A capacitor of capacitance ((10^-4) /m) F, an inductor of inductance (2/m) H and a resistor of resistance 100 Q are connected to form a series RLC circuit. When an AC supply of 220 V, 50 Hz is applied to the circuit. Determine the power factor in the circuit.

A capacitor of capacitance ((10^-4) /m) F, an inductor of inductance (2/m) H and a resistor of resistance 100 Q are connected to form a series RLC circuit. When an AC supply of 220 V, 50 Hz is applied to the circuit. Determine the power factor in the circuit.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: Find the value of C, in μF, if the energy stored in the capacitor in Fig.P6.28 equals the energy…

A: We need to find out the value of capacitance for given circuit .

Q: A forward biased PN junction diode has the. and the condition increases _connected to the positive…

Q: Given the following circuit, find the Thevenin equivalent circuit. 5 mA 4 ΚΩ Vx 2V, -+ 2 ΚΩ 6 ΚΩ 2…

Q: 10. Determine the power density on an earth station from a 5-W satellite source. That is 22,000 mi…

A: Given data, Power is given P=5 W. Distance is given, r=22000 mile,=22000×1609.4,=35405568 m.

Q: In a series L-C circuit, the inductance and capacitance are 5 H and 2 μF respectively. of the…

Q: please where did the root 3 value come from

Q: Problem 12. A current of 5 A flows in the winding of an electric motor, the resistance of the…

A: Given: Current flowing in winding, I=5 A. Resistance of the winding, R=100 Ω.

Q: In the figure the current in resistance 6 is ig=1.47 A and the resistances are R₁ = R₂=R3-2.470. R4…

A: The required emf can be calculated by using the total resistance of the circuit and the total…

Q: Consider the joint PDF: fx,y (x, y) = (1/15 0≤x≤5,0 ≤ y ≤ 3 otherwise. Find the probability that Y…

A: given here PDF and asked to find the Probability that y>ax where a=2.

Q: (4) Find the current passing through each diode and Vo. Assume ideal diodes. Κ 5ΚΩ -10V 10V 5ΚΩ Vol

A: In this question We need to determine the current in the each diode and also determine the voltage…

Q: Determine the variables indicated with a ? Assume all diodes are ideal. 10V 3K Vo=? DZ 2K (a) 1K D₂…

A: We need to find out voltage for given diode circuit .

Q: For the circuit shown find the impedance phase angle Z (in degrees) i= 0.02 sin(157t+40) 17 2517…

A: Given data, Circuit diagram is given as,

Q: 1.27 Reduce the block diagram in Figure 1.22a to the standard form shown in Figure 1.20b and to a…

Q: A three phase 16 pole wye connected alternator has 9 slots/pole. It employs a full-pitch two-layer…

Q: 2. Determine the even and odd parts of the given CT signal y(t) and DT signal z[n]. 2, y(t) = =…

A: Given: Signals y(t) and z(n) as, To find: Even and odd parts of the signals y(t) and z(n).

Q: A conveyor motor has a N.O. START button (I:0/3) and a N.C. STOP button (I:0/4) to start and run the…

A: To draw the program rungs for given operation

Q: Problem 3 Find the Norton equivalent circuit for the circuit below at the terminal a-b.

A: The Norton's equivalent circuit can be obtained by calculating the short circuit current and the…

Q: A unity negative feedback system has an open loop transfer function k s(s+10) for the system to have…

A: Given : The open loop transfer function is given as, Gs=kss+10. Value of damping ratio ξ=0.25.

Q: The current in the inductor changed from 0 mA to a current of I = 141 mA in a time of t=9 ms and…

Q: At inversion, the surface pf an NMOS transistor is ??

A: To find At inversion, the surface pf an NMOS transistor is? A positive voltage given at the gate of…

Q: 7. 1 ΚΩ Given the following circuit, find Io. Must use Norton's Theorem. 5V (+ 1.5ΚΩ www 1mA (1) 1.5…

Q: 6. Determine the output voltage V, of the summing op-amp shown

A: The output of the given circuit can be calculated by finding the stage 1 output and then the total…

Q: For FSK, If the bit rate is fb, the Baud rate is equal to:: Select one: a. fb/2 b. fb/3 c. fb/4 d.…

A: In this question We need to choose the correct option What is baud rate if bit rate is fb

Q: If the forward voltage drop on a diode is 774 mV, what is the current passing through it? Assume I s…

Q: Now consider the following continuous-time system with input and output specified sepa- rately,…

A: The given problem has been solved as follows

Q: Q1: What is the value of the unknown resistor R in figure shown, if the voltage drop across the 500…

Q: 4. State whether or not these signals are periodic. If they are periodic, give their fundamental…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: What should Zy be to transfer the maximum active power from the source? Please use Thevenin method

Q: سدهه ± 10 k AR₂ чол 7 50v Calculate the Max- power deliver to RL.

