Use nodal analysis to find vo in the circuit of figure below. 50 μF 10 cos 10³t V 20 Ω 20 Ω www 4i 10 mH 30 Ω

Q: give some specific applications of liquid crystal in the field of electronics. asap fast within 5…

A: Give some specific applications of liquid crystals in the field of electronics.

Q: 34. Develop a truth table for each of the standard POS expressions: a. (Ā + B + C) (A + B + C) (A +…

A: In the given questions we need to calculate the true table of the given pos expression.

Q: Question 1 1.1 Evaluate the transfer function / of the RC circuit in Fig.1 and sketch the # and…

A:

Q: Problem 1 Compute the Fourier transform of each of the following signals: cos(wot)]u(t), a > 0 (a)…

A:

Q: 4- The charactersitic and load impedances of a lossless transmission Line are Zo and Z₁ = = = Zo' a-…

A: The load impedance is given by; ZL=13Zo Here ZL is the load impedance, Zo is the characteristic…

Q: Q1: For the circuit of Fig. beside: a. Find the time required for vc to reach 60 V following the…

A: Source voltage; E=80 V Capacitance value; C=6 μF Resistance values; R1=8 kΩ R2=12 kΩ

Q: 12. four channels, two with a bit rate of 200kbps and two with a bit rate 150 kbps are to be…

A: Number of channels N=4, Bit Rate of 1st two channels 200 kbps, Bit Rate of other two channels 150…

Q: In the figure below, transistor Q2 is equivalent to 3 transistors in parallel, each of which is…

A:

Q: PROBLEM 2: A RTD is used to measure the temperature of an oven. The RTD forms one arm of a…

A: A Wheatstone bridge circuit with a RTD is given in the questions. The value of supply voltage is…

Q: E = 120 V, R2 = 10k ohms, VR1 = 50 V and IT = 13.5 mA. Find the value of IR1, R2, R1, and IR3. till…

A: In this question we need to find the current through resistor R1 , R2 & R3  and find the value…

Q: (a) Find I, in the network shown below using source transformation. 6. ΚΩ 6 ΚΩ www 6V 6 ΚΩ www 6 ΚΩ…

A: Given Data: A resistive network with, A voltage source and A current source To Find: The value of…

Q: Q-2: Below is the combinational circuit that implements the Boolean expression F a- Write the…

A: Asked to find a. Output of gate 2 and gate 3 b. Given inputs a=0,b=0, c=0 output of logic expression…

Q: P.6 The output resistance of a voltage series feedback amplifier is 10 22.If the gain of the basic…

A: We need to find out output resistance for given feedback amplifier .

Q: Assume a 20 MHz Fcy and a prescaler value of 8 for Timer2 operating in 16 bit mode. Also assume that…

A: Fcy=20 MHz.Prescaler value=8.Time period, T=5ms.

Q: The 555 timer connected in the monostable multivibrator mode: a) Design the circult to provide an…

A: The required value of resistor and capacitor needs to be calculated and the recovery time of the…

Q: The open loop transfer function of a unity feed back system is given by G(s) = (e-0.1s)/s. The gain…

A: Given: Open loop transfer function of a unity feedback system,  G(s)=e-0.1ss, To find: The gain…

Q: Q5 1-Find X₁(n) if X₁(ej) = 8(+2k). k=-00 2- Find hi(n) if H₁(e) = 1+2cos(w) + 3 cos (20)

A:

Q: A sinusoid with amplitude 8 has a minimum value of 9 . What is its maximum value?

A: We need to find out maximum value of given sinusoidal signal.

Q: Vo RO 1)D IO Î SINE(1.5m 3uA 1k) AC AC .tran 10m 3.3V CO 330n MicroPhoneInput VSS V2 3.3 R1 R3 VDC…

A:

Q: 10 20 50 Do a) let C = luf and find w and L j30 $-j40 b) find Vo(t) and (s(t)

A: In this question we need to find the following Value of w and L Vo(t) & is(t)  NOTE : In AC we…

Q: 2) Sketch the graph of f(t) = sin 2t - {u(t - π/2) – u(t − n)}|

A: Given a function to draw its function. Since the given function is a multiplication of sine wave and…

Q: Self inductance of an inductor with toroidal geometry is 268 mH. The total number of turns of this…

A: Inductance L=268 mH. Total number of turns N=36. Current flowing through inductor I=28 A.

Q: What are the basic components of Atomic Power Plant.

A: In this question we discuss the basic components of atomic power plant

Q: Match the items in List - I with the items in List - II and select the correct answer using the…

A: The list in the table,

Q: The 555 timer connected in the monosta le multivibrator mode: a) Design the circult to provide an…

A: The required value of resistor and capacitor needs to be calculated and the recovery time of the…

Q: Calculate the value of stored energy in an inductor if the value of inductance is 10 mH and 2 mA of…

A:

Q: X The instantaneous voltage across a circuit element is v(t) = 359.3 sin(cot +15°) volts, and the…

A: The given instantaneous voltage across the element is as follows. v(t)=359.3 sin (ωt+15°) V The…

Q: Question#1 Determine the voltage value of each source in the circuits of the figure below. Vs= 27 ΚΩ…

A: The circuit diagrams are shown below,

Q: Given a sequence x[n] = [2 1.5 3 -1] for 0 ≤ns 3. 1) Evaluate its DFT X(k) by definition 2) Assume…

A: 1) The sequence xn is given asxn=2  1.5  3  -1  for 0≤n≤3.This is 4 point DFT i.e N=4.

Q: Logic Equation Yl: Standard SOP The logic circuit :

A:

Q: me op amp in the circuit in (Eigure 1) is ideal. Suppose R-15 kl. ure 8k0 w w 25 kn 32 k 15 V -9V…

A: We need to calculate the output voltage expression, Vs max and min value for output will not…

Q: 1 G₁ - H₂ G₁ 163 Gu

A: We need to find the transfer function for the given SFG ( signal flow graph) SFG:- We know Mason's…

Q: (a) Use source exchange to determine V, in the network shown below. Η -j1Ω 12/6°ν (Ε 1Ω 2/04 (1) ·+)…

A: The given network diagram is shown below,

Q: 2. For the waveform of the voltage across a 10H inductor with an initial current of 0.5A a. Plot…

A: In this question We need to plot the current verse time graph in the inductor and power, energy at…

Q: The input and output voltages of an amplifier are 1mV& 1V respectively. If the gain with gative…

A: We need to find out the feedback factor and input impedance for given feedback amplifier.

Q: Question 2 Find Vo in the circuit shown using Thevenin's Theorem (note that 20001. = 2kIx). στ Μ ΚΩ…

A: We need to find out Vo for the given circuit  for given circuit.

Q: A 4 nF parallel plate capacitor is made with a dielectric with a relative permittivity of 8.  If the…

A: We need to find out seperation between plates for given capacitor .

Q: In Fig. 3.2b, under de conditions, calculate the current in each inductor, the voltage in each…

A: In this question We need to determine the all unknown parameters.  We know  Inductor act as short…

Q: 33. A conductor of length 15 cm is moved at 750 mm/s at right angles to a uniform flux density of…

A:

Q: An air filled parallel plate capacitor has a capacitance of 100 pF and a plate separation distance…

A: We need to find out the energy stored in capacitor for given electric field and capacitance .

Q: Calculate the reactive power consumed in the 50mH coil in the circuit where the voltage value of the…

A:

Q: Question- An iron ring of mean length 50 cm has an air gap of 1 mm and a winding of 200 turns. If…

A: An iron ring mean length = 50 cm Air gap = 1 mm Number of turns= 200 turns. The permeability of iron…

Q: Find the overall transfer function (Y(s)/X(s)) for the system below. Show all your work to reduce…

A:

Q: A Y-Y three-phase circuit is shown below. Solve for the following: Line current of phase b = Blank…

A: In this question,  We need to determine the line current and average power.  We know Current I= V/Z…

Q: .8: Obtain the Thevenin equivalent at terminals a-b of the circuit in Fig. 8.16. 120/75° V n -6 Ω 8…

A: In this question We need to determine the Thevenin equivalent across the terminal a and b.

Q: The voltage and current at the terminals of the circuit element in (Figure 1) are zero for t <0. For…

A: given voltage and current are for time t ≥0                                         v =…

Q: (a) Use Thévenin's theorem to find V, in the network shown below. 12/6v 2/6°A 1Ω -j1Ω + 1Ω Μ 1Ω Vo 0

A:

Q: In the circuit given in the figure, determine the value of is(t). Take Vs (t) = 25 cos (2000t) V. is…

A:

Q: Determine the Laplace transforms of the following continuous-time functions Show all work. a)…

A: In this question,  We need to determine Laplace transform of the given signal.  We are solving this…

Q: The convolution integral: y(t) = x(t)h(t) = x(7)h(t-1)dt = [h(t)x(t-r)dr Q1. Given g(1) and f(1) in…

A:

Current Division Method

The generalized current divider formula is given by the following relation below,