Write the answer of each of the following questions in brief with respect to OSI layer model: 1. Reliable process-to-process message delivery Answer 2. Route selection Answer 3. Defines frames Answer 4. Transmission of bit stream across physical medium
Q: The physical layer translates logical communication requests from the ______ into hardware specific…
A: Dear Student, The Data link layer present just above the physical layer sends the logical…
Q: Write the answer of each of the following questions in brief with respect to OSI layer model:…
A: Given: Write the answer of each of the following questions in brief with respect to OSI layer model:…
Q: The term synchronization has many meanings in Computer Science. Within the networking field, the…
A: Synchronization Synchronization is defined as the devices and events are coming all together and…
Q: Draw a block diagram of a single carrier digital transmitter and corresponding receiver for the…
A: Please upvote. I am providing you the correct answer below. Please please please.
Q: 1) Consider a Transport layer segment with size of 8000 bytes includes an IP header of 20 bytes no…
A: Given Data : ID = 555 MTU = 1500 Total Data = 8000
Q: Consider a selective repeat sliding window protocol that uses a frame size of 2 KB to send data on a…
A: Given the Frame Size as 2KB, Bandwidth=4Mbps Latency =60ms, which is also known as Propagation delay…
Q: Match the following to one or more layers of the OSI model: i.Route determination ii. Flow control…
A: Given that match the following to one or more layers of the OSI model: i.Route determination ii.…
Q: Transport layer functions are implemented primarily at the interconnecting devices in the network
A: Solution :
Q: Which layer of the ISO/OSI Reference Model would be responsible for encryption or compression during…
A: Given: Which tier of the ISO/OSI Reference Model would be responsible for delivering this service if…
Q: Name the two host-tohost layer protocols important to remember
A: The two host-tohost layer protocols important to remember are:-
Q: queries are submitted in a broadcast architecture
A: ARP Address resolution protocol ARP queries are submitted in a broadcast architecture because they…
Q: What are advantages and disadvantages of random access based multiple access protocols? Why slotted…
A: Multiple Access Protocols: The Data Link Layer is responsible for the transmission of data between…
Q: Data is sent over a network from a source to a destination. The data cannot be sent until it has…
A: Data is sent over a network from a source to a destination. The data cannot be sent until it has…
Q: Question 1 a) Give the names of the layers of the OSI standard that address the following issues:…
A: Given: Fill in the blanks.
Q: The physical layer is responsible for converting logical communication requests from the into…
A: Given: The physical layer is responsible for converting logical communication requests from the into…
Q: An ARP query is delivered inside a broadcast frame for a reason. Why is an ARP response transmitted…
A: Introduction: ARP sends a request packet to all of the computers on the LAN, inquiring as to whether…
Q: Write the answer of each of the following questions in brief with respect to OSI layer model:
A: Answer: 1. Reliable process-to-process message delivery: A transport layer is used that is reliable…
Q: In OSI model dialogue control and token management are responsibilities of Network layer O Data link…
A: Ans: In OSI model dialogue control and token management are responsibilities of : d) Session layer
Q: a broadcast framework? What is the purpose
A: ARP request is sent as broadcast because initially it don't know the particular target MAC address…
Q: 6. Match the following to one or more layers of the OSI model: a. Route determination b. Flow…
A: We need to match the columns with layers of OSI model.
Q: Suppose, through the Data link layer a message is passing from Sender to Receiver. That message…
A: What is DLL(Data Link Layer) The Data Link Layer is the second layer in the OSI model, above the…
Q: Describe clearly ,step by step ,and layer by layer,the operation that takes place when passing a…
A: This procedure takes place in a switching network when the datagram crosses an intermediate node:…
Q: d) Assume that, in a Stop-and-Wait ARQ system, the bandwidth of the line is 5 Mbps, and 1 bit takes…
A: i. Its bandwidth-delay product: (5x106)x(80x10-3) = 400000 bits ii. The system can send 400000 bits…
Q: QUESTION 9: Assume the usage of Go-Back-7 (N = 7) ARQ sliding window protocol for flow and error…
A: Here in this multiple question we have given a sliding window (GB7) .and we have asked to find no of…
Q: Match the following to one or more layers of the OSI model: i.Route determination ii. Flow control…
A: Hey there, I am writing the required solution based on the above given question. Please do find the…
Q: The physical layer is in charge of coordinating the functions required to send a bit stream via a…
A: Introduction: The physical layer is in charge of moving individual bits from one hop (node) to the…
Q: Which layer of the OSI Model is responsible for bit-bit delivery in networking?
A: 1) The OSI(Open Systems Interconnect) model explains all the individual functions that are necessary…
Q: When a physical layer data transmission frequency rises, what happens to the period?
A: Given: information that has been suppliedIn the context of data transmission at the physical layer,…
Q: In the Internet, the datagrams transmitted by IP datagrams are assembled at the final destination…
A: Advantages of Reassembly of IP datagrams at final destination host: Assembling IP datagrams at…
Q: Write the answer of each of the following questions in brief with respect to OSI layer model: 1.…
A: The Answer is in given below step
Q: Match the Protocol Data Unit (PDU) with the OSI layer. Layer 1 v [ Choose ] Segment Packet Frame…
A: Here in this question we have asked to match the osi layer with thier data unit term.