Q: Determine the peak forward current through each diode in Figure +30 V Vin OV -30 V (a) ww 2.2 ΚΩ 12…

A: In this question We need to determine the peak forward current through each diodes. Assume both…

Q: Using a d.c. voltmeter and a.c. voltmeter to measure the output filter of a power supply, the obtain…

A: Given data, Output voltage measured by DC voltmeter VO-dc=25 V. Output voltage measured by AC…

Q: In the circuit of Fig. 7.101, find the value of Red for which the steady-state energy stored in the…

A: It is given that:

Q: The voltage across a capacitor with the value C = 4 F is given by the waveform in Fig.P6.10. Find…

Q: In the following circuit, vs(t) = a + bu(t) V, R = 5 N, L = 3 H, C = 2 F Given that, a = 9 V and b =…

A: We need to find out Voltage across inductor in the given circuit .

Q: 6. Which of the following is not a type of signal is... a. analog signal b. Chain signal c. Binary…

A: Signals It is the function of one or more than one type of independent variable, which provides…

Q: A round balloon of radius r=0.1 m has an electric charge Q=0.001 C distributed evenly over its…

A: it us asked to find surface charge density

Q: 8. Given the following circuit, find the Norton equivalent circuit. 4 ΚΩ 10 V +1 21x Ix 5 kn RL

Q: PSA: Given the following: y(n)=x[n]-x(n-1) 1. What kind of FIR filter is this? 2. Write the correct…

Q: Draw the Bode plot for the following:

A: In this question We need to determine the bode plot. We are solving this problem using the…

Q: Learning Goal: To analyze an RC circuit to determine the initial voltage across a capacitor, then to…

Q: 10/⁰ VRMS ΦΩ j3Ω 8000 -4 Ω

Q: The current in the circuit in (Figure 1) is known to be io 50e 8000 (cos 6000t + 2 sin 6000t) mA =…

A: Answer : given that resistance R = 360 ohms current io = 50e-8000t(cos6000t+2 sin6000t) mA to find…

Q: (2) Derive the Laplace transform for the following time functions: (a) tu(t) (b) t'u(t) (c) e…

A: Given, a) tu(t) b) t3u(t) c) e-atcosωtut

Q: 1. B D BI Ya Y=A+B • HW: Show the logic arrangements for implementing: 2. a NOT circuit using a…

Q: Which statement best describes the motion of electrons in a 1 amp current. They travel less than…

Q: The switch in the circuit in (Figure 1) has been closed for a long time and opens at t = 0. V = 130…

Q: For the system represented in the block diagram of figure 3, obtain the function of closed-loop…

A: It is asked to find the closed loop transfer function and time parameters etc., for given control…

Q: For this assignment you will be designing a power supply circuit for windshield heating element and…

A: According to the question, we need to design a power supply circuit for windshield heating element…

Q: vi(t)u(t) + R L R C vo(t) See the dynamic RLC circuit shown above. It has a time dependent input of…

Q: An RLC-serial resonance circuit can be used as a band-pass filter. Find out how the filter works.…

Question

A capacitor of capacitance ((10^-4) /m) F, an inductor of inductance (2/m) H and a resistor
of resistance 100 Q are connected to form a series RLC circuit. When an AC supply of
220 V, 50 Hz is applied to the circuit. Determine the power factor in the circuit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in parallel, and the combination is supplied from a sinusoidal voltage source. The power factor of the combination is ?
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A 10.0-μF capacitor and a 2.00-H inductor are connected in series with a 60.0-Hz source whose rms output is 100 V. Finda. the rms current in the circuit.b. the voltage drop across the inductor. c. the voltage drop across the capacitor.
Problem Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V dc voltage source.
a) The voltage across a 20uF capacitance is v. = 50 sin( at - 80) volts and Frequency equal to 100 Hz. Determine the current through the capacitor i and sketch its waveform. b) Define phasor