how to obtain   opeerating line from component balance and boil up ratio

Q: The molar heat capacity of liquid iron exceeds that of iron vapor by 2.522 calories/K, the molar…

A: It is given that:temperature, T molar heat of evaporation of liquid iron, vapor pressure of liquid…

Q: 1. A substrate solution of 0.1 kmol m³ is reacted in a stirred-batch reactor using the free enzyme.…

A:

Q: 6-Oxygen gas is contained in a piston cylinder arrangement as in Fig.(1-6), the piston mass is 60 kg…

A: Given,

Q: a - [1 + m (1-√T₁)]² = R A stream of propane at temperature T = 423 K and pressure p (atm) flows at…

A: It is given that:temperature,,flow rate, pressure, critical temperature, critical pressure,accentric…

Q: Saccharomyces cerevisiae grows with a doubling time 2.4 h in the exponential growth phase. Calculate…

A: Saccharomyces cerevisiae is a species of yeast, commonly known as baker's yeast or brewer's yeast.…

Q: Wheat starch production process E.g. Wheat bran Rail Car Delivered Wheat Silo Storage Flour Mill…

A: For slurry tank,For washing and filtration tank,For steam jet cooker,

Q: Q6: A fuel gas consisting of 90 mol % methane and 10 mol % nitrogen is burned with 25% excess air in…

A: GivenIn mixtureMethane=96% of feedExcess air=40%Water flow rate=35kg/sWater heated from 25C to…

Q: 2H4O) is produced by catalytic oxidation of E (C2H4) but competes with an undesired combustion…

A: The reactions are given as: The molar flow rate of ethylene in the fresh feed entering the reactor…

Q: Table Q4 shows the solubility of liquid trichlorohexane in toluene (also liquid) at equilibrium at…

A: A binary mixture of liquid trichlorobenzene and toluene is given.Pressure, ,Also a table with…

Q: Describe the basics of fluid flow and mixing,chemical reactors and process control.

A: detailed description of the basics of fluid flow and mixing, chemical reactors, and process control…

Q: In stoichiometric zirconia ZrO2 the Schottky defects are the predominant equilibrium point defects.…

A: The given information is: is added to, to stabilize its high-temperature phase. This addition only…

Q: In the following two problems a continuous stream temperature To and pressure To, reacts there, and…

A:

Q: Q1. The liquid-level process shown in Figure below is operating at steady state of 10 cfm when the…

A: It is given that,the flow rate of liquid, ,at time, , the flow rate of liquid (unit step),at ,  of…

Q: Exercises: 1) A rigid tank contains 50 kg of saturated liquid water at 90°C. Determine the pressure…

A: Amount of saturated liquid in tank = 50 KgTemperature of saturated liquid = 90oC

Q: Iron oxide, FeO(s) (mol mass 71.85 g/mol and specific mass 2.5g/cm3) is reduced to metallic iron,…

A: The question asks us to think of a chemical process that uses hydrogen gas to convert iron oxide to…

Q: Table B.2: Constants for the Antoine Equation for Vapor Pressures of Pure Species B t/°C + C Latent…

A: Assuming the parameters calculated in the previous solution is correct.First we will plot the P-x…

Q: A heat engine receives 500 BTU of heat per cycle from a reservoir at 540oF and rejects heat to a…

A: The way a heat engine works is that it takes heat from a source, or high-temperature reservoir, and…

Q: P3-15, The gas-phase reaction N, * Hy – NH is to be carried out isothermally. The molar feed is 50%…

A:

Q: In the famous Haber process to manufacture ammonia, the reaction is carried out at pressures of 800…

A: Given,Fresh feed,

Q: determine the rate of heat flow through a spherical boiler wall which is 2 m in diameter and 2 m…

A:

Q: c) Using deviation variables, derive the response when the inlet concentration increase in a step by…

A: Irreversible first-order reaction is taking place in CSTRVolume of reactor = 10 m3 Inlet…

Q: use this equation EI; = mi emmitted MF, burned To get this equation EI₁ = (x₁+Xco) · ( J XMwi MWf

A: Emission Index (EI) is the measure of pollutants emitted per unit of fuel burned.

Q: Describe the physical, chemical and biological composition of leachate

A: Leachate has unique physical properties that reveal information about its composition and source.…

Q: Figure 3 shows flood water flowing into two tanks. Assume that the flow is steady and there are no…

A: For system having constant pressure at in and out position Bernaulli equation becomesV^2/2g…

Q: Explain the concept of chemical equilibrium and its importance in chemical reactions.

