a.derive the expression for the close- loop gain for an op amp non inverting amplifier b.the input of an op amp differentiator is a sinosiodial voltage peak of value 150uV voltage of frequency 10hz.determine the output voltage if the R=25ohms and C=2uf. C.An inverting amplifier has Rf=200ohms and R1= 12ohms. Determine the amplifier circuit voltage gain,input resistance and output resistance, determine also the output voltage, and input current if the voltage is 0.3. Assump it is an ideal op amp.

a.derive the expression for the close- loop gain for an op amp non inverting amplifier b.the input of an op amp differentiator is a sinosiodial voltage peak of value 150uV voltage of frequency 10hz.determine the output voltage if the R=25ohms and C=2uf. C.An inverting amplifier has Rf=200ohms and R1= 12ohms. Determine the amplifier circuit voltage gain,input resistance and output resistance, determine also the output voltage, and input current if the voltage is 0.3. Assump it is an ideal op amp.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The term duty cycle refers to the amount of time a signal is complete cycle. A. off compared to the period of one B. on The output voltage of op-amp is positive saturation, when the voltage applied to the input is greater than the input. A. inverting B. noninverting A square wave that is 20V at its high state and OV when it is off will produce an average DC when its duty cycle is 75%. Formula: VOUT = Duty Cycle * Peak voltage voltage of A. 7.5V B. 10V C. 15V
3) Consider the Zener-diode voltage regulator shown below. Suppose you design this circuit to drive (supply) a load resistance RL. The supply voltages to the op-amp are +15 V and -15 V (not shown). a) What is Vout? b) If R = 1 k 2, what is the smallest R, that the circuit can handle without "sagging" the output voltage? c) What should be the power rating of the resistor R? Be explicit about your assumptions. +15 V R Vout IN4738 CS Scanned with CaScanner
Design a voltage to current converter amplifier. Assume that you have 5v input voltage to the non-inverting input with a frequency of 60hz and another input voltage to the inverting input with a frequency of 60hz, place it before the input resistance. What should be the value of your voltage input in inverting input and input resistance to get a reading of 38.22mA at exactly 22.20ms and what is the shape waveform of the current? Cursor 1 I(R2) Horz: 22.204037ms Vert: 38.277447mA What is the value of Rin in ohms? No need to include the Units. Rin = ohms ----
Design a voltage to current converter amplifier. Assume that you have 5v input voltage to the non-inverting input with a frequency of 60hz and another input voltage to the inverting input with a frequency of 60hz, place it before the input resistance. What should be the value of your voltage input in inverting input and input resistance to get a reading of 38.22mA at exactly 22.20ms and what is the shape waveform of the current? What is the value of Vin?Vin = ____ volts
With capacitors in this Inverting Op-Amp, how should I find worst case values of Rin and Rf?
For the given op-amp circuit, determine: (a) iout/iin2, (b) iin2/iin, (c) iin/Is, and (d) iout/Is.
If the ideal design for op-Amp circuit generate 200 mV at the output, Then practically with 26 mV offset voltage the output voltage of the circuit will be equal to .............. mV
3I Calculate the the Output Voltage of a non-inverting op-amp with the following parameters Rf = 360KOhms, Vo = -9.3V, and Vi = -0.3V. a.31.2 kOhms b.32 kOhms c.12 kOhms d.31 kOHms
Figure 6 (a) shows the circuit diagram for a differential amphfier. You may assume that M and M, have identical parameters. Referring to Figure 6 (a): (a) What kind of amplifier is it? What is its role in a three-stage op amp? Draw the small signal equivalent eircuit and derive the differential voltage gain Aag. For the analysis consider RDI RD2 >>Rp State any assumption. (b) RD. gml gm gm, and r re=r What is the new Adr in the circuit of Figure 6 (b), where a PMOS current source has replaced the two drain resistors Ror R Rp and a NMOS current sink has replaced the source resistor Rs? (c) What are the advantages in using the circuit of Figure 6 (b) instead of Figure 6 (a) to realize an op amp? (d) Ven Ms Mg Rp1 Rpa Vo HM, My M Ma M3 Vss 0 V Vss 0 V Figure 6(b) Figure 6 (a)
2. b) (i) Derive an expression for the differentiator using op-amp. (ii) Design a circuit to perform differentiation of an input signal that varies in frequency from 20HZ to about 2 KHz. (iii) If a sine wave of 0.5 V peak at 2 KHz is applied to the differentiator of part (ii), draw the output waveform.
Introducion to Electronic Analysis and Design - CE05 To have a good amplifier Select one: a. The input resistance should be high b. the output resistance should be high c. the voltage gain should be equal to zero d. the current gain should be equal to zero Ssment CE255/EE255 (O1)- Dr. Mamoun Al-Mistar Jump to...
Consider the op-amp circuit to the right. Write a general formula for Vout as a function of Vin and the parameters of the resistor and MOSFET. Make sure to pay attention to the orientation of the MOSFET, you may assume an ideal op-amp. Vin R1 om + Q1 Vout