When the water table is deep (like 30 to 100 feet deep) and the surface soil is at field capacity, the soil water potential at field capacity for loamy soils will be about: -31 bar ) -1,000 bar O -15 bar -0.01 bar O -1/3 bar

When the water table is deep (like 30 to 100 feet deep) and the surface soil is at field capacity, the soil water potential at field capacity for loamy soils will be about: -31 bar ) -1,000 bar O -15 bar -0.01 bar O -1/3 bar

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter3: Weight–volume Relationships

Section: Chapter Questions

Problem 3.18P

See similar textbooks

Related questions

Q: The in-situ moisture content of a soil is 18% and its moist unit weight is 16.50 kN/cu. m. The speci...

Q: The ground distance as corrected from temperature sag and pull correction is 10,000 meters. If the s...

Q: nstruction: Please provide complete solutions and box final answers.

A: S.no Strength in Mpa Mean (X-mean) (x-mean)^2 1 38.3 41.735 -3.435 11.799225 3.074275...

Q: r is designed to ca 20KN. Using allow 20MPa and ỢC = 6

Q: You were tasked to draw the Soil-Water Characteristic Curve (SWCC) of four types of soil: sand, clay...

A: Soil water characteristic curve (SWCC) is widely known as the relationship between matric suction an...

Q: A soil sample has a weight of 13.5 KN and a water content of 44.4%. If G=2.7 degree of saturation 80...

A: Given data : The value of specific gravity of soil G=2.7 The value of water content w%=44.4 The valu...

Q: A gasoline engine is an internal combustion engine that requires fuel for its combustion and operati...

Q: The motion of a particle is governed by the relation a = 4t² , where a is in m/s² and t in secs. Whe...

Q: Select one agricultural crop that is widely cultivated in the Japan (ex. Rice, corn, sugarcane, etc....

A: Japan is the largest importer of foods and agricultural products in the world. In 2019, around 7.76 ...

Q: 2. A 6 in. pipe, as shown in the figure, takes water from a reservoir and terminates in a nozzle hav...

A: Apply the Bernoulli's equation from 1 to 2 as follows: △Z=V2/2g+(0.08)V2/2g+hL 140−15=(1.08)V2/2g+3+...

Q: A soil sample has a total volume of 1,462 cc. The specific gravity of the soil solids is 2.66. Then ...

A: Given data in question Total volume Specific gravity Dry weight To find out Volume of voids

Q: A horizontal 45° bend 750 mm Ø upstream and 300 mm Ø downstream has water flowing thru it at the rat...

Q: (2) What is the efect of the new footing on the old footing? Suggest a method to minimize these effe...

A: The effect of new footing on the old footing. As from the picture, if natural ground level for old ...

Q: tensile load of 150 kN is applied to a round metal bar with a diameter of 16 mm and a gage length of...

Q: Diameter Length Darcy Terminal Reservoir Pipe Weisbach Reservoir elevation friction (m) factor (f) J...

Q: 3. Find the pressure difference between A and B if: a.) x=4ft, y=2ft, z=3ft and Fluid 1 is water, Fl...

A: To find out the pressure difference between A&B.

Q: Two plates with a thickness of 35mm, width of 160mm, and length of 200mm are joined ogether by a pin...

A: thickness =35mm Width =160mm Length =200mm Pin Diameter =60mm

Q: The horizontal boom OC, which is supported by a ball-and-socket joint and two cables, carries the ve...

A: coordinates of A = (0,3,0) B = (0,5,0) C = (0,6,0) D = (-2.5, 0, 3) E = (3.5,0, 3)

Q: Sample of soil was tested in the laboratory, and the test results were listed as follows. Classify t...

Q: Horizontal stiffness coefficient, K,, of bar ab is 11 given by,

Q: The soil has the following properties: Gs= 2.67 void ratio= 0.54 watee content%3D 11.52% Solve the a...

Q: A projectile was launched from the top of a 25-m high building at a velocity of +35 m/s and at an an...

A: Hello dear Please see the attached solution, thanks

Q: A. A truck, with four wheel configuration and has loads as shown, will cross to a 12 m span bridge. ...

