Answered: What is the power output of a 92U 235…

What is the power output of a 92U 235 reactor if it takes 30 days to use up 3 kg of fuel? Given that energy released per fission is 250 MeV. and Avogadro's number = 6.023 x 1026 per kilomole,

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter10: Contactors, Relays, And Overloads

Section: Chapter Questions

Problem 19RQ

See similar textbooks

Related questions

Q: The two resistors have a total resistance of 30Ω when connected in parallel and a total resistance…

Q: A fuse wire of circular cross-section has a radius of 0.8 mm. The wire blows off at a current of 8A.…

A: We have been given as fuse wire with, Radius (r1) = 0.8 mm Blows off current (I1) = 8 A IF, Radius…

Q: ) A 200mA, 50Hz AC current source (of negligible output impedance) is connected across the same RL…

Q: An electric field E and a magneticfield B have the same energy density. (a) Express the ratio E>B…

A: Given data, The Energy density in electric field is given by ε0E22 Here ε0 is permittivity of free…

Q: 1GHz satellite antenna has an E-plane beam-width of 12º and on H-plane beam-width of 10°. The…

A: SOLUTION GIVEN--> Frequency f=1GHz…

Q: In 132 kV transmission system, the phase to ground capacitance is 0.01 µF. The inductance being 6 H.…

A: We have an 132 KV transmission line with, Phase to ground capacitance (C) = 0.01 μF = 0.01 * 10-6 F…

Q: 기아 장 ~ 154

A: Given, The circuit is,

Q: For the circuit of Figure 4.35 a. With the load RLOD disconnected, compute the open circuit voltage…

A: Given:

Q: 2) Determine the continuous-time signal that corresponds to the following Fourier Transforms (i.e.,…

Q: Lectures Ex19: For the circuit below, determine the voltage at the (452) resistor and the power at…

Q: What is the low frequency output resistance, Ro, in Q2 for the amplifier shown at 27° C with Rc =…

A: Given: RC=49.8 kΩ, RE=0.5 kΩ, RB=0.8 kΩ.IC=86 μA and β=30

Q: Ex19: For the circuit below, determine the voltage at the (42) resistor and the power at the (862)…

Q: The initial cost of an energy storage project is Rs. is 160 × 10^5. And after 20 years of useful…

Q: Three resistance of 40ohm, 60ohm and 80ohm are connected in delta. So find the equivalent resistance…

Q: P4.11d Find the damping ratio and natural frequency of the closed-loop transfer function. 20…

A: Given, The closed loop transfer function is, Ts=20s2+6s+144.

Q: Using Fourier transform,

Q: Consider an RC coupled amplifier at low frequency. Internal voltage gain is -120. Find the voltage…

A: Gain is the scientific name for an amplifier's output-to-input magnitude ratio. Gain is a unitless…

Q: From the figure below calculate the total charge due to the charge distributions labeled A (line…

A: Continuous charge distribution refers to the dispersion of charges along a line, surface, or volume…

Q: A 6 KVA step-up transformer having a turns ratio of 1: 4 has a primary voltage of 1000V.calculate…

Q: For the network of Figure 5.16, replace all inductors by a single equivalent inductor. _momo 35 mH…

Q: Fig. 37.17 shows 2-stage amplifier. What is the overall voltage gain in db? (1) 40 db (iii) 90 db…

A: Given a 2-stage amplifier,

Q: For the star connected 3-phase circuit shown in the figure below, the line-line voltage is 208 V rms…

A: Given- Line to line voltage VL=208 VPower absorbed P=432 WPower factor cosϕ=0.6 leadingTo find-The…

Q: The absolute true error when approximating p = 1.000 by p*= 0.978 is 0.032 0.022 0.002 O 0.22

A: Given, Actual or true value, p*=0.978 Approximating value, p=1.000

Q: Find ve, i, and ir 12 V Μ 1Ω VC 4Ω 5Ω 1F 2H3 Τ

Q: Q2) Infinite line charge of pu-5nc/m at X-1, Y-I and a sheet of charge of ps-3 nc/m² at y=-2, the…

Q: How do LED’s work?

A: LED: LED is semiconducting device. It is also a p-n junction diode. It is used to emit light in an…

Q: A 3-phase, 10 MVA, 11 kV generator with a solidly earthed neutral point supplies a feeder. The…

A: We have an 3-Phase generator with a solidly earthed neutral point which supplies a feeder. Positive…

Q: For the circuit shown in figure, the internal resistance r is given by www O a. O b. O C. O d.…

A: Given circuit,

Q: Find (Vo) and (lo) in the circuit below. 6A Α 2 Ω Μ lo 9] πολ 8 Ω Vo

Q: An ADC having a range of [0, 5] V. i. Determine the number of bits required if the minimum…

A: Given data, Range of ADC is 0 to 5 V, Resolution, Vr=0.61 mV = 0.61×10-3 V

Q: For the circuit of Figure 8.11, find the average power supplied by the voltage source, the average…

A: Solution !!

Q: An LRC resonant circuit is often called an oscillatorcircuit. What is it that oscillates?

