What is the value of the voltage function at 30 seconds? v(t) = 82 sin (16nt + (21t/4) V Сл v (t) = A sin (Bnt + D

Q: Shown below is a DC circuit that contains a number of switches. Each switch is resistanceless when c...

A:

Q: Two relays each with 20 ohms resistance and 0.16 Henry inductance are connected in series. What is ...

A: In this question, We need to calculate the equivalent impedance if Two relays each with 20 ohms resi...

Q: Determine the magnitude of the series impedance parameters of Transformer(Req ,Xeq) referred to the ...

A:

Q: 4. A single-circuit 60-Hz high voltage power transmission line is 181 km (112.5 mi) long. The conduc...

A:

Q: sketch the output waveform of the following circuits

A: The given circuit is a clamper circuit that shifts the DC line either in the positive side or negati...

Q: A piece of silver wire has a resistance of 1 Q. What will be the resistance of a wire of one-half th...

A: Solve the problem

Q: Consider a single phase 2-winding 150 kVA, 2400/240 V, 60 Hz transformer with Reg = 0.00425 N, Xeq =...

A: In this question,  Find the efficiency of the transformer If it's operated at rated current and volt...

Q: 10 Ω 10 Ω 10 Ω 1.5 Η 3 ο

A:

Q: Q4: Consider a Zener diode with a nominal voltage (10v @ 10mA) and a resistance of 50 ohm. Calculate...

A: As the current through diode is halved the voltage will also be changed and thus we have: ∆V=rz×∆I=5...

Q: Given

A: G  

Q: C Y A A В В (a) Find the Boolean function Y for this CMOS Logic Gate. You can simplify Y as you wish...

A:

Q: Using disciminant Method: What is the power across the 3 ohm resistance?  What is the voltage across...

A:

Q: く+ Using KCL and KVL, calculate the voltages V and V, for the netw shown below. All the resistors ar...

A:

Q: 1. Using nodal voltage method, determine the magnitude and direction of the current / in the network...

A: Given circuit- Before applying node voltage method to the above circuit, First applying source tran...

Q: 4. If you need to assign binary encodings to 35 items, how many bits do you need?

A:

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 14 ohms R2 = 20 o...

A:

Q: A/ The atomic model that is currently used is called: *

A: The currently used atomic model is  Electron  Cloud model.

Q: Ex. 316. Determine the closed-loop steady-state error given a R(s) input, (b) unit ramp input, E (s)...

A:

Q: toroid

A:

Q: For the circuit shown, a) If vg = 1 kV and i̟ = 5 mA, find the value of R and the power absorbed by ...

A:

Q: 1. A motor draws 20A from 110V, 60HZ line with power factor of 77% lagging, calculate, (i) (ii) (iii...

A:

Q: dave connects an electric circuit to find the resistance of 100 cm of wire. the battery voltage is 9...

A: The given circuit is shown below: Voltmeter reading:V=5 voltAmmeter reading:I=2A

Q: 3. Apply nodal analysis to solve for Vx in the circuit in Fig.? Vx 20Ω 2 A 10 Ω. 0.2 Vx

A:

Q: Rule 6. Find the VX curl result of the vector W when W = x²yz î+ xy²zj+ xyz? k at the point (1,0,1) ...

A: This question belongs to electro magnetic field theory . It is about calculation of curl of a given ...

Q: True or False (a) The output Vo is in-phase with the input Vi if the cascaded amplifier consists of ...

A: Amplifier circuit is define as the circuit which is used for the amplification of the frequency, vol...

Q: Determine the voltage V, for the network. 9 12 V 912 V Si Si Ge V,+0.3 V 0.3 V 0.7 V 2.2 k2 2.2 k2

A:

Q: (20+j12)= ( 10- j6)=(4+J5)#(2+j3) = Z. (45-J co) - ( 30 +j 10) =(5+ ja) = 5, (120+ J 100) + (1110+ 1...

A:

Q: For the circuit below, find the current I.

A:

Q: Discuss the whole system of primary power distribution

A: Distribution system mean the electrical power  convert low voltage to high voltage at generating sta...

Q: 4. Determine the output voltage (Vo) and diode current (Ip) for the circuit shown below 2 ka Si +10 ...

A:

Q: 2. What fault occurs when Line and Neutral wires come with each other? Which device is actuated?

A: According to the given question, it is required to describe the fault which occurs when a line and a...

Q: The transfer function of the system below is

A:

Q: Ex. 318. Determine the closed-loop steady-state error given a R(s) input, (b) unit ramp input, -->0-...

A: This is a basic problem on steady state error. The solution is given below

Q: 1. Using vector diagram show and briefly explain the effect of supply voltage changes on a synchrono...

A: The armature current Ia in a dc. motor is calculated by multiplying the difference between V and Eb ...

Q: Q3.B/ The velocity of electrons will change when they collide with ions, therefore, :the probability...

A: Consider the time is τ.

Q: 1. Item 4. Find the result V gradient of the function t when t=4x^2 y - (y^2 * e^z) at the point (1,...

A:

Q: In a balanced three-phase Y-Y system, the source is an abc sequence of voltages and Van = 150 ∠35° V...

A:

Q: (note, 1 Kbps = 103 bps) that uses circuit switching and that Ali sent some  number of bits to Paul ...

A:

Q: The signal power at an amplifier is 150 W with noise power of 2µW. At the output, signal power is 1W...

A:

Q: j2N 1, 4Ω 3Ω j3Ω -j20 )3/10°A 6/0°v I= 1' + I" + I" +

A:

Q: Q3.C/ The breakdown voltage can be decreased by increasing the: Q3. D/ The junction is in thermal eq...

A:

Q: 1. Someone watches TV on average 5 hours each day. The TV is connected to a 220 V voltage so that th...

A:

Q: Find the equivalent impedence bewteen nodes A and B in the circuit. Express answer in both polar and...

A: In this question, Find the equivalent impedence bewteen nodes A and B in the circuit. Express answer...

Q: Article 1) 1.1 Find the electric charge density in the cylinder volume. with a radius equal to 10 ce...

A: The solution is given below

Q: energyguide labels are not required for TV's, ranges, ovens, and clothes dryers. Why do you think th...

A: Answer: No, it is a false statement. Energyguide  labels  are required for TV's, ranges,ovens, cloth...

Q: Q2: For the circuit shown in Figl, plot the waveform resulting at Vo. Assume an ideal diode model. D...

A:

Q: Q2: Given an nMOS transistor with Cox- 5F/mm2. L 0.25um, and w 2.5um. Find the total charge stored i...

A: It is Given that:CoX=5fF/mm2CoX=5×10-15F10-6m2L=0.25μm=0.25×10-6mW=2.5μm=2.5×10-6mVov=0.5V,VDS=0

Q: In a balanced three-phase Y-Y system, the source is an abc sequence of voltages and Van = 150 235° V...

A: Use per phase analysis to find line currents. Using line current obtained from above and ohms law fi...

Q: What is the overall signal-to-noise in dB of a tandem connection with the following individual signa...

A: Signal to nosie ratio (in dB )  when they are connected in tandem model is equal to sum of signal to...

Q: 3- Let ur1 = 2 in region 1, defined by 2r+3y-4z > 1, while µ2 = 5 in region 2 where 2r+3y-4z < 1. In...

A:

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.