Answered: v,(1) Current-limiting resistor VB…

v,(1) Current-limiting resistor VB -i(1) v,(1) Vm sin(mx) i(1) Figure 9.25 Half-wave rectifier used to charge a battery.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 4RQ: What is the difference between a diode and rectifier?

See similar textbooks

Related questions

Q: Question 4) A full wave controlled rectifier with ohmic load given in the figure below feeds a 10 Q…

A: Peak value of voltage(Vm)=2×VrmsAverage value of voltage, V0=2VmπAverage value of Current,…

Q: 11. A Zener diode is connected in a voltage regulator circuit as shown in Figure Q9. The Zener…

A: as per the guidelines, we supposed to answer one question at a time. so please ask other questions…

Q: Suppose we have a 10-V-peak sinusoidal voltage source. Draw the diagram of a circuit that clips off…

A: To cut-off both the peaks of sinusoidal wave, two level clippers is required. The general circuit of…

Q: d. Calculate the mean values of the load voltage and load current. e. Sketch the inductor voltage…

A: Given: A single-phase, fully controlled bridge rectifier supplies a series-connected…

Q: AC Load Supply Figure Q6a : Rectifier Circuit a) For the rectifier circuit shown in figure Q6a…

Q: An ideal single-phase source, 240 V, 50 Hz, supplies power to a load resisto R= 100 2 via a single…

Q: Q explain briefly with drawing the principal of zener region operation and the applications of zener…

A: consider the given circuit;

Q: A half-wave rectifier with ohmic load given in the figure below feeds a 50 2 load and the peak value…

A: Half wave Rectifier Load resistance 50ohm Peak value of source resistance 311V Frequency 50Hz

Q: Given the zener voltage at 9V and the zener power at 1W, what is the range of allowable values of Iz…

A: Given data, Zener voltage is given, VZ=9 V Zener power PZ=1 W

Q: Q ) For the full- wave uncontrolled rectifier circuit supplying a series resistive The supply…

Q: Consider a peak rectifier ted by a 50 Hz sinusoid having a peak value Vp-100 V. Let the load…

A: In this question we need to find a value of capacitor that will result in a peak to peak ripple of 3…

Q: What are the different integrated circuits? Describe their characteristics, advantages and…

A: When a set of electronic components mount on a small piece of semiconductor to perform some…

Q: Electrical Engineering Why we use Ag/A9CL electrode for recording and why we use Pt electrode for…

Q: A single phase bridge rectifier supplied from a 120V - 50 Hz sinusoidal source is connected to an…

Q: B The diodes in the full-wave DC power supply shown in Figure P9.44 are silicon. If I = 250 mA V =…

A: (a) Given circuit diagram is - Given values are -

Q: Some electronic devices operate on a DC voltage of 7.5 V. To obtain 7.5 V DC from a 120-V (rms) AC…

A: It is given that: Voltage in primary coils: Vprms=120 V Voltage in secondary coils: Vprms=7.5 V…

Q: Outline a method for solving a circuit that contains a single nonlinear element plus resistors, dc…

A: To explain the method for solving a circuit that contains a single non-linear element with resistors…

Q: Q13. What are the applications of LEDS?

A: 13) Applications of LEDs

Q: From the image provide find A) what is the emf and show the loops/junctions used. B) What is the…

Q: Suppose we have a 10-Hz sinusoidal voltage source, vin(t). Draw the diagram of a circuit that clamps…

A: Drawing a circuit that clamps the positive peaks to - 4 V

Q: Q13. What are the applications of LEDs?

A: LED stand for light emitting diode. It is a semiconductor device. When the current flow through it,…

Q: A chopper circuit in the figure, 400 ? (???) Control the power of an ohmic load from a 50 ?? source.…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…

Q: 9.(a) A three-phase, half-wave rectifier feeding a resistive load is supplied by a star/star type of…

A: In this question we need to find a firing angle of the given three phase half wave rectifier . For…

Q: A chopper circuit drives an inductive load from 390 DC supply. Given the load resistance as 8 Q, the…

A: Chopper: Chopper is the DC-DC converter which will transfer dc power from one circuit to another…

Q: 2. For the half-wave uncontrolled rectifier circuit supplying a series resistive- inductive load…

Q: . What are the main applications of using diodes in commercial power supplies such as laptop power…

A: Laptop is given single phase ac supply. The Ac power has to be converted to dc power via a converter…

Q: Q3 (a) With the aid of suitable drive circuitry and its waveform, briefly discuss the…

A: Single-phase fully controlled rectifier for separately excited DC motor: The circuit diagram for…

Q: The diode in the circuit shown in Figure P9.32 isfabricated from silicon andR = 2.2 kΩ VS2 = 3 V…

A: The diode as shown in the circuit P9.32 is made from a silicon material. For silicon material, the…

Q: For the circuit schematic below assuming an ideal switch, preform transient analysis to predict the…

Q: Q4) For the Zener regulated power supply shown below the rms value of vs is 15 V, the operating…

A: According to the question we have to find, Find Voutput & find the ripple voltage.

Q: Determine the value that the unknown emf (E) must have so that the potential V12 = 9v

A: Please refer the Attached images for the complete answer..

