) Which of the following statement is true about Current Transformer? a. The current in the secondary winding is more than primary winding. b. No of turns in primary winding are less than secondary winding c. No of turns in primary winding are more than secondary winding. d. The voltage in the secondary winding is less than primary winding.

) Which of the following statement is true about Current Transformer? a. The current in the secondary winding is more than primary winding. b. No of turns in primary winding are less than secondary winding c. No of turns in primary winding are more than secondary winding. d. The voltage in the secondary winding is less than primary winding.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.9P

See similar textbooks

Similar questions

For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the rated voltage on the other winding? (a) Yes (b) No
3.b. When several blowers are installed instead of a single blower to force air through a transformer, theyA. require more complicated installation.B. provide greater safety.C. are noisier.D. consume more power. 3.c.In large power transformers, the unequal voltage distribution caused by voltage surges in the winding isprevented by the use ofA. series capacitors.B. parallel inductances.C. static shields.D. low-voltage arresters.
Ans all the below questions... Which liquid is used for transformer cooling?What is cooling tube in transformer?Why does a transformer need cooling?What are the different types of transformer cooling?
1.a. For performing dielectric-strength tests on insulating materials, two transformers are connected in aA. parallel combination.B. cascade arrangement.C. polyphase arrangement. 1.b. In large power transformers, the unequal voltage distribution caused by voltage surges in the winding isprevented by the use ofA. static shields.B. series capacitors.c. low-voltage arresters.
A transformer core is laminated in order to ....................................? (A) reduce hysteresis loss and eddy current loss (B) reduce only hysteresis loss (C) reduce copper loss (D) reduce all of the above losses (E) None of the above.
12.a. Comparing the transformer cores of core-form and shell-form transformers shows that thea. shell form provides lower reactance without increasing the transformer size.b. core form makes possible wider coils and better oil circulation.c. shell form is used exclusively in small low-voltage transformers.12.b. Distribution transformers are generally protected from damage due to excessive internal temperatures,by the operation of aA. lightning arrester.B. circuit breaker.C. surge diverter.
The efficiency of a transformer will be maximum when ........................? (A) copper losses = hysteresis losses (B) hysteresis losses = eddy current losses (C) eddy current losses = copper losses (D) copper losses = hysteresis losses plus eddy current losses (E) None of the above.
what is backlash in transformer ? if dc added in transformer what will happened. please draw diagrams and explained.
2. What is the material commonly used for construction of transformer core? Draw the B - H curve for this material?
The core of a three phase, 50 Hz, 11000/550 V delta/star, 300 kVA, core-type transformer operates with a flux of 0.05 Wb. Find (i) number of H.V. and L.V. turns per phase. (ii) e.m.f. per turn (iii) full load H.V. and L.V. phase-currents.
What conclusions we come up with after doing open circuit test on single phase transformer.
In the single-phase, three- winding, transformer, the primary current is equal to lo at the condition of ints there is no load on tertiary windings the current in secondary windings equal to zero the resistances (R1, R2, and R3) in transformer windings are equal the inductances (L1, L2, and L3) in transformer windings are equal.