В OBPHMua0J5eg/view O Discor S Home Schoology 34.) Apply Kirchhoff's current law and voltage law to the circuit shown below to identify the branch current 13. Express in four decimal places. 50 11 13 12 Ω 12 V 18 V F. E answer tance is connected in series with the r e battery source is rated 12 V, de or. Express in four decima

Q: Twr alenoting voltayas V = 100 Girn (ot -Z). Donw the phator diagram and find, by ealemlatimo A Ginu...

A:

Q: A 50 and 100 microfarad capacitors are connected in series and across 100sin(w+30) voltage. Write th...

A:

Q: aplace transform of the initial and final values ​​of the current i0(t) in the circuit in Figure 2. ...

A: Solution-  For t = 0-,  For this condition, the system is for long time with supply  of 4A only. Ca...

Q: 1. The unbalanced A-load below is supplied by balanced line-to-line voltages of 240 V in the positiv...

A: In this question Unbalanced three phase Delta load is given.  Find the line currents?  If line volta...

Q: PROBLEM 2: Four capacitors are connected in series with a battery shown in the figure. Simply the sc...

A:

Q: What is the important quantity to distinguish metals from insulators or semiconductors ?

A: Given: Metal, Insulators and semiconductors

Q: terminals in the circuit of Fig. 4.30. Then find I. 6Ω a ww Answer: V-Th = 6 V, RTh = 3 N, I = 1.5 A...

A:

Q: Given three impedance Z1=10 +j0 Z2 =3+j4 and z3=8-j6. Impedance z2 and Z3 are connected in parallel ...

A: If two impedances Z1,Z2 are connected in series than equivalent impedance is Z1 +Z2.  If two impedan...

Q: When the electric current through the DC motor is 2.0 A and the torque on the shaft is 0.34 Nm, the ...

A:

Q: Problem1) Determine the signal space representation of the four signals s (1), k = 1,2, 3, 4, shown ...

A:

Q: E The Probability density funetron (PA) of a signal is ginen by PCx) = ke 1x1 <4 otherwse a) what Ts...

A:

Q: A2 3:2 220V 1k V2 V3 1. What is V1 reading? 2. What is V2 reading? 3. What is V3 reading? 110V 146.6...

A: Rectifier circuit: This is used for converting the AC quantity into the DC quantity.

Q: For the three stage system with an input power Pin = -20 dbm and a power gains of the three stages a...

A:

Q: 2. For the unbalanced circuit below, find: (a) the line currents, (b) the total complex power absorb...

A: In this question Unbalanced three phase star load is supplied by three phase balanced load.  Find th...

Q: Question No. 2: Let z1 = 2 - j2 and z2 = 2 + j6 (a) Compute the polar form of z1 and z2. (b) Compute...

A:

Q: Modulation is the process of modifying a base signal with a carrier signal, and it is used mostly in...

A:   Given, In frequency modulation Carrier frequency (fc) = 570 kHz Amplitude of carrier signal (Ac) =...

Q: 3. In the circuit shown in figure below, the resistance R is random and uniformly distributed betwee...

A: The circuit shows a voltage source which provide supply to the constant resistance and R in form of ...

Q: Derive the truth table for a majority function which is generated in a combinational circuit when th...

A: The answer for the following questions are

Q: I=39 mA E=72 V R=8 kQ R2 R3 =6 kN

A:

Q: Vn R, 1.2kab KAככ 5Vי ,R = 3.3 k Rz= 2-242 E10 v 200 + E, -

A:

Q: Design of the voltage reference In lab 2 we found that a Zener diode can be used as a voltage refere...

A:

Q: Vx - vin i. RI Jwci VX -Ve R2 Vo = V2 = V de vive vi

A:

Q: Question 1-) A piece of crystalline silicon (Si) is doped uniformly with 2 x 1017 phosphorus atoms/e...

A: It is given that: ND=2×1017 atoms/cm3B=7.3×1015 cm-3 K-32Eg=1.12 eVk=8.62×10-5 eV/K 1 eV=1.6×10-19 V

Q: Yo 2-to-4 4 4-to-1 Decoder So MUX Y2 1/2 So C-

A: Multiplexer: It has many input and one output terminal so this is also called many to one.

Q: Identify and explain the different notational methods for describing the behavior of gases and circu...

A: Gates: It is an electronic circuit and has logical decisions based on applied input.  

Q: A 75 Ω lossless line is terminated in error with a 93 Ω resistor. A generator sends 100 mW down the ...

A:

Q: Solve the following system by any method 211 - 12 + 313 + 514 = 21 I - 213 + 14 = -1 511 - 512 + 13 ...

A: From second equation the value of I1 is given as: I1=-1+2I3-I4         (1) We will substitute the va...

Q: Given the notations F1 (A, B, C) = 1(0,1,2,4) F2 (A, B, C) = r(1,3,5,6) design a combinational circu...

A:

Q: Assume that an analog signal is given by a) x(t) = 5 cos(4 × 10°nt) + 3 cos(6 × 10°nt),t > 0 b) x(t)...

A: We need to find out the spectrum of sampled signal .

Q: Four capacitors are connected in parallel with a battery shown in the figure. Simply the schematic d...

A:

Q: 21.) Determine the Thevenin's Voltage (VTH) across the 3-ohm resistor at branch BE. A B 12 V 3Ω 2Ω D...

A:

Q: Calculate the difference in profit (Aprofit) between the case of CC1 and CC2 ( Aprofit = profitcci –...

A: Answer - Given - CC1 cost = $100 CC2 cost = $275 Pmpp  = 10 [W] Vmpp = 16 [V] Vbat = 12 [V]

Q: 10. Determine V, and Ip for the networks of Fig. 160. 20 V ID Si 12 V Ge Si GaAs oVo 4.7 k2 2.2 k2 4...

A: Forward voltage drop of Si diode = 0.7 V GaAs = 1.5 V Ge = 0.3 V

Q: Instrumentation Amplifier Circuit 2R, 1+ R. V. V1 out RG R, (4-2) R2 R3 R1 RG Vout R2 R1 R3 V2 13

A: Note: We are authorized to answer one question at a time since you have not mentioned which question...

Q: using K-map,minimimze the function f(x,y,z)=sop(1,2,4,6,7)

A:

Q: Design a three input NOR layout so that rise time and fall time become equal when input logic switch...

A: Given: A three-input NOR layout so that rise time and fall time become equal when input logic switch...

Q: 2Vp-p 10V If kr = Eripplerms/Eave, determine kr of the given waveform. а) 1 b) 0.5 c) 0.06 d) 0.3

A: We need to find ripple factor for given waveform .

Q: Find ix using Node Analysis

A: This question comes under electrical circuit theory . It is based on the concept of nodal analysis ....

Q: Rz Ri vina VX V2 find

A:

Q: A coil RL is connected in series with a capacitor across the 220 V, 60 hz, AC supply. If this circui...

A:

Q: StarDellatransformationa (A) 12V "S3p 630-1 A (A) 6802 6802 mA) Iy=7921MA. VLi=3.921 v Ie=3.96 mA Vi...

A:

Q: Activity 1: Try To Solve Me! Directions: Solve the following problems systematically. Write your sol...

A:

Q: the parallel connection of a resistor and a capacitor takes 0.6 A rms from a 120 V rms voltage sourc...

A:

Q: Calculate the intrinsic impedance of free space. Need it urgently.

A: In this case, the intrinsic impedance of free space is to be calculated. 

Q: How did he get the value inside the circle, can you explain step by step? ratio of SNR value over th...

A:

Q: Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine a- The nu...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: Exercise 2. An RCL circuit contains an aging battery generating E(t) = 10e-t/100 volt. The resistanc...

A: The solution is given below 

Q: The equivalent phasor domain representation of the equation of the current i = 60 Sin (100πt - 30°) ...

A: We need to draw the phasor for given current .

Q: Q1. For the circuit shown in Figure below find the maximum and minimum values of zener diode current...

A:

Q: A signal, x(t) is described by : X(t) = rect(1000t)*S0.002(t) X(t) is the input of an ideal lowpass ...

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.