VDD +15 V R₁ LAMP 3Ω 1 ΜΩ T MTV10N100E R₂ 2 ΜΩ Figure 12-55 14- The lamp of Fig. 12-55 is replaced by another with a resistance of 5 2. What is the lamp power when it is dark? PHOTODIODE

Q: (c) volts

A:

Q: 2. Power calculation In the following circuit element, it is known that Vab-10V, lab=-5A. Does the…

A: Given:

Q: A PV system uses 720 silicon PV cells connected in an array which supplies up to 120 V. .How many PV…

A:

Q: Adding resistance to armature decrease the starting torque. O True OFalse

A: By adding resistance to armature decreases the starting current not starting torque. The starting…

Q: The depletion layer width of SCR OIncreases with increase in junction temperature. O Decreases with…

A: An SCR is a semiconductor device which is commonly used in rectification purposes. It consists of 4…

Q: and b) Draw the S.F.G and obtain the transfer functions R₁ using Mason's gain formula. R₁(s) G₁ G₂…

A:

Q: Q2// Calculate the system response using:- a) Fourier Transform for the continuous signal shown in…

A: Given: Fourier transform of figure 1.

Q: (6) Apply Norton's theorem to find Vo in the circuit of Fig. 6 ΤΩ 4Ω ΜΕ 34 16Ω Figure 6 5Ω 12 V 10 Ω

A:

Q: In the following True or False and Multiple Choice problems, circle the correct answer. 1. One of…

A: As per our guidelines we are supposed to be the first three questions only. Kindly repost the other…

Q: The efficiency of a 1000kVA, 110/220V, 50Hz single phase transformer is 98.5% at a half load 0.8 p.f…

A:

Q: What we covered in Chapter 10 are called bilateral z-transform X(z). There 00 is also a thing called…

A:

Q: A 3-phase 11kv generator feeds power to upf load of 100mw through 3-phase transmission line. The…

A:

Q: To Do: GI 63 Ga G4 GS Hi

A: Given here a block diagram and asked to reduced it

Q: The value of resister R that makes the following bridge circuit balance is 2002 2502 2002 R 10 Q…

A:

Q: A single phase 220/6 Volt, 50 Hz transformer has a rated primary current = 0.5 A. its maximum…

A:

Q: For the network of Fig. 5.172: Determine AVNL?

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: For the two port network shown. Calculate Z₁, for maximum power transfer and 211 = 10 Ω Z12 = -20…

A: For the above given 2 port network we need to calculate the value of load impedance under the…

Q: SHOW YOUR COMPLETE SOLUTION, MAKE SURE YOUR ANSWERS ARE IN 4 DECIMAL PLACES. A uniform line charge…

A:

Q: An electric heater whose resistance is 40 ohms, has a current of 5 amps, and the amount of voltage…

A: Given  Electric heater R = 40 ohms I = 5 A

Q: 5. Determine the transfer function I.(s)/IT(S)

A: It is given that:

Q: When the input signal is AC voltage source reaches zero at every cycle, this will turn the thyristor…

A:

Q: An AC system with the frequency of 60hz is composed of 2 relays with 20 ohms resistance and 0.16…

A:

Q: R₁ P R3

A:

Q: Q.2) Consider the fixed-gate bias circuit of JFET shown below with the following parameters obtained…

A: The dc circuit is given below  Now we need to find dc parameter by dc analysis.

Q: A d.c. circuit usually has .......... as the load Oresistance Oinductance Ocapacitance hoth…

A: We know that a simple DC circuit usually consists of a current source (Usually battery) and one or…

Q: For the following toroid, the flux is 440μWb, r1= 8 cm and r2=12 cm. The flux density is O 0.0875 T…

A:

Q: 11. Find the magnetic flux density when a flux is equal to 28 x 10³ Maxwell is enclosed in an area…

A:

Q: A dc separate excited generator operate at speed = 1500 R.P.M at a certain excitation gives a…

A:

Q: The four resistors shown below in Fig.6 have the lengths and cross-sectional areas indicated and are…

