A 0.064 kg of octane vapor (MW=114) is mixed with 0.91 kg of air (MW=29) in the manifold of an engine. The total pressure in the manifold is 86.1 kPa, and a temperature is 290K. Assume octane behaves ideally. What is the partial pressure of the air in the mixture in kPa?

A 0.064 kg of octane vapor (MW=114) is mixed with 0.91 kg of air (MW=29) in the manifold of an engine. The total pressure in the manifold is 86.1 kPa, and a temperature is 290K. Assume octane behaves ideally. What is the partial pressure of the air in the mixture in kPa?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 0.064 kg of octane vapor (MW=114) is mixed with 0.91 kg of air (MW=29) in the manifold of an engine. The total pressure in the manifold is 86.1 kPa, and a temperature is 290K. Assume octane behaves ideally. What is the partial pressure of the air in the mixture in kPa?
RP-1 is highly refined form of kerosene used for many first stage rocket engines. The average composition of it is indicated by CH1.9 a. What is the stoichiometric mixture ratio (MR) for RP-1 and oxygen? b. Now, you have a mixture of air and RP-1 with three times more air (in terms of moles) than is needed to burn all the fuel. How high is the final temperature? The heats of formation are given in the table below. In molar quantities, assume 1 mole of air is (O2+3.76N2). The reactants have a temperature of 25°C before combustion. You may use the average values of the specific heats for each constituent. C. Would the adiabatic flame temperature be lower or higher for a rocket engine that uses pure oxygen instead of air? Explain. Constituent Qf kJ/kmol @ 298 K Cp kJ/kmol K CH19 9,358 CO2 (g) -393,522 51.9 O2 (g) 0 34.0 N2 (g) 0 31.6 H₂0 (g) -241.827 40.6
In a certain engine, the partial pressure of NO.1 gas was 12 pa. If the total pressure in the engine is 8300 pa, calculate the mixing ratio of .NO in ppmv 1400 O 1445 O 1554 O 1200 O
Determine quality of the mixture
15. The partial pressures of a mixture of gases are 20 kPa (N2), 60 kPa (O2), and 80 kPa (CO2). If 20 kg of the mixture is inside a tank at 60°C and 300 kPa, find the volume of the tank.
In a heat exchanger two stream of water mix to each other at 300 kPa constant pressure. The cold stream is at 30°C and the hot stream is at 120°C. Mass flow rate of cold stream is 3 kg/s, and the control volume loses heat to the surrounding air at 30°C at a rate of 1800 kJ/min. If the mixture leaves the mixing chamber at 75°C.
6. As shown in Figure 3, two flasks are connected by initially closed stopcock. One flash contains krypton gas at 500 Krypton Helium mmHg, while the other contains helium at 950 mmHg. The 250 cm. 500 mmHg 450 cm 950 mmHg stopcock is now opened so that the gasses mix. What is the final pressure in the system? Assume constant temperature. NB: 2 out of 6 six questions will be on your Midterm Exam. 2/2
A 0.14lbm (0.064 kg) of octane vapor (MW = 114) is mixed with 2.0 lbm (0.91kg) of air (MW = 29) in the manifold of an engine. The total pressure in the manifold is 12.5 psia (86.1 kPa) and the volume in the tank is 920 liters. Assume octane behaves ideally, Determine the temperature in the tank in Kelvin.
An engine operates on methanol with an equivalence ratio of 0.9. The air and fuel enter the engine at 298 K, and the exhaust is at 527 °C. The heat rejected to the coolant is 340 MJ/kmol fuel. (a) What is the enthalpy of the exhaust combustion products in kJ/kg.fuel? (b) What is the specific work output of the engine in kJ/kg.fuel? (c) What is the thermal efficiency of the engine?
QUESTION 14 Determine the type of steam, given: Temperature: 87°C Entropy: 6 kJ/kg.K O Superheated Vapor O Wet Vapor O Subcooled Liquid O Saturated Vapor
4. A petrol engine develops 50 kW brake power. The fuel and air flow rates are 10 kg and 107 kg/hr. The temperature of fuel air mixture entering the engine is 200C and temperature of gases leaving the engine is 5000C. The heat transfer rate from the engine to the cooling water circulated is 50kJ/s and that to the surroundings 10 kJ/s. Evaluate the increase in the specific enthalpy of the mixture as it flows through the engine.
Q NO1: A mixture (i.e., thermodynamic system) of 0.182 kg of helium (He) and 0.091 kg ofoxygen (O2) is compressed polytropically (PVn = const.) in a piston-cylinder devicefrom 101.352 kPa and 15.56C to 413.69 kPa according to n = 1.4. Determine for theprocess: (a) the final temperature, (b) the work done, and (c) the heat energy.Clearly mention whether the work is done on or by the mixture, and whether the heatis supplied to or rejected by the mixture to the surroundings.Take the specific heat capacity at constant volume, cv for He = 3.119 kJ/(kg·K) andfor O2 = 0.659 kJ/(kg·K), and the value of gas constant R for He = 2.0769 kJ/(kg·K)and for O2 = 0.2598 kJ/(kg·K).Draw the schematic of piston-cylinder device and display the process on a hypothetical indicator diagram for the process.