Write a report to compare between Ac Through capacitance and AC through in inductance then: For the circuit shown beside, find the total impedance between a (and b and Circuit current (I a 100 0 v 8Ω -j72

Write a report to compare between Ac Through capacitance and AC through in inductance then: For the circuit shown beside, find the total impedance between a (and b and Circuit current (I a 100 0 v 8Ω -j72

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: H.W 1.6: A series RL circuit is connected to a 110-V ac source. If the voltage across the resistor…

A: In case of series RL circuit resistor and inductor is directly connected with voltage source. Given…

Q: The equivalent capacitance at terminals a-b in the circuit given is 80 F, then the value of C is

Q: Three equal star-connected impedances take 11 kW at power factor 0.6 leading when connect across a…

Q: A series R combination in an AC circuit has R = 100 and X, = 120 A capacitor is connected across the…

A: By ohms law current in impedance Z=(voltage across impedance)/(impedance Z). Given impedance =R+jXL…

Q: 20) 20) With an input sinusoid as shown, determine the yvo(t). Another way of saying this is what is…

Q: ind the current i(t) in the network in Figure shown below: 20 1 )120 sin (3771 + 60) V 50 µF 40 mH

A: we need to find out current i(t).

Q: An AC circuit is composed of a serial connection of: a resistor with resistance 50 N, a coil with…

Q: L! > 6H L2 4H L32.44 2.44 120V 12544 11 1 √2 √3

Q: connected in parallel. This combination is then placed in series with a capacitance. Compute the…

Q: Q. Using Mesh analysis find the voltage across the indicated capacitance. R2 100 0 80 mH 50 mH 200 0…

Q: An inductor is connected in series with a resistor of 20 N and an ac source of voltage 200 V, 50 Hz.…

A: Given; impedance Calculate inductive reactance

Q: Transform the following sinusoids to phasors a. i(t) = 6cos (50t - 40') A b. v(t) = 12cos (377t -…

A: The standard representation of the voltage and current sinusoids will be: v(t)=A cosωt+θV,i(t)=A…

Q: Given an AC source having a voltage v(t)=18sin(173t + 30°) V, find the votage at t=130ms.

A: Substitute t= 0.13 sec in v(t) to find V(t) at t = 10m seconds .

Q: 10 Ohm resistance in parallel with 50 uF capacitance and the current through the capacitance is: ic…

Q: 3.) True or False: If the frequency is zero, the capacitive reactance is infinite. It is said that…

A: From the Question If the frequency is zero, the capacitive reactance is infinite. It is said that…

Q: Find the equivalent capacitance of the network shown below connected across terminals a and b. 0 a…

Q: A 50-µF and 100-µF capacitors are connected in series and across a 100 sin (wt + 30o) voltage.…

A: In this question we need to choose a correct option

Q: CAPACITANCE Find the equivalent capacitance with respect to the terminals a-b for the circuit shown.…

Q: 10 resistance in parallel with 50 uF capacitance and the current through the capacitance is: ic (t)…

A: Given Resistance (R)= 10 ohm Current through the capacitance is

Q: R1 R2 + Vout Vou(t) (* In the circuit above, use R, = 62, R, = 52, and V = 30V. Assume that element…

Q: In any circuit if we have AC and DC sources, then circuit must be analyzed by superposition Select…

A: Superposition theorem states that if circuit contain more than one independent source then total…

Q: Find the current flowing through the RLC circuit connected through an AC source of 240 V as given…

A: Given data, V=240 V, R=100 Ω, L=100 mH, C=100 μF, f=50 Hz Given circuit diagram,

Q: -) Find, from the de finition, & § sinw,t } Use jcw-w.)t e

Q: two of nions! a) 10 resistance in parallel with 50 µf capacitance and the current through the…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: A current source in a linear circuit has i(t) = 12 cos (100tt – 15°) A Determine the frequency of…

Q: /102 resistance in parallel with 50l F Capacitance the Current through the capacitance is: (c(+) = 2…

A: Given,Resistance, R=10 ΩCapacitance, C=50 μFThe current through capacitance is,ict=2 sin100t+1.5…

Q: Q.NO.3 In an ac circuit two loads of impedances 100x + 0j N and 10x + j20 N are connected in…

Q: A series RLC AC circuit has R = 425 Ω, L =1.25 H, C = 3.50 µF, ω=377 s-1, and ΔVmax= 150 V. (a)…

