.27, and 0.32 Btu/h-Ft2 °F, respectively. The surface areas of the unheated space exposed to the outdoors are 175-ft² and 210-ft² with corresponding overall heat transfer coefficients of 0.21 and 0.40 Btu/h- Ft2 °F. The sixth (6th) surface is on the ground and can be neglected for this example as can be the effect of any outdoor air entering the space. Inside & outside design reference temperatures are 70°F & -10°F, respectively. Tunc = 37°F Tunc = 36°F Tunc = 30°F Tunc = 35°F

Calculate the temperature in an unheated space (Tunc) adjacent to a conditioned room with three (3) common surface areas of 175-ft2, 190-ft2, and 210-ft² with an overall heat transfer coefficient of 0.21, 0.27, and 0.32 Btu/h-Ft2 °F, respectively. The surface areas of the unheated space exposed to the outdoors are 175-ft² and 210-ft² with corresponding overall heat transfer coefficients of 0.21 and 0.40 Btu/h- Ft2 °F. The sixth (6th) surface is on the ground and can be neglected for this example as can be the effect of any outdoor air entering the space. Inside & outside design reference temperatures are 70°F & -10°F, respectively. Tunc = 37°F Tunc = 36°F Tunc = 30°F Tunc = 35°F

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.39P: 1.39 On a cold winter day, the outside wall of a home is exposed to an air temperature of when the...

See similar textbooks

Similar questions

A cooling system is to be designed for a food storage warehouse for keeping perishable foods cool prior to transportation to grocery stores. The warehouse has an effective surface area of 1860 m2 exposed to an ambient air temperature of 32C. The warehouse wall insulation (k=0.17W/(mK)) is 7.5 cm thick. Determine the rate at which heat must be removed (W) from the warehouse to maintain the food at 4C.
A pipe carrying superheated steam in a basement at 10C has a surface temperature of 150C. Heat loss from the pipe occurs by radiation (=0.6) and natural convection (hc=25W/m2K). Determine the percentage of the total heat loss by these two mechanisms.
The heat transfer coefficient between a surface and a liquid is 57 W/(m2K). How many watts per square meter will be transferred in this system if the temperature difference is 10C?
Using Table 1.4 as a guide, prepare a similar table showing the orders of magnitude of the thermal resistances of a unit area for convection between a surface and various fluids.
Heat is transferred at a rate of 0.1 kW through glass wool insulation (density=100kg/m3) with a 5-cm thickness and 2-m2 area. If the hot surface is at 70C, determine the temperature of the cooler surface.
1.39 On a cold winter day, the outside wall of a home is exposed to an air temperature of when the inside temperature of the room is at . As a result of this temperature gradient, there is heat loss through the wall to the outside. Consider the convective heat transfer coefficients for the air inside the room and at the outside wall surface to be, respectively, 12.0 and . If the composite room wall is modeled as a plane wall with a thermal resistance per unit area of , determine the temperature at the outer surface of the wall as well as the rate of heat flow through the wall per unit area. If the homeowner were to consider using a fiberglass insulation layer on the inside wall surface for reducing this heat loss by 50%, what is the required thickness of this layer and the outside wall temperature for this case?
1.67 In beauty salons and in homes, a ubiquitous device is the hairdryer. The front end of a typical hairdryer is idealized as a thin-walled cylindrical duct with a 6-cm diameter with a fan at the inlet that blows air over an electric heating coil as schematically shown in the figure. The design of this appliance requires two power settings, with which the air blown over the electric heating coil is heated from the ambient temperature of to an outlet temperature of and with exit air velocities of 1.0 m/s and 1.5 m/s. Estimate the electric power required for the heating coil to meet these conditions, assuming that heat loss from the outside of the dryer duct is neglected.
1.60 Two electric resistance heaters with a 20 cm length and a 2 cm diameter are inserted into a well-insulated 40-L tank of water that is initially at 300 K. If each heater dissipates 500 W, what is the time required for bringing the water temperature in the tank to 340 K? State your assumption for your analysis.
1.29 A spherical interplanetary probe with a 30-cm diameter contains electronic equipment that dissipates 100 W. If the probe surface has an emissivity of 0.8, what is its surface temperature in outer space? State your assumptions in the calculations.
1. A 1000-W iron is left on the iron board with its base exposed to the air at 20°C. The convection heat transfer coefficient between the base surface and the surrounding air is 35 W/m². °C. If the base has an emissivity of 0.6 and a surface area of 0.02 m², determine the temperature of the base of the iron. 2. The inner and outer surfaces of a 5-m x 6-m brick wall of thickness 30 cm and thermal conductivity 0.69 W/m °C are maintained at temperatures of 20°C and 5°C, respectively. Determine the rate of heat transfer through the wall, in W.
H.W1 Consider a person standing in a room. Determine the total rate of heat transfer from this person if the exposed surface area and temperature are 1.6m² and 29°C, respectively. Assume that the convection heat transfer coefficient is 6W/m².K and the emissivity of a person is 0.95. The air temperature in the room is maintained at 22°C at all times of the year. In summer, the wall and ceiling temperatures are observed to be 25°C, while in winter, they are 10°C. Ans: Qrotal =104.4 W In Summer Qrotal =231.3 W In Winter
Question:- A cylindrical steel tank with a diameter of 3 m and height of 4.4 m is used to store chilled water (at 9.3 °C) as part of an air conditioning system for a building. The heat transfer (convection) co-efficient for the surface of the tank in contact with the water in this application is 15 W/(m2.K). Given the surface temperature of the metal tank is 40 °C. At what rate must heat energy be removed from the water just to maintain its temperature constant at 9.3 °C ? Assume the tank is an enclosed cylinder and that the tank is always full. Note - the thickness of the tank is not relevant to this problem. Work in base SI units.