A: When both the forward and reverse reactions in a chemical reaction occur at the same pace and there…

Q: Iron ore is wet-milled, the mill produces a pulp at a rate of 1.54 t/hr. The mill product has a…

A: Mill Characteristics:Mill product rate (Q) = 1.54 t/hrLiquid-to-solids ratio (L/S) of mill product =…

Q: 2. Use Routh Array to check the stability of the process. 92 91 hm LT#LCH Toy Figure 11.22…

A: The Routh stability criterion generally asserts that if and only if every first-column element in…

Q: Which software is good for designing of reactors in chemical engineering ?

A: Chemical engineers can design reactors using a variety of software programs. The user's tastes and…

Q: Fresh orange juice with 12% soluble solids content is concentrated to 60% in a multiple effect…

A: In order to create a final product with a 42% soluble solids content, orange juice must first be…

Q: 5. thick-walled tube of aluminum (k = 237 W/m °C) with 0.2m inner diameter (ID) and 0.3m outer…

A: Ta = interface temperature

Q: A racemic mixture consisting of component A and B displayed enantiomeric excess of 60% A. How much…

A: The amount of one enantiomer present in the mixture is expressed as enantiomeric excess.

Q: Which of the following is true for the rate law of a reversible reaction? a) Rate law can be written…

A: The correct answer is (b), which states that the rate law of a reversible reaction reduces to an…

Q: A house has a composite wall made of wood, fiberglass insulation, and gypsum boards. On a cold…

A: The concepts used to solve this problem are heat transfer, equivalent thermal resistance, and heat…

Q: A new structural application uses partially stabilized zirconia with equimolar (equal molar amounts)…

A: it is given that the material is at an operating temperature of 500ocAt this temperature, the wt% at…

Q: Derive the corresponding equation for the MTBL, PLD and CRC rate determining step of a gas-solid…

A: It is given that the reaction is a gas-solid reaction in a spherical configuration, where  and  are…

Q: Water is discharged steadily from a tank to the atmosphere thre (roughness e = 0.046 mm). The…

A:

Q: 500 mol of methane are stored in a volume of 0.06 m³ at 50°C? Given a = 0.012, To 190.6 K and Pc =…

A: The objective of the question is to calculate the pressure generated by 500 moles of methane stored…

Q: 1.6 Properties: Diffusivity Estimate the molecular diameter and diffusion coefficient for the…

A:

Q: Table B.2: Constants for the Antoine Equation for Vapor Pressures of Pure Species B t/°C + C Latent…

A:

Q: Calculate the Areal weighted average for the below reservoir data measurements: Ø₁ = 20%, Øb = 11%,…

A: Given,

Q: 1. A substrate solution of 0.1 kmol m^-3 is reacted in a stirred-batch reactor using the free…

A:

Q: TASK 4: Consider a suspension settling under hindered settling conditions (type III) in a cylinder…

A: Given :Hindered velocity of settling Unhindered settling , single particle velocity Galileo Number…

Q: 4.Find the heat transfer per unit area through the composite wall in Figure Assume one-dimensional…

A:

Q: 7.4 A normally consolidated clay is consolidated under a triaxial chamber con- fining pressure of…

A: It is given that normally consolidated clay is consolidated under a triaxial chamber .Confining…

Q: The ethanol dehydrogenation reaction  C2H5OH(v) --> CH3CHO(v) + H2(g) is carried out with the feed…

A:

Q: resent flow diagram.  (The problem below is as stated, no corrections needed) 1. A ternary blend…

A:

Q: A reactor operates at 10 % conversion and produces NH3 from N2 and H2.  A perfect separator recovers…

A: Given,

Q: 5- A vacuum gauge indicate a pressure of 0.2 bar of a gas enclosed in a rigid cylinder, the…

A: GIven,

Q: 17.17. The fins on the radiator of your car are about 2 in long. When your car is going 60 mi/h, the…

A: length of fin x=2 inchvelocity approaching the fins  v=40 mi/hr = 17.88 m/s

Q: You task your lab partner with measuring the melting point of a compound while you dispose of the…

A: The temperature at which the solid and liquid forms of a pure substance can exist in balance is…