Z2(s) R2 20 log R1 SC R2 -20 dB/decade R1 log o Он Frequency (b) Figure 10.32 (a) Inverting amplifier with frequency-dependent feedback; (b) Bode plot of the voltage gain of the low-pass filter.

Q: A) By Cascading a first-order op RC low-pass circuit with a first-order RC high-pass circuit, one…

A: The OP-amp configuration works as unity gain Amplifier  and R5 and C4  network work as a Low…

Q: 2- What are the limitations of Sallen-Key filter design topology. 3. What are the values of ideal…

A:

Q: An active filter needs to be designed using a non-inverting amplifier that behaves as a band pass…

A:

Q: A first-order PLL is operating with zero frequency and phase error when a step in frequency of…

A:

Q: Vcc +9 V Bpc = Bac = 125 Che = 25 pF Che = 10 pF Rc 220 Ω Determine the critical frequencies…

A: Given data, βDC=125βac=125Cbe=25 pFCbc=10 pFRC=220 ΩRE=100 ΩC1=1 μFC2=10 μFC3=1 μFRL=680 ΩR1=12…

Q: why the frequency fT is called the ? unity - gain frequency

A: Unity gain frequency fT is one of the important parameter in frequency response.

Q: The electronic circuit of the filtering stage of a biomedical device is as seen. The filter passes…

A: The circuit diagram is: Applying voltage division rule at the input of first op-amp:

Q: Q9: Obtain the transfer function C(s)/R(s) for the closed loop system shown in figure (9). Use…

A:

Q: a) Draw the equivalent circuit of the current mirror in the middle frequency domain. Find the…

A:

Q: Q 2. An amplifier circuit is shown in Figure 2. Use the short-circuit and zero-value methods to find…

A: For the given circuit of amplifier  lower 3-dB frequency, higher 3-dB frequency and mid band gain is…

Q: e и KONT SİST In the above figure, the transfer function of the system (SİST) block is (1/ s2), but…

A:

Q: Consider the RL circuit below. UI a. Obtain the transfer function H(s) = Vo/V₁. b. Find the relation…

A:

Q: 13. Given the unity feedback system of Figure P6.3 with [Section: 6.3] 84 G(s) %3D s(s7 +5s…

A: We need to tell about number of poles lies on RIght hand side , left hand side of s plane and poles…

Q: XSC1 ХВР1 Tektr IN OUT R4 12kQ 12V U1 C1 C2 5nF 5nF 741 V1 VEE R3 1Vpk 500HZ 0° 12kQ -12V RA 31KQ RB…

A:

Q: + R2 V R1 +1

A:

Q: Refer to the block diagram below. If K = 50, determine the a) overall transfer function, b)…

A:

Q: a) Determine the order of a lowpass Butterworth filter that has a cutoff frequency of 1000 rad/sec…

A:

Q: for the following given circuit a) find Avs mid = Vs/ Vi. b) define the values fLS, fLC and fLE. c)…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should be…

Q: For each of the bandpass filters we have constructed, we have always assumed an ideal voltage…

A: Applying voltage divider rule in the above circuit, v0=R×viRi+sL+1sC+Rv0vi=R×sCsCRi+s2LC+1+RsC

Q: Q1: The bode diagram of the following open-loop T.F is as shown in Fig. below: K GH(s)= s(s+2)(s+2)…

A: Gain margin: It is the amount of change in an open-loop system that requires to make a closed system…

Q: Using Mason's gain rule, obtain the overall transfer function of a control system represented by the…

A: control system problem given

Q: Transfer function is given to the filter a) Perform with passive elements (R, L, C) with f0 = 1 MHz,…

A: For the given transfer function  the filter is analyzed using passive elements and op-amp as shown…

Q: 1- Assume we have the following active filter with R₂ = 1k02, R₂ = 25k2, R₁ = 15k02, C₂ = 0.2μF, and…

A: Given:- R1=1 kΩR2=25 kΩR3=15 kΩC1=0.2 μFC2=0.1 μF We have to find the lower and higher frequency.

