A 5.0 mH inductor and a 10.0 resistor are connected in series with a 6.0 V ideal battery and a switch. (a) Immediately after the switch is closed what is the voltage across and current in the resistor? (b) Immediately after the switch is closed what is the voltage across and current in the inductor? (c) How long will it take to reach 75.0% of the maximum current in the

A 5.0 mH inductor and a 10.0 resistor are connected in series with a 6.0 V ideal battery and a switch. (a) Immediately after the switch is closed what is the voltage across and current in the resistor? (b) Immediately after the switch is closed what is the voltage across and current in the inductor? (c) How long will it take to reach 75.0% of the maximum current in the

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 52P: In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b)...

See similar textbooks

Similar questions

When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?
An inductor is connected across the terminals of a battery. Does the current stance of the battery? Does the time required for the current to reach its final value depend on this resistance?
In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b) the initial current through the resistor, (C) the final current through the resistor, (d) the current through the resistor when t=2L , and (e) the voltages across the inductor and the resistor when t=2L .
Check Your Understanding. A changing current induces an emf of 10 V across a 0.25-H inductor. What is the rate at which the current is changing?
In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
A step-up transformer is designed so that the output of its secondary winding is 2000 V(rms) when the primary winding is connected to a 110-V (rms) line voltage, (a) If there are 100 turns in the primary winding, how many turns are there in the secondary winding? (b) If a resistor connected across the secondary winding draws an rms current of 0.75 A. what is the current in die primary winding?
Check Your Understanding Find the voltages across the resistor, the capacitor, and the inductor in the circuit of Figure 15.11using v(t)=v0sint asthe output of the ac generator.
Check Your Understanding (a) Calculate the self-inductance of a solenoid that is tightly wound with wire of diameter 0.10 cm, has a cross-sectional area of 0.90 cm2, and is 40 cm long. (b) If the current through the solenoid decreases uniformly from 10 to 0 A in 0.10 s, what is the emf induced between the ends of the solenoid?
Does the time required for the current in an RL circuit to reach any fraction of its steady-state value depend on the emf of the battery?