7. Determine the hexadecimal equivalent of the following Ethernet address: 01011010 00010001 01010101 00011000 10101010 00001111 A. 5A:11:55:18:AA:0F В. OF:AA:18:55:11:5A C. A5:11:55:81:AA:F0 D. 5A:88:AA:11:55:F0

7. Determine the hexadecimal equivalent of the following Ethernet address: 01011010 00010001 01010101 00011000 10101010 00001111 A. 5A:11:55:18:AA:0F В. OF:AA:18:55:11:5A C. A5:11:55:81:AA:F0 D. 5A:88:AA:11:55:F0

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 3VE

See similar textbooks

Related questions

Q: Ethernet implements the Frame Check Sequence (FCS) using a technique called Cylic Redundancy Check…

Q: 3. The following character encoding is used in a data link protocol: A: 01000111; B: 11100011; FLAG:…

A: The transmitted for four-character frame is given below: A B ESC FLAG (01000111 11100011 11100000…

Q: If R2 OXA902 8470 and R3 = -160, what effective address is generated by the ins uction LDR RO, [R2,…

A: Solution Here, the effective address is = R2 + (R3 << 1) Now, R2 = 0xB903 8471 (given)…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A: Given :- The figure below shows synchronous TDM, the data rate for each input connection is I Mops.…

Q: Fill in the gap In 802.11 architecture, access points periodically send beacon frames. Each of them…

A: In IEEE 802.11 WLAN's consist of management frame called as Beacon frame These frames consist of…

Q: Suppose a switch is built using a computer workstation and that it can forward packets at a rate of…

A: given bandwidth of main memory is 2 Gbps I/O bus is used to access the memory. I/O bus speed is…

Q: Use suitable serial communication protocols between 1 Master and 3 Slaves (Slave 1 address=0110…

A: Use suitable serial communication protocols between 1 Master and 3 Slaves (Slave 1 address=0110…

Q: Consider the switch shown below. Suppose that all datagrams have the same fixed length and that the…

A: The switch fabric is a crossbar so that at most one datagram can be transferred to a given output in…

Q: What is the range of addresses for jump and jump and link in MIPS (M 1024K)?1. Addresses between 0…

A: A jump instruction, like "jmp", just switches the CPU to execute a different piece of code within a…

Q: Computer networking Consider an ethernet with length of the cable is 1800 meter and speed of the…

A: Length of the cable = 1800 meter Speed of the signal = 3x10^8 m/s Propagation Time (Tp) = Length /…

Q: Explain Difference between Circuit Switching, and Packet Switching. And also what are the advantages…

A: I have provided the answer in step 2.

Q: 3. Token-Ring because it currently can run at both 4Mbps and 16Mbps. This means that it can be used…

A: given data Token-Ring because it currently can run at both 4Mbps and 16Mbps. This means that it can…

Q: A serial transmission T1 uses 8 information bits, 2 start bits, 1 stop bit and 1 parity bit for each…

A: Introduction serial transmission T1 info bits 8 Start bit 2 Stop bot 1 Parity bit 1 synchronous…

Q: Design a bus network which consists of 2 routers. Attach 3 PC's and a Server with router 1 switch.…

A: 1) A bus network is a course of action in a neighborhood (LAN) in which every hub (workstation or…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

Q: Your answer includes number only, thousands should be separated by a For example: 1,000 or 1,000,000…

A: GIVEN : Distance( satellite ,earth) = 36,000 km [As , 1 km = 103 meters] Distance between…

Q: C. Convert the prefix notion for a subnet mask to the dotted-decimal format. Then use the AND…

A: Classless Addressing: Classless Addressing is denoted in the form of W.X.Y.Z/n where W, X, Y, Z…

Q: MAC address of a device is represented using Hexadecimal number. A section of MAC address is given…

A: Mac Address section taken as: 031(Hex) We have to convert this to binary. Hex: 031 Binary: 110001…

Q: d (b) assume there is a s ply calculate the averag 0-Mbps Ethernet throu- ritches as in Exorciso 16

A: (a) The effective bandwidth is 100 Mbps, so that the sender can send data steadily at this rate and…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

Q: Suppose a switch is built using a computer workstation and that it can forward packets at a rate of…

A: Below is the answer with calculation:

Q: A serial transmission T1 uses 8 information bits, 2 start bits, 1 stop bit and l parity bit for each…

A: Introduction :We have given two transmission T1, T2 where T1 is a serial transmissionAnd T2 is a…

Q: What is the total delay (latency) for a frame of size 78 million bits that is being sent on a same…

A: Given, Frame of size = 78 million bits = 78 × 106bits = 78000000 bits Queuing time = 83 μs = 83×…

Q: 19 10 Mbps half-duplex ethernet network consists of two segments connected by a repeater. It…

A: According to collision detection in half duplex ethernet. Tt >= 2* TP Here we have given the…

Q: A Go-Back-N (GBN) ARQ scheme has been designed with window-size W = 10 such that it is fully…

A: Given that, In Go-Back-N ARQ scheme, Window size w= 10 Frame size= 20,000 bits There are no errors…

Q: Assume for dealing with errors sender and receiver computers are using the CRC algorithm. If data…

A: Here in this question we have given Data bits - 10111001 Divisor - 1001 And we have to find out the…

Q: II. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A: Solution:-

Q: Assume we have a memory with access time of 10 nanoseconds. The memory is accessed as 4-byte words.…

A: General guidance The answer provided below has been developed in a clear step by step manner. First…

Q: All links in the path between source and destination have a transmission rate of 10 Mbps. Assume…

Q: QUESTION 28 If four 4-kbps connections are multiplexed together using synchronous TDM. Fim 1. The…

A: Introduction

Q: The most common Ethernet connection for terminating twisted-pair wires is called a) RJ11 b) RJ45…

A: Task :- Choose the correct option for given question.