A: A series RLC AC circuit R = 425 Ω, L =1.25 H, C = 3.50 µF, ω=377 s-1, ΔVmax= 150 V. (a) Determine…

Q: A circuit consists of a voltage source, Vs = 15 cos 2000 t V, in series with a resistance of 150 Q…

A: Given: Series RL circuit: Vs=15cos2000t VR=150 ΩL=47 mH

Q: Q1 Using Mesh, find the voltage on the capacitor. 20 10 L60°v 12 ww ww j8 -j10 2 20 Lo°V ww

A: KCL (Kirchhoff's Current Law) states that the algebraic sum of current at node or junction is zero.…

Q: Consider the circuit shown in the figure below. Find the phasors Is, V, IR. IL, and Ic- i,(1) = 0.01…

A: From the above question the given data is as follows: The source current:ISt=0.01cos104tPhasor form…

Q: A. For the following sinusoids, determine which one leads and by how much a. v(t) = 10cos (4t – 60°)…

Q: Determine the equivalent inductance Leq between terminals a and b in Figure T3.5.

A: Given circuit is =

Q: Q2: Find the equivalent capacitance between terminals a and b in the circuit of Figure. All…

A: Capacitor is an electrical component used to store electrical energy in the form of charge. If n…

Q: For the network in following circuit, determine the capacitance that will ensure maximum power to…

Q: TOPIC: AC CIRCUITS A 10 ohm resistor, 15 mH inductor and a 20 micro-Farad capacitor are connected…

Q: 1) A DC circuit has as a load. (a) Resistance (b) Inductance (c) Capacitance (d) All of the above

A: A DC circuit has always a resistive load. As a DC source has zero frequency so capacitor behaves as…

Q: a. Determine I, VR, and Vc in phasor form.

A: To find the phasor form of I, VR and VC in the given below circuit:

Q: 1. What capacitance when connected in series with a 5000 resistor will limit the current drawn from…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: For the given network, find the total capacitance. (Note: all capacitance in microfarad) 10 16 4 a…

Q: A series RLC circuit containing a resistance of 1202, an inductance of 0.15H and a capacitor of…

Q: Use linearity to find Vo when and is is = 30 A. Let Vo =8V 20 No is i (1) v8 vh

Q: b. Find W. (capacitor energy) in the following circuit under DC conditions: 12 42 12 V 2 H 1F 25 J…

A: Given circuit, C=1 FL=2 H

Q: The equivalent inductance at a-b exist is : * 2H

Q: 3. [AC Circuit Analysis] Determine the steady-state AC value of Vx. Express your result in polar…

A: In this question, Determine the steady state voltage using the AC analysis. We are solving this…

Q: What is the amplitude of the current I?

Question

Write a report to compare between Ac
Through capacitance and AC through in
inductance then: For the circuit shown
beside, find the total impedance between a
(and b and Circuit current (I
a
100 0 v
8Ω
-j72

Expert Solution

Step 1

Let the total impedance between a and b be Z_th

Step 2

Step by step

Solved in 3 steps with 3 images

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Write a report to compare between Ac Through capacitance and AC through in inductance then: For the circuit shown beside, find the total impedance between a (and b and Circuit current (I j6N a 100 0 v 82 -j72 b
The below figure shows the waveform of the voltage and current in a purely inductive AC circuit. Voltage Current Using the voltage phasor as the reference, the current phasor Lags by 90° Is in phase with the voltage Leads by 90° Lags and then leads by 160°
Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at 25 Hz. The circuit takes 425 W, and the power factor is 0.47. The resistance of the circuit is A. 7.32 ohms C. 7.98 ohms B. 7.86 ohms D. 7.56 ohms
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
Write a report to compare between Ac Through capacitance and AC through in inductance then: For the circuit shown beside, find The average power delivered to * .the circuit I 92 100 0 v 82 -j72 b ww
The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert to polar form, complete the math, then convert back to the waveform at i1 = 3.5sin(2500t) mA and i2 = 2.3sin(200t – 60°) mA
An inductive impedance made up of a resistor and an inductor has the characteristic that its currentadvances in phase to the voltage at the impedance A) lags in phase with the voltage across the impedance B) is in phase with the voltage across the impedance. C) None of the above
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
The source in the circuit shown is a sinusoidal source. The supply voltages across various elements are marked in the figure. The input voltage is: 3V- ww -14 V-10V moon It