Q: Question 9: The moment of inertia about the X-X axis of the shape below is most nearly: 4 cm A. 270 ...

Q: てり sisve dpenning. て2) (3) weighi retuined (5) 7hetanedfessing مم القمه— (mm) 76-2 s08 25.4 19.0 12-...

A: Percentage retained Percentage passing.

Q: the DO meter showed a concentration of 8.8 mg/L. m RPD of 9% what is the saturation concentration c

A: Given:- concentration=8.8mg/L Maximum RPD=9% To find:- saturation concentration

Q: A rectangular tank 10m long by 2m deep by 5m wide contains Im of water. If the linear acceleration h...

Q: O WRITE NEATLY. KINDLY ER WITHIN 2 H RS FOR AN

A: Tan θ=σ2 θ= tan-13 θ=71.56° joint A ∑Fx =0P = 250 kn FAB Si...

Q: Scaie: 1:1 Instructions: Redraw the orthographic projections as given. Also, draw the oblique or iso...

Q: Determine the value of maximum principal stress

A: The given question is related with solid mechanics . In this question we are provided with value of ...

Q: 4P P P D B E A

Q: What are the pros and cons of the different terrain (land, water, air) where you can do outdoor recr...

Q: Determine the reaction (kN) at supports A and B from the given structure. 600 lb/ft 400 lb/ft 20 ft ...

Q: A three hinged parabolic arc having a span of 20 m and a rise of 5 m carries a point load of 10 kN a...

Q: ituation III: The table below shows the reported accidents for 1 10-mile highway section o lacapagal...

Q: How important is steaming when bending wood part? 2. What could happen if steaming process is not d...

A: 1. How important is steaming when bending wood part? Steaming actually changes the cellular structur...

Q: A vehicle travels at 50 mph on a straight, level Highway. Using a driver reaction time of 2.5 second...

Q: 1.0 m 1.2 m Motor B C 50 mm (а)

Q: 500 Ib/ft 8000 lb ft 8000 lb -ft B 10 ft

Q: A soil sample has a bulk unit weight of 18.8 kN/m^3 at a water content of 16.9%. Use Gs=2.69 Determ...

Q: An action will release discharge from a factory at a flow rate of 5 m³/s containing chemical A at a ...

Q: n the beam loaded as shown in the figure, 1. Find the reaction at the left support. a. 30kN b. 40...

A: note: when there is an internal hinge present summation of moment to the left of it and to the right...

Q: 14) When a fluid contained in a vessel initially at rest is translated horizontally, its surface ten...

Q: 2. The 1-m diameter cylinder in the figure is 8 meters long (dimension perpendicular to the paper) a...

Q: Aggregates from three sources having the properties shown in the table below where blended at a rati...

Q: When the soil water potential is zero bars (or atmospheres), the soil typically: is at the wilting p...

A: Brief concept introduction- Soil water potential- This represents the force per unit area required t...

Q: How important is it to Civil Engineers to understand the concept of work done by a force?

A: Civil engineer must know the concept of work done by forces ..

Q: Question #2: It is required to put guide sign (URBAN AREA; SPEED < 80 kph) on a rural highway, Deter...

A: Solution: Decision sight Distance: DSD = 1.47Vt+1.075v2a where, DSD = decision sight distance, ft. o...

Q: period (B) is 120 days for an irrigated crop, then If duty (D) is 1428 hectares/cumec and base nerio...

A: This question is related to the Irrigation Engineering. In this question we calculate the Delta of c...

Concept explainers

Landfills

The landfill is a site used for the disposal of waste materials. The landfill is a solid waste facility that is often known as a dumping ground. The image below shows a landfill site in Hawaii. Landfilling is the most ancient and common method used for the disposal of waste. For the landfill, a deep trench is constructed in an isolated place away from the city. The trench for landfills is designed properly after analyzing the total population and the waste generation per capita. The waste is dumped into the trench and after every layer of waste, a layer of soil is spread on the top of it.