Q: QUESTION 16 Select the correct statement(s) regarding Frame Relay (FR). a. FR is a connectionless…
A: Frame Relay is a highly efficient WAN protocol that operates on physical and data interface layers…
Q: Which layer manages the transmission of data across a physical link and is primarilyconcerned with…
A: The layer that manages the transmission of data across a physical link and is primarily concerned…
Q: Design a MAC protocol for an access network where N nodes generate data continuously at a constant…
A: 1st is thar each node transmit at constant rate x bit/sec
Q: 6- Bits can be sent over guided and unguided media as analog signal by a) digital modulation b)…
A: 6)Bits can be sent over guided and unguided media as analog signal by -‐-------------…
Q: a) Give the names of the layers of the OSI standard that address the following issues: • Handling of…
A: The OSI model layers are:- Physical layer Datalink layer Network layer Transport layer Session…
Q: 1.5.1 Show the sequence of start, data, and stop bits that are generated during asynchronous…
A: 1.5.1 Show the sequence of start, data, and stop bits that are generated during asynchronous…
Q: The protocol data unit (PDU) for the data link layer in the Internet stack is called ___________.…
A: Protocol data unit for data link layer Protocol data unit is a single unit of information…
Q: 3.4-8 Channel utilization with pipelining. Suppose a packet is 10K bits long, the channel…
A: Correct answer - (C) 0.1
Q: An ARP query is delivered within a broadcast frame for a reason. Why is an ARP response transmitted…
A: Introduction: For the purpose of explaining how to submit an ARP request as a broadcast message,…
Q: What is the delay of sending a data file from a source station to a destination station? Suppose…
A: Here the total delay for sending file from source to destination => Transmission delay +…
Q: 1) A protocol data unit on Layers 5 to 7 is generally referred to as a a) Segment b) Frame c)…
A: The OSI Model (also known as Open Systems Interconnection Model) can be understood as a conceptual…
Q: Compare the different streaming data delivery protocols with respect to the following points: I.…
A: Compare the different streaming data delivery protocols with respect to the following points: I.…
Q: Use again the network architecture provided in the figure above, were Rs, Rc and Ri for i =…
A: Given :- Use again the network architecture provided in the figure above, were Rs, Rc and Ri for i =…
Q: Given that the data connection layer is capable of detecting mistakes between hops, why do you…
A: Because the data link layer can find some errors, we need a different way to check for them at the…
Q: How big would the window size have to be for the channel utilization to be greater than 98 percent…
A: As given:- The transmission rate of the link (R) = 1Gbps = 109 bits/sec. The round-trip…
Step by step
Solved in 2 steps
- Write the answer of each of the following questions in brief with respect to OSI layer model: 1. Reliable process-to-process message delivery Answer 2. Route selection Answer 3. Defines frames Answer 4. Transmission of bit stream across physical medium AnswerWrite the answer of each of the following questions in brief with respect to OSI layer model: Transmission of bit stream across physical medium Answer: *This question has already been submitted, but this question remains unansweredWhat is the physical layer's concern with bit-by-bit delivery?
- A 4480-octet datagram is to be transmitted and needs to be fragmented because it will pass through an Ethernet with a maximum payload of 1500 octets. Show the Total Length, More Flag, and Fragment Offset values in each of the resulting fragments.Question Two a) Explain the ARP protocol to a friend. In that explanation, mention what layer it operates at and the kind of service it provides to the layer above it. b) Having ARP table entries time out after 10 to 15 minutes is an attempt at a reasonable compromise. Describe the problems that can occur if the timeout value is too small or too large. c) IEEE defines two sublayers at Layer 2, discuss the purpose of each. d) How does a computer attached to a shared LAN decide whether to accept a packet? e) Expand the acronym CSMA/CD, explaining each part and why CSMA/CD uses a random delay? f) Explain why cllision is an issue in a random-access protocol but not in reservation or channel partitioning protocols. Page 2 of 5 Р. Т.ОDescribe the significance of "Preamble" and "Start Frame Delimiter" in the Data Link layer.
- The physical layer concerns with bit-by-bit delivery why?basic data link layer principles (e.g. PPP if modems, maximum frame size in byte, maximum header size, CSMA/CA or CSMA/CD media-access control if any, etc): Your answerWhat is the delay of sending a data file from a source station to a destination station? Suppose that the length of the data file is 2 Mbytes and the bandwidth of the channel is 1600 bps, and the network link between the sender and receiver is 20000 Km and the speed of the light inside the link is 2x108 meters/second? Assume that the delay is composed of only transmission time and propagation time.
- How do ARP (Address Resolution Protocol) and RARP (Reverse ARP) differ in their functionalities within the Data Link layer?Why is the physical layer worried about bit-by-bit delivery?We define data link layer communication efficiency as the ratio between a packet transmission time and the sum of the the packet transmission time-and twice of its, propagation time. A channel has a bit rate of 10 kbps and a propagation delay of 10,000 micro-second. For what range of frame sizes (in number of bit) does stop-and-wait give an efficiency of at most 60%?
