A 500 nm laser shines through a double slit with a separation of d=0.2 mm. The light that emerges shines on a screen that is 0.8 maway.a. What is the y-position of the fifth maximum, y5 ?b. We change the double slit to a diffraction grating of 300lines/mm. What is the new y-position of the fifth maximum,V5 ?

The wavelength of the laser shines is λ = 500 nm The separation of the double-slit is d = 0.2 mm…

A 500 nm laser shines through a double slit with a sepa =0.2 mm. The light that emerges shines on a screen tha away. a. What is the y-position of the fifth maximum, y5 ? b. We change the double slit to a diffraction grating

A 500 nm laser shines through a double slit with a sepa =0.2 mm. The light that emerges shines on a screen tha away. a. What is the y-position of the fifth maximum, y5 ? b. We change the double slit to a diffraction grating

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter3: Interference

Section: Chapter Questions

Problem 63AP: A hydrogen gas discharge lamp emits visible light at four wavelengths, =410 , 434, 486, and 656 nm....

See similar textbooks

Similar questions

A hydrogen gas discharge lamp emits visible light at four wavelengths, =410 , 434, 486, and 656 nm. (a) If light from this lamp falls on a N slits separated by 0.025 mm, how far from the central maximum are the third maxima when viewed on a screen 2.0 m from the slits? (b) By what distance are the second and third maxima separated for l=486 nm?
(a) What is the minimum angular spread of a 633-nm wavelength He-Ne laser beam that is originally 1.00 mm in diameter? (b) If this laser is aimed at a mountain cliff 15.0 km away, how big will the illuminated spot be? (c) How big a spot would be illuminated on the Moon, neglecting atmospheric effects? (This might be done to hit a corner reflector to measure the round-trip time and, hence, distance.) Explicitly show how you follow the steps in Problem-Solving Strategies for Wave Optics.
In the double-slit arrangement of Figure P36.13, d = 0.150 mm, L = 140 cm, = 643 nm. and y = 1.80 cm. (a) What is the path difference for the rays from the two slits arriving at P? (b) Express this path difference in terms of . (c) Does P correspond to a maximum, a minimum, or an intermediate condition? Give evidence for your answer. Figure P36.13
Figure P36.53 shows two thin glass plates separated by a wire with a square cross section of side length w, forming an air wedge between the plates. What is the edge length w of the wire if 42 dark fringes are observed from above when 589-nm light strikes the wedge at normal incidence? FIGURE P36.53
A laser beam with wavelength λ = 675 nm hits a grating with n = 4750 grooves per centimeter. A. Calculate the grating spacing, d, in centimeters. B. Find the sin of the angle, θ2, at which the 2nd order maximum will be observed, in terms of d and λ. C. Calculate the numerical value of θ2 in degrees.
Problem 2. A) A Michelson interferometer uses light of wavelength 500 nm. The irradiance of the beam exiting the laser is IL. What are the possible differences in the lengths of the arms of the interferometer when the irradiance at the detector is IL/3? B) Young's Double slit experiment is performed with HeNe laser wavelength 632.8 nm. The screen is 2 m from the slits and the slit separation is 0.2 mm. Find the distance of the 3th bright fringe from the center of the interference pattern on the screen (call the central bright fringe the "Oth" fringe).
The lens of a camera has a thin film coating designed to enhance the ability of the lens to absorb visible light near the middle of the spectrum, specifically light of wavelength 560 nm. If nair = 1.00, nfilmcoating %3D 1.40, and njens 1.55, what is the required minimum thickness of the film coating? Assume that the light is normally incident in the air medium. a. 200 nm O b.250 nm O c. 100 nm O d. 150 nm e. 300 nm
A thin film of polystyrene n=1.49 coats a piece of glass n=1.55. When illuminated from above, the dominant color of the light reflected to the observer is 473 nanometers wich is blue. What is the minimum thickness of the thin film? A. 317 nm B. 153 nm C. 159 nm D. 305 nm E. 79.4 nm
Light with wavelength i passes through a narrow slit of width w and is seen on a screen which is located at a distance D in front of the slit. The first minimum of the diffraction pattern is at distance d from the middle of the central maximum. Calculate the wavelength of light if D=2.5 VAD. Give your answer in nanometprs. m, d=1 mm and w = Answer: Choose...
Monochromatic light of wavelength 4300 A.U. falls on slit of width a. For what value of a, the first maximum falls at 30°?
350 nm of light falls on a single slit of width 0.20 mm. What is the angular width of the central diffraction peak?
1. a. If a piece of glass (n = 1.5) is coated with a transparent plastic (n = 2.0), will there be a phase shift in either of the beams reflecting off the interfaces (air/plastic and plastic/glass)? How can you tell, without doing the experiment, whether or not there will be a phase shift in either beam? Be specific about what rays are reflecting off what materials. b. So what thickness or thicknesses give the maximum reflection? What thickness or thicknesses (hint: it's thicknesses) give the minimum reflection? Assume that a light of wavelength 500. nm is used, and you may leave the answer in nm. Yes, this is a choice between equations 35.17 and 35.18, but your answer to part a should be helpful in deciding which set.