A: RLC Oscillator circuit- For making RLC oscillator we will consider a circuit having two switch…

Q: 5. Approximately how many milliamperes of current flow through a circuit with a 40 V source and 6.8…

Q: what is a demagnetizing factor and what is it used for? does it have any dimensions or units? what…

A: ANSWER DEMAGNITIZATION--> .…

Q: Two lamps of 36 candle power and 6 candle power respectively are placed 2 meters apart. A screen is…

A: SOLUTION Given--> L1 = 36 candle L2 = 6…

Q: Frequency modulated signal with single-tone modulation has a frequency deviation of 15 kHz and…

Q: Compute the input resistance Rin of the inverting op amp amplifier shown in Figure 4.47 in terms of…

A: Given : Input resistance R1 Feedback resistance RF Input voltage Vs Output voltage Vo Find…

Q: An ADC having a range of [0, 5] V. i. Determine the number of bits required if the minimum…

A: Given Range = [0,5] V Tolerance = 0.61mV

Q: Example 2.9 The resistance of a long piece of copper wire is 48 2 at 20°C. a. What would the…

A: a. The temperature rise is degrees Celsius and the resistance increases 0.393% forevery degree rise.…

Q: SMF more efficient over long distances than MMF?

A: Given: Why is SMF more efficient over long distances than MMF?

Q: (b) A 12V 200, 2kHz AC voltage source of 5002 output impedance is connected to a load of impedance…

A: A voltage is being applied across a series of two resistors via a voltage divider. As the current…

Q: Compute the input resistance R₁ of the inverting op amp amplifier shown in Figure 4.47 in terms of…

A: Given:

Q: The resistance of a long piece of copper wire is 48 2 at 20°C. a. What would the resistance be at…

A: Given: Resistance of a long copper wire = 48Ω at 200C To do: a) we have to determine the resistance…

Q: 20. Find Rab in the four-way power divider circuit below. Assume each element is 192. 1 1 I ww ww 1…

Q: Is it option B? 1. In an open loop control system the control action is dependent upon; a) the size…

Q: A three-phase alternator has three armature coils, each rated at 1200 V and 120 A. What is the most…

A: Given, A three phase alternator has three armature coils. Phase voltage, Vph=1200 V. Phase current,…

Q: For given BJT, β=200. The applied input frequency is 20 Mhz and net internal capacitance is 100 pF.…

A: Given,For a BJT circuit,β=200.fin = 20 MHz.Cin = 100 pF.

Q: Determine the electrical conductivity and conductance of Aluminum cable (L) meter in length and 4 mm…

Q: Determine the Norton equivalent of the circuit drawn in Fig. 1 as seen by terminals a and b. 500 i…

A: Given:

Q: 23. A 20kn/V voltmeter reads 1V full scale. a. What series resistance is required to make the meter…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

What is the power output of a 92U235 reactor if it
takes 30 days to use up 3 kg of fuel? Given that
energy released per fission is 250 MeV. and
Avogadro's number = 6.023 x 1026 per kilomole.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Match the following Uranium Choose. IC engines Choose. Hydro power plant wind power plant Tidal power plant Coal Water Thermal power plant Diesel power plant Nuclear power plant
Why Pout will not increase bu 75% So why we did not use (1+0.75)(S)Pf and only we use 0.75(s)(pf) why we did not increase it ?
What should I do when I get a current like 0.263187845A, should I round into the simplest form, or keep it and convert into mA?
The resistivity of Cu at 0°C is 1.30×10-8 2m. The change in resistivity per degree Celsius is 0.02×10-8 Qm/°C. If resistivity of a Cu-10at%Ni alloy at 0°C is 5×10-8 Om, calculate the resistivity of Cu-40at%Ni alloy at 100°C. O 8x 10-8 Qm O 11 x 10-8 Qm 14 x 10-8 Qm O 17 x 10-8 Qm.
determine the value of zener power
A RAB- B 1 k 4 KIT k 2M0 6 km)
Exercise: What will be the o/p of the following meters? F.W.R H.W.R D'Arsonval Dynamo. meter PMMC PMMC meter meter meter E=10V 1) 2) 3
A voltage-multiplier has a Vm = 60 V peak sinusoidal secondary voltage. During the positive half-cycle, D1 conducts and D2 is cut-off, charging C1 up to what voltage level? C1 HE (A) OV B) 60 V V Ⓒ120 V (D) 180 V Vp 1:1 Vm = 60 V D1 D2 не C2 Ideal diodes C3 HE D3 D4 C4 :
Estimate thermal voltage for 30o C.
The Value of R1 is 39.4Ohms. explain
4. With reference to the Paschen curve below, Breakdown voltage (V) 60 55 50 45 40 35 30 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 pd (cm-torr) If a discharge at p = 0.1 torr, d = 20 cm is to be initiated, what is the voltage required to cause a breakdown? What will be the breakdown voltage if p = 0.025 torr, d= 20 cm?
Soru 3 Sır For uncontrolled half wave rectifier, R=80ohm, L=0.15H, Henüz f=50HZ and Vm3311V. 1. cevaplanmadı Calculate the rms current (A). 10,00 üzerinden işaretlenmiş UyC Soruyu Kala In your calculations, take 3 digits after the comma and take pi = 3,14; Enter your answer into the system in terms of the işaretle %D desired unit only as a number. Yanıt: