AA = (AX Ах (a) O increasing RHR-2 в Application of Lenz's law RHR-1 R #E Equivalent circuit (b) Figure 23.11 (a) A motional emf = Btv is induced between the rails when this rod moves to the right in the uniform magnetic field. The magnetic field B is into the page, perpendiculer to the moving rod and rails and, hence, to the area enclosed by them. (b) Lenz's law gives the directions of the induced field and current, and the polarity of the induced emf. Since the flux is increasing, the induced field is in the opposite direction, or out of the page. RHR-2 gives the current direction shown, and the polarity of the rod will drive such a current. RHR-1 also indicates the same polarity for the rod. (Note that the script E symbol used in the equivalent circuit at the bottom of part (b) represents emf.)

AA = (AX Ах (a) O increasing RHR-2 в Application of Lenz's law RHR-1 R #E Equivalent circuit (b) Figure 23.11 (a) A motional emf = Btv is induced between the rails when this rod moves to the right in the uniform magnetic field. The magnetic field B is into the page, perpendiculer to the moving rod and rails and, hence, to the area enclosed by them. (b) Lenz's law gives the directions of the induced field and current, and the polarity of the induced emf. Since the flux is increasing, the induced field is in the opposite direction, or out of the page. RHR-2 gives the current direction shown, and the polarity of the rod will drive such a current. RHR-1 also indicates the same polarity for the rod. (Note that the script E symbol used in the equivalent circuit at the bottom of part (b) represents emf.)

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 33P: A single-turn circular loop of wire of radius 50 mm lies in a plane perpendicular to a spatially...

See similar textbooks

Similar questions

Check Your Understanding Shown below is a rod of length l that is rotated counterclockwise around the axis through O by the torque due to mg . Assuming that the rod is in a uniform magnetic field B , what is the emf induced between the ends of the rod when its angular velocity is ? Which end of the rod is at a higher potential?
A solenoid is wound with 2000 turns pet meter. When the cuiient is 5.2 A, what is the magnetic field within the solenoid?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
How is the percentage change in the strength of the magnetic field across the face of the toroid related to the percentage change in the radial distance from the axis of the toroid?
Check your Understanding Themagneticfield shown below Is confined to the cylindrical region shown and is changing withtime. Identity those paths for which =EdI0 .
12.7 Check Your Understanding What is the ratio of the magnetic field produced from using a finite formula over the infinite approximation for an angle of (a) 85°? (b) 89°? The solenoid has 1000 mins in 50 cm with a current of 1.0 A flowing through the coils
The magnetic field perpendicular to a single sire loop of diameter 10.0 cm decreases fron 0.50 T to zero. The re Is made of copper and has a diameter of 2.0 mm and length 1.0 cm. How much charge moves thrnugh the re while tt field is changing?
Check Your Understanding What Is the magnitude of the induced electric field in Example 13.8 at t=0 if r= 6.0cm, R= 2.0cm,n = 2000 turnspermeter, I0= 2.0A, and a = 200s-1?
Suppose you wish to produce 1.2-T magnetic field in a toroid with an iron core for which =4.0103 . The toroid has a mean radius of 15 cm and is wound with 500 turns. What current is required?
The two long, parallel wires shown in the accompanying figure carry currents in the same direction. If I1= 10 A and I2= 20 A, what is tire magnetic field at point P?
In the August 1992 space shuttle flight, only 250 m of the conducting tether considered in Example 23.2 could be let out. A 40.0 V motional emf was generated in me Earth’s 5.00105T field, while moving at 7.80103m/s. What was the angle between the shuttle’s velocity and the Earth’s field, assuming the conductor was perpendicular to the field?
Check Your Understanding Consider using Ampere’s law to calculate the magnetic fields of a finite straight wire and of a circular loop of wire. Why is it not useful for these calculation?