A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder that measures 52.0 cm wide and 62.4 cm high. The maximum safe pressure inside the vessel has been measured to be 7.20 MPa. For a certain reaction the vessel may contain up to 6.16 kg of dinitrogen monoxide gas. Calculate the maximum safe operating temperature the engineer should recommend for this reaction. Write your answer in degrees Celsius. Be sure your answer has the correct number of significant digits. temperature: n°c

Q: The structure of bentonite is best described as Select one: a. Negatively charged aluminium silicate...

A:

Q: If methylisonitrile is placed in a sealed quartz tube and heated in a tube furnace, it isomerizes to...

A: Given reaction: CH3NC (g)  →  CH3CN (g)   The initial number of moles of methylisonitrile = 0.200 mo...

Q: The reaction described by the equation 0,(g) + NO(g) 0,(g) + NO, (g) > has, at 310 K, the rate law r...

A: Given: The concentration of O3 at (t = 0 ) =3.0×10-4 M The concentration of NO at (t = 0 ) =6.0×10-5...

Q: Starting from acetylene and alkyl halides not longer than 4 carbon atoms, show the synthesis of 3-oc...

A:

Q: Part B KCI (aq) Express your answers as chemical equations separated by a comma. Identify all of the...

A:

Q: 16

A: Cis-Trans isomerism is very common isomerism which can be seen in organic molecules. The cis-trans i...

Q: I need help finding the therotical yield and the percent yield with the data provided:  mass of fil...

A: % yield = Actual yield  / theoretical  yield ×100

Q: Determine the enantiomer of Carbon 1 and Carbon 2. If it is an S or an R enantiomer.

A: Configuration of the molecule.

Q: The chemical reaction shown was performed and the concentration of CCl, was measured over time. Cl, ...

A:

Q: The major product for the following reaction will be BH3 H2O2, OD-

A:

Q: When the atom of Th-232 undergoes radioactive decay, an alpha particle, which has a mass of 4.0 a.m....

A: Given that, mass m= 4 amu  1 amu = 1.67377×10-27 Kg velocity v= 1.4×107 m s-1 Wavelength = ?

Q: Given the set of compounds below: isopentane 4-methylcyclopent-1-ene toluene In separate test tubes,...

A: A question based on aromatic compounds that is to be accomplished. 

Q: Arrange the compounds in order of INCREASING reactivity towards bromination. Toluene, Nitrobenzene,...

A:

Q: 19. A product weighing 12.11 g was isolated/obtained in the laboratory. The maximum amount of obtain...

A: Given,  A product weighing 12.11g was obtained in the experiment, the maximum product can be obtaina...

Q: HyC CH, CHy

A:

Q: Considering the NMR data below, which of these structure is correct?

A: 13C-NMR is an analytical technique which is aimed at structural elucidation of a compound. The struc...

Q: 1. Differentiate between thermoplastic and thermosetting polymers.

A: Thermosetting plastics and thermoplastics are both polymers, but they behave differently when expose...

Q: Which of the following atoms has the largest radius? a) F b)Cl c)Li d) Na

A: Which of the following atoms has the largest radius?  a) F b)Cl  c)Li d) Na

Q: Solve the given problems with complete solution. Calculate the Gibbs Free-Energy and the standard Gi...

A: we are required to find the Gibbs free energy and standard Gibbs free energy for the given cell reac...

Q: H3C. CH3 CH3 H,C CH3

A: The IUPAC name of the given compound is:

Q: 7. What happens to the average kinetic energy of the substance in Region II of the cooling curve? Re...

A: 1) we know kinetic energy is directly proportional to the temperature. In the given graph the region...

Q: SOLVE ME! 1. Determine S for the reaction: SO:(g) H20(1) → H2SO4(1) Given: S°(J/K.mol): 256.2 69.9 1...

A:

Q: Which of the following would be made from an alcohol by a dehydration reaction? A) alkane B) alken...

A: Alcohol contains -OH group and dehydration of alcohol means removal of water. 

Q: Sodium chloride, silver nitrate, lead (1I) nitrate, zinc sulfate, and magnesium chromate were dissol...

A:

Q: A1 liter solution is made by adding 0.8603 moles NaH2PO4 and 0.4973 moles Na2HPO4. What will be the ...