Q: O A Zener diode ideal i-v characteristic is shown in Figure P9.60(a). Given a Zener voltage, Vz of…

A: (a) First, find the region of operation of the Zener diode. Calculate the voltage across the diode.…

Q: OA chopper circuit drives an inductive load from 120 DC supply. Given the load resistance as 7 0.…

A: Since you are asking question with multiple sub-parts we will answer the first part for you. Supply…

Q: 15) The plot below shows the time dependent voltage trace for an unknown ac- voltage source. Using a…

A: For the given waveform as shown above Peak to peak voltage, peak voltage , RMS voltage , time…

Q: Below is a circuit containing a non-linear element; a) Determine the operating points (two) of the…

A: A) for Dc analysis, here you have to short circuit the Ac voltage source. here polarity od DC…

Q: please write introduction about Analysis of simple AC Circuits using MATLAB

A: MATLAB programming and simulink are used to analyze the network or circuit in theoritically before…

Q: 9.15 One of the more interesting applications of a diode, based on the diode equation, is an…

A: (a) Write the expression for the current iD in the circuit.

Q: Problem 1 (Source, Load and Battery). In the figure shown, a DC energy source generates power Pe to…

A: Q1 From the given description, The current delivered by the battery can be written in terms of…

Q: diode whose internal resistance is 20 ohms is to supply power to a 1000-ohm load from a 110V(rms)…

Q: For the circuit schematic below assuming an ideal switch, preform transient analysis to predict the…

Q: 8. How can you connect two LED diodes with different colors in parallel to the same DC power supply?…

A: This is a question related to basic electronics. Let us suppose, we have a LED diodes with different…

Q: Describe the difference between AC (alternating current) and DC (direct current). Use illustrations.

A: Difference between AC (alternating current) and DC (direct current)- Alternating Current (AC)…

Q: esign a battery charger for safe operation in a damp garage environment to use for charging your…

A: Input voltage, Vrms=110VInput voltage is alternating voltageTransformation…

Q: DESCRIPTION OF SIMILARITIES AND DIFFERENCES OF DC AND AC CIRCUITS WITH RESISTIVE AND CAPACITIVE…

A: The resistance is the measure of the ability of an electric component to oppose the flow of electric…

Q: Does Peak Voltage and Intrinsic Stand-off Ratio have dependency on other circuit parameters (such as…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Q 3/ We measured the current that appeared on the drawn screen as shown in the figure by using three…

A: Here,the three different current gauges are connected in series and they are, 1. De-Arsenval type 2.…

Q: A half-wave rectifier is needed to supply 15-V dc to a load that draws an average current of 300 mA.…

A: Given, Half wave rectifier having Average load current, IL=300 mA Peak to peak ripple required,…

Q: 1. What is the average voltage and peak-to-peak voltage for a given voltage having an equation of…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Question

Consider the battery charging circuit shown in Figure 9.25 on page 476. The ac source has a peak value of 24 V and a frequency of 60 Hz. The resistance is 2 Ω, the diode is ideal, and VB = 12 V. Determine the average current (i.e., the value of the charge that passes through the battery in 1 second). Suppose that the battery starts from a totally discharged state and has a capacity of 100 ampere hours. How long does it take to fully charge the battery?

v,(1)
Current-limiting resistor
VB
-i(1)
v,(1)
Vm sin(mx)
i(1)
Figure 9.25
Half-wave rectifier used to charge a battery.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the difference between a diode and rectifier?
What is CEMF?
How is a solid-state diode tested? Explain.
In a full wave rectifier circuit involving double diodes, a sinusoidal input signal of the following nature is applied e=10 sin(500*pi*t) V. What will be value of the dc voltage obtained at the output of the rectifier.
. A half-wave rectifier is needed to supply 15-V dc to a load that draws an average current of 300 mA. The peak-to-peak ripple is required to be 0.2 V or less. What is the minimum value allowed for the smoothing capacitance?
Q3/a/ what is the function of the inductance (L) in a single phase half wave thyristor ? b/ For 3 phase half wave rectifier source voltage is 100 sinwt with a = 40° find the Vav and draw the output voltage?
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to 220V rmsh soHz} VL-DC =20V 0.01 F 0.02 F 0.0167 F None of the above
Determine the a.c. ripple voltage across the load of full wave rectifier which delivers 40 W to a load resistance of 150 ohm, and ripple factor is given as 1% A) 77.4 V B) 38.7 V C) 0.387 V D) 0.774 V
You are asked to design a de power supply using a bridge full wave rectifier, as shown in Figure 1.d, to deliver a de voltage of Vo = 12 V to a 3 k2 load resistor with a ripple of less than 0.6 Vpp, where Vpp is the peak to peak voltage. The input voltage is a sine wave with frequency of 50 Hz. The diodes have a forward voltage of 0.7 V. i) Calculate the value of smoothing capacitor C. ii) Calculate the rms value of the input voltage, v(t). Figure 1.d.
3 Given the bridge-type full-wave rectifier circuit shown 220V 60Hz 220V:Es Es D1 D2 D3 D4 The load resistor is 220 and the transformer average current is 300mA. Determine: (a) Average value, RMS value, and frequency of load voltage VRL. (b) Average current and PIV of each diode. RL
A half-wave rectifier is needed to supply 15-V dc to a load that draws an average current of 250 mA. The peak-to-peak ripple is required to be 0.2 V or less. What is the minimum value allowed for the smoothing capacitance? If a full-wave rectifier is needed?
A single phase – half wave controlled rectifier with freewheeling diode is supplying a load consistingseries connected a resistor and an inductance from a 70.7V (RMS), 50Hz sinusoidal AC source.The firing delay of the thyristor is 90° and the load values are R=10Ω, L=0.1 H. Define the loadcurrent expression and draw the load current by calculating for first two periods. And calculate theaverage values of the load voltage and current.