Answered: What is the different b/w solid type…

Engineering

Electrical Engineering

What is the different b/w solid type cables and pressure cables (oil and gas)...

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.16MCQ: In developing per-unit circuits of systems such as the one shown in Figure 3.10. when moving across...

See similar textbooks

Related questions

Q: What is a receptacle? What is meant by “service drop”? What are sets of service-entrance…

A: As per the guidelines given, we can only provide the solution of one question in multiple type of…

Q: Define and draw unit circle. What is the significance of unit circle for system analysis?

A: to draw and define unit circle significance of unit circle for system analysis

Q: Procedure

A: For a Buck converter Vo= DVs -(1) Vo is the out put voltage Vs…

Q: Draw & explain the single line diagram of a Typical A.c power Supply Scheme?

Q: What is a grounding conductor? What is a grounding conductor (equipment)? What is a grounding…

A: Grounding Conductor: A Grounded Conductor is a system or circuit conductor that is grounded on…

Q: Define the term "local wide network."

A: The given terms are as follows - 1. Local Network 2. Wide Network

Q: Subject: Electrical & Electronics Engineering Course: Power Systems Question: What is GMR and GMD?…

A: To explain GMR and GMD

Q: What are the wind turbine losses? How to minimize these losses? What is the role of SCADA system in…

A: Wind turbine losses: There will be electrical losses practised between the low voltage terminals of…

Q: What is the difference between modules and ways ? and how many ways we need to construct a…

A: The Electrical distribution system consists of some standardized terminologies in which the…

Q: () List any three factors to be considered for mechanical design of overhead lines

A: According to our expert policy only one individual question is to answered.kindlybrepost the…

Q: Why do we need to use the Bus Bar protection? Generalize the theory behind it

A: The power system these days has become quite complex and consists of many equipment operating in…

Q: Full introduction of Flexible AC transmission System (FACT) devices with illustrations

A: AC transmission System (FACT) devices : AC transmission System (FACT) devices is a system which…

Q: In electric transmission line, we can distinguish low voltages from high voltages through the…

A: For high voltage line the distance between them is also high compared to low voltage line for safety…

Q: the amount of real and reactive power that flow between any two buses is determine by the relative…

Q: sequence components o

A: For PU system- PU value=Actual value/Base value

Q: From the topic of insulation resistance testing of a transformer,(Layout of the Analog Insulation –…

A: Insulation resistance is used to determine the resistance between two points separated by the…

Q: n an ungrounded electrical systems with conductors installed in grounded metal raceways and…

A: In an ungrounded electrical system, there is no direct connection with the grounding electrode.…

Q: 2. What is meant by open and short concept in cabling?

A: When a potential is applied across the ends of a conductor (wire or cable), the circuit becomes…

Q: 3. What are the classifications of Core Loss and Copper Loss?

A: Electrical machines can be either generator or motors and transformers. They can be either Ac…

Q: Enumerate and discuss the standard criteria to be considered when designing overhead pole lines to…

A: Overhead Transmission line- Overhead Transmission line is define as cables which are used to conduct…

Q: Explain Basic Trip Circuit in Transmission line? Also, Discuss the Fundamental Requirements of…

A: Protection refers necessary isolationof healthy system from faultysystem, so that fault can not…

Q: Describe some of the factors that have contributed to the delays in undersea cable maintenance.

A: The underground cables play a major role in the internet flow in many of the country's.They are a…

Q: What is load curve

Q: Write the methods of Neutral Grounding.

A: The solution is given below

Q: 8. How do the terms ‘impedance drop’, ‘voltage drop’ and ‘voltage regulation’, in connection of…

A: Impedance drop: Impedance drop is the product of the current and the internal impedance. The…

Q: 2. What is the responsibility of MSC in cellular telephone system? a) Connection of mobile to base…

A: Correct option is b) connection of mobile to PSTN

Q: Discuss Suspension insulators are recommended in high voltage transmission lines.

A: Pin encasings become excessively cumbersome an uneconomical past 33 kV. Thus, for voltages higher…

Q: What is The amount of compensation to keep VR constant in power transmission line performance study?