Q: Assume a 1 Mbps shared connection (for example, an Ethernet bus). How long does it take to send a…

A: Introduction: The all-encompassing Ethernet LAN protocol has now been thoroughly examined. Today's…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

Q: 88-B2-2F

A: Draw a fully populated ARP table (all required entries) at host A Draw a fully populated ARP table…

Q: Using the longest prefix matching scheme, determine what link interface the destination address of…

A: The given DA is : 11001000 00010111 00010110 10100001

Q: Find the interface identifier if the physical address in the EUI is FC-AB-00-FE-00-AA-FF-FE16 using…

A: HEX: FCAB00FE00AAFFFEBIN: 1111 1100 1010 1011 0000 0000 1111 1110 0000 0000 1010 1010 1111 1111 1111…

Q: Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During…

A: Circuit Switching:- In circuit-switched networks, the resources needed along a path(buffers, link…

Q: Do research on the following protocols: Can Bus protocol SPI I2C USB and draw the transmission…

Q: 52. This is ordinary telephone twisted pair wire, one of several physical media specified in the…

A: In this answer I will be discussing about different telephone twisted pair wire.

Q: A source computer is connected to a destination computer through one router (R1). The throughput of…

A: The answer to the following question:-

Q: 16. A frame is a PDU of layer: 04 02 03 07

A: Let us see the answer below,

Q: What is the channel capacity for a communication channel with a bandwidth of 1 MHz, 1 W transmitted…

A: Find the required answer with calculation given as below :

Q: 1.Explain the architecture of IEEE 802.11 Wireless LAN. Briefly explain the various variants and…

A: 1.Wireless LANs are those Local Area Networks that use current high frequency radio waves instead of…

Q: ________________ is a bit-oriented protocol for communication over point-to-point and multi-point…

A: Given:- 40. _________________ is a bit-oriented protocol for communication over point-to-point…

Q: Assume that a channel occupies a bandwidth of 110 kHz. We need to combine eleven channels into a…

A: Solution :

Q: Suppose you are designing a sliding window protocol for a 1-Mbps point-to-point link to a stationary…

Q: Suppose we get a message throughout the network using a 56,000 bits per second modem. Also suppose…

A: The most common encoding is 8N1, which means 10 symbols are sent per 1 byte of the message. The baud…

Q: How big would the window size have to be for the channel utilization to be greater than 98 percent…

A: As given:- The transmission rate of the link (R) = 1Gbps = 109 bits/sec. The round-trip…

Concept explainers

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.

Question

7. Determine the hexadecimal equivalent of the following Ethernet address:
01011010 00010001 01010101 00011000 10101010 00001111
A. 5A:11:55:18:AA:0F
В. OF:AA:18:55:11:5A
C. A5:11:55:81:AA:F0
D. 5A:88:AA:11:55:F0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Explain how these addresses are being sent to a receiver on the Ethernet cable. Use arrow to for the flow of the stream of bits. 1. 4A : FF : 8B : 90: AD: E6 2. FD: AC:49 : 9E : CE : 3B
Sketch the Bipolar NRZ Voltage encoding on a classic Ethernet for the bit stream0001110101.
Computer Science Question 3 part b) For the Ethernet destination address 06:01:02:03:05:04 b) Show how the address is transmitted through a channel
III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1 bit at a time is multiplexed, Find (a) the input bit duration, (b) the output bit duration, (c) the output bit rate, and (d) the output frame rate. ... 1 1 1 1 1 1 Mbps 0 0 0 0 0 1 Mbps Frames 01010001110100010101 ... MUX 1 0 1 0 1 1 Mbps *** 0 0 1 0 0 1 Mbps
Computer Science 1. How fast can a 46-byte block of data be transmitted on a 10 Mbps Ethernet packet and a 16Mbps Token Ring packet? 2. If you have an operating frequency of 750 MHz, what length of a pair f conductors is considered to be a transmission line?
28 A paging scheme uses a TLB. A TLB access takes 10ns and main memory access takes 50ns. What is the effective access time (in ns) if the TLB hit ratio is 90%? 50 65 70 55
Suppose you are designing a sliding window protocol for a 2Mbps point to point link to the moon, which has a one way latency of 10 sec. Assume that, each frame carries 1KB of data, what is the minimum number of bits you need for the sequence number?
How many bits are needed for the alternating bit protocol?
Suppose that we are sending a 30 Mb MP3 file from a source host to a destination host. All links in the path between source and destination have a transmission rate of 10 Mbps. Assume that the propagation speed is 2 × 108 meters/sec, and the distance between source and destination is 10,000 km. 1. Now suppose there is only one link between source and destination, and there are 10 FDM channels in the link. The MP3 file is sent over one of the channels. What is the end-to-end delay?
A serial transmission T1 uses 8 information bits, 2 start bits, 1 stop bit and 1 parity bit for each character. A synchronous transmission T2 uses 3 eight-bit sync characters followed by 30 eight bit information characters. If the bit rate is 1200 bits/second in both cases, what are the transfer rates of T1 and T2?
In asynchronous serial communication the physical layer provides
For the 12C transmission below by the Master, determine the Slave address and whether or not it is a read or write operation and whether there is an acknowledge bit sent. the numbering shows the clock cycles. SDA SCL O Ox57, Read, ACK OXEA, Write, ACK OXEA,Write, NACK O Ox75, Write, ACK