A: In this question we need to choose a correct option . I.e - among option A , B, C and D which has a…

Q: 9. The generator power is always the maximum load power. c. equal b. less than d. greater than or…

A:

Q: (a) The typical starting current for induction motor (i.e., at s=1) is five to eight times of the…

A: Induction motor:- It is a AC  motor that runs at lower speed than synchronous speed so it is also…

Q: Q5) (A) If the length of the transmission line is one-quarter wavelength (1=2/4). Derive an…

A: Given  We need to derive input impedance of quarter wavelength transmission line. Please find the…

Q: The voltage 2,000,000 V can be expressed in powers of 10 as: (a) 2 mV (b) 2 kV (c) 2 MV (d) 2 GV

A: Given: Voltage, V=2,000,000V conversion system: 1000=103=K1000,000=106=M

Q: H.W: Find the exponential Fourier eries for the following functions. (1) = sint n -2π -TC D TT 2.TT

A:

Q: Power electronic controllers have OLow overhead capacity OHigh overhead capacity ONo overhead…

A: In this question we need to choose a correct option

Q: For the two port network shown. Calculate Z₁ for maximum power transfer and imum power delivered to…

A:

Q: The open circuit characteristics of dc machines is the relation between. O Torque and speed at…

A: Given data, Asking Open circuit characteristics of dc machine.

Q: 1.1 How many coulombs are represented by these amounts of electrons? (a) 6.482 x 10¹7 (b) 1.24 x…

A:

Q: Three responses are in figure below is true or False? Initial disturbance Initial disturbance f Time…

A: 1. This is false as it is overdamped to the desired value that is 0. If it was undamped then value…

Q: Q5) For the amplifier circuit shown in figure (4), calculate the voltage gain of each stage and the…

A: A cascaded connection is a head to tail connection of two or many circuit the output of the first…

Q: 14. Find f(t) of the following F(s) = 20s² + 141s +315 s(s² + 10s +21)

A: In this question we will find f (t) with the help of inverse laplace transform....

Q: Find the Fourier Series for the following common repetitive waveforms. a. Half-wave rectified sine…

A: Since you have posted multiple different question. we will solve the first question for you. To get…

Q: Determine the transfer function Io(s)/IT(S)

A: Given: Required: Transfer function I0sITs

Q: and b) Draw the S.F.G and obtain the transfer functions R₁ using Mason's gain formula. R₁(s) G₁ H₁ 2…

A:

Q: A varying current, with a periodic waveform, flows through an 8Ω resistor in accordance with the…

A: Heat dissipated =power ×time. Power =current2×resistance.  Using rms and average value integral…

Q: The voltage regulation of alternator can be regulated by changing its rotational speed. O True O…

A:

Q: 20. The quantity of charge that will be transferred by a current flow of 10 A over 1 hour period is…

A: Given, Current flow, i=10 A Time, t = 1 hour = 3600 sec

Q: 35. The vector field in sphecrical coordinate system: A= 9sin a0. Determine the value of its…

A:

Q: 6. Determine the transfer function V.(s)/Vi(s). R₂ WW voor +₂ Vils)ME R₁ C₁ tii + 62 HE Vo (s)

A: 6) To find the transfer function Vo(s)/Vi(s)

Q: Control System: Apply the 6 rules of Block Diagram and Show your COMPLETE solution in a step by step…

A:

Digital to Analog Converters

Digital to analog converters are commonly known as DAC, digital analog converter, D2A, or Digital-to-Analog converters. DACs are one of the important devices used in the electronics and electrical domain. DACs are the systems that convert a digital signal into an analog signal, whereas an analog to digital converter or ADC performs the opposite function. Digital signals are those signals that can represent the information or data as a set of discrete values. At a particular instant of time, a digital signal can only take a particular value of data. A digital signal is characterized by two unique values; zeros and ones, or true and false, represented by the Boolean domain. These are also known as binary signals or logic signals. Unlike digital signals, an analog signal is represented by continuous values, where at any time instant, the analog signal is represented by a real number.