What type of terminal seal is shown here?

Q: An op-amp has a slew rate of 10 V/μs. The largest since wave output voltage possible at a frequency…

A: Given: An opamp slew rate = 10 Vμs Frequency, f = 2 MHz Maximum possible sine wave output voltage,…

Q: 2. A push-pull converter has the following parameters: V's-24 V, Nr/N-2, D-0.25, Lx 2.5 mH, R-602,…

A: It is given that: VS=24 VNPNS=2D=0.25Lx=2.5 mHR=6 ΩC=50 μFf=10 kHz

Q: Consider the sinusoidal voltage (t) = 48 cos(32t+10°) V. NOTE: This is a multi-part question. Once…

A: Given: Sinusoidal voltage, v(t)=48 cos(32t+100) V, To find: The period T of the sinusoidal signal.

Q: 1-F capacitor is connected in series with a 6-ohm resistor. If the connection is energized from an…

A: We need to find out the voltage across capacitor for given circuit.

Q: +1 24 V V2 (1+) 12 V V3 (+1 10

A:

Q: An op-amp comparator in a firing circuit can produce waveforms at the output of up to 28 V…

A: Given: Peak to peak voltage, Vp-p=28V, Therefore the maximum voltage will be, Vm=14V, Firing angle,…

Q: A unity feedback system has the open loop transfer function shown below. Find the angle of arrival…

A:

Q: Q1/ After determine E to set the probabilities source vector, find: a) The Huffman codes of the set…

A: 1) Given, P(xi) =[0.1, 0.05,0.2,0.25,0.05,0.01,F] We need to find value of 'F' and then determine a)…

Q: Phosphorous ions are doped into active areas of NMOS transistors. P-well is required for PMOS…

A: We have to write whether the given statements are True or False. 1) Phosphorous ions are doped into…

Q: ex? logH Fir L & + √(x) tzo 805 4 H find i, (t), i₂(t), is (t) 30 134 201 , t)o

A:

Q: Find the charge on the capacitor and the current in the given RLC series circuit whose values are…

A:

Q: Calculate the value of V1 and V2? 12V R VI 8V B R E R + V2- 2V R D

A:

Q: In the circuit below, v1 = 10 V and i1 = -2.5 A. Use mesh analysis to find V i1 200 V₂ = 50 Ω ww 10…

A:

Q: 1. 10 I2 13 102 H

A:

Q: 125" ΖΩ 3Ω 1 I 49 (+) 452 4Ω (13 +1 |240

A:

Q: for the following circuit find a. Ip b. VDS c. VD d. Vs 20 V ' 2.2 ΚΩ + Vps 0.68 ΚΩ Ipss=4.5 m Vp =…

A: We need to find out the current and voltage for given circuit.

Q: Problem 09.030 - Find current when a resistor and capacitor are in parallel A voltage (t) = 100…

A:

Q: Problem 5. For the following transfer function of the plant and differential equations, derive the…

A: it is asked to find the state space representation of given transfer functions and differential…

Q: Please solve Last time Rejected. A 230-V, 3-phase, 4-pole, 50Hz, star connected induction motor is…

A:

Q: 1/0 SO s3 1/0 0/1 0/1 1/1 1/1 s1 s2 0/1 0/1

A:

Q: Listen R₁ *· 22 ΚΩ Vino (a) R₁ ww 150 ΚΩ D out (b) OV out The circuit or circuits with a virtual…

A:

Q: Example 3. Solve DE shown below. d² y dy +3- dt² dt +2y=24_y(0)=10 and y'(0) = 0 L[f"(t)]=s²F(s)-sf…

A:

Q: Mesh 50 V1 1 o 11 www Mesh 25R - 2 12 V2 25U

A:

Q: Consider the sinusoidal voltage (t) = 48 cos(32t + 10°) V. NOTE: This is a multi-part question. Once…

A: Given sinusoidal voltage:- vt=48cos32t+10° V Time interval t=10 ms =10×10-3 s

Q: Sketch the frequency response of the amplifier on a semi-log paper

A: The frequency response plot can be drawn between the frequency and the gain in decibels. The cut off…

Q: & Moving to another question will save this response. Question & A hair dryer is plugged into a 267…

A:

Q: A 4-pole, 50 Hz, 3-phase induction motor has blocked rotor reactance per phase which is four times…

A: Types of induction motor  Squirrel cage Induction motor  Slip ring induction motor

Q: I want ideas for the electronics and renewable energy course project

A: Types of renewable energy resources  Solar Wind Tidal Water Geothermal  Biomass....etc

Q: |1Α 2Ω 2Ω ← 1Ω 2Α 1Ω

A: it is asked to find the voltage at node a, b using nodal analysis

Q: four resistors having a value of 100 ohms each are connected parallel. what is the total resistance…

A: The resistances of the given circuit are:  R1=100 ΩR2=100 ΩR3=100 ΩR4=100 Ω Since the resistances…

Q: A sine wave has a maximum value of 10 V. Its value at 450 is 4 450 VO 14.14 VO 7,07 VO 4.5 VO

A: Given data, Maximum voltage Vm=10 V. Angle is given  θ=450.

Q: • For two capacitors connected in series, C₁-80 pF C₂=120 pF What will be the total capacitance? ο ο…

A:

Q: Ex 3: Circuit Modeling Using the Node Method: Two Nodes Consider the circuit shown below. a. Using…

A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per…

Q: Question 4 Three phase, Write answer

A: Given data, Number of pole P = 4. Frequency f = 50 Hz. Rotor speed Nr=1388 rpm.

Q: what is the realistic channel capacity of a communication channel of 25KHZ that has 20db signal to…

A: Given data,Signal-to-noise ratio (dB) SNR(dB)=20 dB Bandwidth BW=25×103 Hz

Q: Problem 09.019.a - Addition of two sinusoids using phasor cos(20t+ Using phasors, the value of 1…

A:

Q: b2. How much is the output G when A= 1, B=1 and C = 0. Explain how u got the result.

A: Given the combinational circuit  A is the input to NOT gate, Output D=A B and C is the input to…

Q: ) A circuit with series and parallel connection has, Vsupply = 24 Volt, resistors, R₁= 600, and two…

A: The required total current can be calculated by using the equivalent resistance of the circuit. So…

Q: need a reference about Elemental Semiconductor

A: Semiconductor has a electrical properties and which is used for the devices like diodes, transistors…

Q: 4. Find the transient charge in an RLC series circuit when: L = 1H                C = 0.25F R = 2Ω…

A: 4. Given, RLC series circuit is having  L = 1H C = 0.25F R = 2Ω E(t) = 50 cos(t), V We need to find…

Q: If the load reduces to 400 MW, how will it be shared among the generators and what will the system…

A:

Q: Electrical Circuits The switch in the circuit in Figure 3 changes position from position b to…

A: In this question We need to determine the voltage across the capacitor, current in the capacitor and…

Q: 3. Design a parity generator for a 3-bit data input A2A1A0, Use ODD PARITY. You have to use exactly…

A: The given problem is from digital electronics.  The detailed solution is given in the next step

Q: ult) v + Volt 2 ۱ pro he المان

A:

Q: + 12 V < 0° V1 R1 www 0.5k0 R2 ww 5kf XL = 10k Q Xc =5KQ 11 O' 4 mA < 0°

A:

Q: • If the capacitor and resistive circuit is connected to a DC voltage, what will be the charging…

A:

Q: Lecture: Combinational Circuits Implement the given Boolean function using inverted decoder.…

A: The given Boolean function have 3 input so the 3 to 8 decoder can be used to implement the given…

Q: 13. 14. 15. (B + BC)(B + BC)(B + D) ABC[AB + C(BC + AC)] ABCD + AB(CD) + ABCD

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 3. Find the charge on the capacitor and the current in the given RLC series circuit whose values are…

A: Capacitor: A capacitor is a device with two conductors used to store electrical energy. The…

Q: A group of single phase loads: 5 x1.8 kW, required to be supplied via 70° C PVC cables Knowing that…

A: Given data, Power P=5×1.8 kW The cross-sectional size of the core determines the single-phase copper…

Sample and Hold circuit

The sampling circuit and the holding circuit generate electrical samples as input and then hold these samples for a specified period. The time at which the sample and circuit holder produces the input signal sample is called the sampling time. Correspondingly, the length of the circuit that holds the sampled value is called the holding time.