Q: XSc1 ХВР1 Tektronix IN OUT C1 5nF VcC R1 R2 22V 12KQ 12kQ U1 C2 :5nF V1 VEE 741 1Vpk 10kHz 0° -22V…

A:

Q: A first-order PLL is operating with zero frequency and phase error when a step in frequency of…

A:

Q: 250 4. Open-loop transfer fünction of a drug delivery system can be represented by H(s) s2 +26s+25…

A:

Q: A single-pole op amp has an open-loop gain of 100 dB and a unity-gain frequency of 3 MHz. Find an…

A: Given fT=3 MHz Calculating angular frequency ωT=2πfTωT=2π3 MHzωT=6×106π Converting gain decibel to…

Q: Q2 (a) As part of a radio receiver, you are asked to design a simple bandpass filter using a series…

A:

Q: CMI + Cgs = (1+gm(r,l|RpL))Cgd + Cgs, so C, is clearly >> %3D Cgd. This means that fol << f» since…

A:

Q: Consider the transfer function of an amplifier shown in the Figure, and then find the bandwidth BW…

A:

Q: for the following given circuit a) find Avs mid = Vs/ Vi. b) define the values fLS, fLC and fLE. c)…

A:

Q: Q1: For the open loop poles shown in figure s-plane 1- Find the open loop transfer function 2-…

A:

Q: 1D In the amplifier of Figure 1, g--6.667 mS, Ip 0.5 mA, 2,-A-0.1 V and CL-31.83 pF. Neglect all…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: LESSON: CONTROL SYSTEMS Obtain the transfer function Vo (s) / Vi (s) in terms of parameters for the…

A: As we have given : R1=1 kΩR2=1 kΩC1=1 nFC2=1 nF

Q: A certain op amp has an open-loop dc gain of A0OL=200,000 and an open-loop 3-dB bandwidth of fBOL=5…

A: The gain bandwidth products is: ft=A0OLfBOL=2×105×5=1 MHzA0OLfBOL=ft if A0CL = 100 then bandwidth…

Q: Consider the following circuit where Rf =5kΩ Select a value of C to give a bandwidth of 100 rad/sec…

A:

Q: Consider the circuit in Figure 5.1 in sinusoidal steady state. R1 L R2 Figure 5-1 V.(jw) V, (ju) (a)…

A:

Q: Task Four: Hearing Aid Volume Control system The human ear reacts to various frequencies in a…

A:

Q: The voltage transfer function of the prototype bandpass filtershown  isH(s)=(1Q)ss2+(1Q)s+1. Show…

A: The transfer function of the circuit is,H(s)=1Qss2+1Qs+1...(1) The transfer function of RLC circuit…

Q: R1 C2 Vị Vo R2 a) For the second-order filter shown above, calculate the transfer function…

A: Given filter circuit is a second-order filter as there are two energy storing elements and the…

Q: 1- For a system with the transfer function Y(s) 2s³ - 12 U(s) 4s5 S3 + 4s 10 The state matix is…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The inverting amplifier shown in Figure P12.46 can be used as a low-pass filter. a. Derive frequency…

A:

Q: 1) In the amplifier of Figure 1, g--6.667 mS, Ip=0.5 mA, A- -0.1 V- and CL=31.83 pF. Neglect all…

A: Given the circuit, as shown below: 1. In the given circuit as shown above: gm=6.667 mS, ID=0.5…

Q: b) The magnitude plot of a transfer function G(s)=- shown in Figure Q4b. Determine K, a and b from…

A:

Q: Analogue Electronics II Design 2 different configurations of active band pass filter for the…

A: Given: A 2 different configurations of active bandpass filter for the frequency with a bandwidth of…

Q: Q-factor and bandwidth

A: Resistance in parallel- 1/Req=1/R1+1/R2+1/R3+...........   Resistance in series-…

Q: Gain Phase deg dB Ph 10w, 2= integrator

A:

Q: Phase deg Gain dB - Ph2 Ph3 Ph 10w W4

A:

Q: 5 X 10 rad/s 6 UB/octave w, ruil/s -6 i1B FIGURE P4,12

A: Designing the Circuit means we need to find the transfer fucntion of the given bode plot therefore…