Question

100%

When the water table is deep (like 30 to 100 feet deep) and the surface soil is at
field capacity, the soil water potential at field capacity for loamy soils will be about:
-31 bar
) -1,000 bar
O -15 bar
-0.01 bar
O -1/3 bar

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A soil has liquid limit of 60% plastic limit of 35% and shrinkage limit of 20% and it has a natural moisture content of 50%. The liquidity index of soil is
The Atterberg limits of of a clay soil are liquid limit = 75 %, Plastic limit = 45 % and shrinkage limit = 25 %. If a sample of this soil has a volume of 30 cm³ at the liquid limit and a volume 16.6 cm³ at the shrinkage limit. Determine the specific gravity of solids.
A clay has the following Atterberg Limits: LL 24% PL 13% SL 4% The clay shrinks from 10.65 cm^3 to 7.41 cm^3 when the moisture content is decreased from liquid limit to the shrinkage limit. Determine: 1. Plasticity Index (in PERCENTAGE form and in 2 decimal places) 2. Specific gravity of clay solids (in 2 decimal places) 3. Shrinkage ratio (in 2 decimal places)
1. A fine-grained soil has a liquid limit of 300% and a plastic limit of 55%. The natural water content of the soil in the field is 80% and clay content is 60%. Determine the plasticity index, the liquidity index What is the soil state in the field? a. b. C. If this soil were under a concrete slab used as a foundation for a building and water were to seep into it from watering of a lawn, what would you expect to happen to the foundation? 2. A liquid limit test, conducted on a soil sample in the cup device, gave the following results: No. of Blows 10 40 19 45.2 23 39.8 27 36.5 Water Content (%) 60.0 25.2 Two determinations for the plastic limit gave water contents of 20.3% and 20.8%. Determine... a. The liquid limit and plastic limit b. The plasticity index c. The liquidity index if the natural water content is 27.4% d. The void ratio at the liquid limit if Gs = 2.7. If the soil is saturated and is loaded to failure, would you expect a brittle failure? 3. The following results were…
Void ratio of a soil is 0.9, its porosity shall be:
The Atterberg limits of a clay soil are 72%, 40% and 23%. If a sample of this soil has a volume of 29.5 cm³ at the liquid limit and a volume 16.4 cm3 at the shrinkage limit, a. determine the specific gravity of solids determine the shrinkage ratio b.
2.A sample of clay soil has a liquid limit of 62% and its plasticity index is 32 percent. (1) What is the state of consistency of the soil if the soil in its natural state has a water content of 34 percent? (11) Calculate the shrinkage limit if the void ratio of the sample at the shrinkage limit is 0.70 Assume Gs = 2.70.
The Atterberg limits of a clay soil are: Liquid limit = 75%; Plastic limit = 45%; and Shrinkage limit = 25%. If a sample of this soil has a volume of 30 cm3 at the liquid limit and a volume 16.6 cm3 at the shrinkage limit. Determine the specific gravity of solids, shrinkage ratio, and the volumetric shrinkage.
2. A sample of clay soil has a liquid limit of 62% and its plasticity index is 32 percent. (1) What is the state of consistency of the soil if the soil in its natural state has a water content of 34 percent? (ii) Calculate the shrinkage limit if the void ratio of the sample at the shrinkage limit is 0.70 Assume Gs = 2.70.
Soil has liquid limit = 32, plastic limit 18, shrinkage limit 8 and natural moisture content = 22%. What will be its liquidity index and plasticity index? 1. 0.67 and 15% 2. 0.285 and 14% 3. 0.67 and 25% 4. 0.33 and 12%
1. A fine-grained soil has a liquid limit of 300% and a plastic limit of 55%. The natural water content of the soil in the field is 80% and clay content is 60%. a. Determine the plasticity index, the liquidity index b. What is the soil state in the field? c. If this soil were under a concrete slab used as a foundation for a building and water were to seep into it from watering of a lawn, what would you expect to happen to the foundation?
- PROBLEM 3: Silt clay has a plastic limit of 25 and a plasticity index of 30. If the liquidity index is 0.33, what is the natural moisture content of soil in percent?