A: Given, NaH2PO4 = 0.8603 mol Na2HPO4 = 0.4973 mol [HCl] = 6.0287 M VHCl = 1.5857 mL = 0.0015857 L    

Q: 6 Synthesize the following molecule from methane, ethane or benzene

A: This is a multi step synthesis reaction . Detail synthetic scheme is shown below

Q: Which is true of bond formation and bond breaking in a polar reaction? Select the correct response: ...

A:

Q: III. Fill up the numbered spaces (only) in the table below. You may type or manually write/ draw you...

A: Fill up the numbered spaces (only) in the table below. You may type or manually write/ draw your ans...

Q: Which of the following alkenes will produce only one product on hydration? A) 4-octene B) 3-hepten...

A: Alkanes reacts with water in acidic medium gives alcohol.

Q: Which of the carbocations will react the fastest in the electrophilic addition of ncl to alkenes? Se...

A: On addition of HCl to alkenes, carbocation intermediate is formed. More stable the carbocation inter...

Q: 4. Given the following reaction, calculate AH°, AS°, and AG°. (25°C) 2P (s) 10 HF (g) → 2 PFs(g) + 5...

A:

Q: A. Classify the following hypothetical molecules as polar or non-polar. Note: Number 5 item is not a...

A: Given :  Number of valence electrons in D = 4  Number of valence electrons in E = 7 

Q: INCREASING reactivity

A:

Q: 1. Write the balanced equation for the bromination of 4-methylbenzoic acid.

A:

Q: 300.0 mL of a 0.385 M solution of NaI is diluted to 700.0 mL. What is the new concentration of the s...

A: Given,  300.0 mL of a 0.385 M solution of NaI is diluted to 700.0 mL. The new concentration of the s...

Q: What is the pOH of a 0.0056 M Ba(OH)2 solution

A:

Q: What will be the mass of Sodium carbonate (MW = 106.0 g/mol) in a sample solution if this salt is ti...

A:

Q: Draw Diene + Draw Dienophile

A:

Q: Consider the reaction. 2 Fe, O, 4 Fe + 30, = +824.2 kJ The formation of 84.0 g of Fe results in O th...

A: Recall the given reaction,  2 Fe2O3 ------>  4 Fe  +  3 O2           ∆Hrxn = + 824.2 KJ We have t...

Q: If the legal minimum acetic acid content in vinegar is 1.50M, which of the two vinegar enthusiasts- ...

A:  % purity of KHP = 99.4 mass of KHP used = 0.540 g Volume of KOH required for standardization titrat...

Q: Five modern United States pennies are measured three times each on a balance, and their measured mas...

A: Since you have asked multiple questions, we will solve the first question for you. If you want any s...

Q: Write the rate law for the two elementary reaction equations. 2 A(g)+B(g) –→ C(g)+D(g) rate = k X(g)...

A: Given:-   For Elementary reaction:- •Rate  is equal to product of rate constant with product of con...

Q: Name the molecule

A:

Q: Indicate the surface charge on Fe(OH)3 sol particles at each of the following conditions. At pH 13, ...

A: In this question we have to tell the surface charges on Fe(OH)3 sol particles in different pH condit...

Q: Of the following structures, which are likely to absorb visible light when treated with aqueous base...

A:

Q: CH3 CH3 F Br A. B. B. C. C. 9. 10. ÇI Č2H5 ČI A. A. B. B. C. C.

A: Rules for IUPAC Nomenclature : 1.Selection of the longest carbon chain which is called parent chain....

Q: Please don't copy what causes electrons in an atom to emit energy after absorbing it? becoming elec...

A:

Q: H,ö: I II (-H*) •. : ОН III НО IV .. A) I B) I C)II D) IV

A: Electrophile are electron loving species i.e. positively charged species and Nucleophile are nucleou...

Q: At the pressure of 2.98 atm, the enthalpy of fusion is 3.59 kJ/mol at freezing point 229.46 K and en...

A: Given that, The pressure is P = 2.98 atm, The enthalpy of fusion is ∆Hfus = 3.59 kJ/mol, The freezin...

Q: 5. Calculate the molality of a sulfuric acid solution containing 24.4 g sulfuric acid in 198 g water...

A: Given - - > Mass of sulphuric acid = 24.4 g Molar mass of sulphuric acid = 98.079 g/mol Mass of s...