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: What is the super tension cable and application,rating

A: In this question we are discussing about super tension cable and application,rating. This is…

Q: What is the phasor diagram of the voltages at bus one and two, in per unit, of the attached image?

A: A diagram of a two bas bur power system is shown in the question. We need to draw the phasor diagram…

Q: find the following parameters for the arcust below

Q: Construct a complete electrical plan layout of a residential type building which includes floor…

A: Here it is asking to construct a complete plan layout of a residential type building.And we also…

Q: Explain some of the factors that have contributed to the delays in undersea cable maintenance.

A: Communication is the exchange of information. Information can be imparted to either individuals or a…

Q: Why do we need Transmission system in various power plants and vehicles?

A: Transmission of Electrical power involves large transmission of electrical energy from power plant…

Q: node-voltage method

Q: . What is “accessible” as applied to wiring methods? What is “accessible” as applied to equipment?…

A: In an electrical system, there are various terms which are used for different phenomenon and gives a…

Q: define the conductor with examples

A: An electrical conductor is defined as substances that permit energy to float via them without…

Q: What precautions are practiced by electric companies in terms of loading capacity? When is a…

A: The precautions are practiced by electric companies are given as: Avoid water while operating with…

Q: The segment length for coaxial cable is -

A: COAXIAL CABLE: It is an electrical cable which transmits radio frequency (RF) signals from one point…

Q: C.Comments on this statement: "PMUs can be used as a protective relays”. D. What is the ZIB and it…

A: NOTE: Since we can solve only 3 parts, so solving 1st three parts. Sorry for the inconvenience…

Q: Discuss overhead and underground tranmission systems.

A: The name itself says Overhead means transmission from top, Underground means transmission from…

Q: What is a twisted pair cable?What are its two types and draw the sketch?

A: In radio frequency when disturbance in external source affects the electrical circuit by…

Q: bus. Real power and voltage magnitude are the quantities specified for

Q: define circuit breaker? Sfs circuit breaker? method for arc interaction in circuit breaker

A: When circuit breaker operates and open its contact then arc occurs between the contact terminals.…

Q: Explain why the low voltage problem at higher loading is more severe in an uncompensated over-head…

Q: open and short concept in cabling

A: In cabling, there may be a possibility of fault that can be classified into two: Open circuit fault…

Concept explainers

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.

Question

What is the different b/w solid type cables and pressure cables (oil and gas)...

The course is power transmission system and the topic is under ground cables...

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a string of suspension insulator with three units, the line unit has 20kV and k=0.35. The voltage across tower unit is........ and across middle unit is.......
A 30 kV single core cable has a conductor dimeter of 2 cm and a sheath of inside diameter 6 cm. Find the maximum (peak value) and minimum stress (peak value) in the insulation.
What is the maximum current-carrying capacity of a wire or cable?A. OvercurrentB. EnergyC. AmpacityD. Surge CurrentExplain why
What is a FACTS (Flexible Alternating Current Transmission System) device, and how does it impact power system operation?
What are FACTS (Flexible Alternating Current Transmission Systems), and how do they enhance power system performance and control?
9- The main reason of using O.H.T.L instead of underground cables to transfer power is a- reliability 10- Due to non-pure capacitance between conductor and sheath, so leakage current passes (true or false). ***....... b- cost C- stability
The figure below shows a ring distributor with interconnector BD. The supply is given at point A. The resistances of go and return conductors of various sections are indicated in the figure, current in the interconnector and *voltage drop in the interconnector are
1)What is a twisted pair cable?What are its two types and draw the sketch?
What are the limitations of solid type cables? How are these overcome in pressure cables?
A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.
What are FACTS (Flexible Alternating Current Transmission Systems), and how do they improve the control and efficiency of power transmission?
Single core cable design for 25 kV. The radius of conductor is 0.5 cm. The insulation material consists of two layers. The thickness of each layer is 2 cm. The voltage of first and second layers are 20 kV, 5 kV respectively. The minimum Electric stress of the cable is * 9.45 kV/cm 1.89 kV /cm O 1.25 kV/cm 5.78 kV/cm Non of them