Answered: Type of voltage control method which…

Type of voltage control method which will reduce inductive reactance of the line is tap changing transformer booster transformer Shunt capacitor series capacitor

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter4: Symbols

Section: Chapter Questions

Problem 7SQ: The symbol shown is a(n) a. iron core transformer. b. auto transformer. c. current transformer. d....

See similar textbooks

Related questions

Q: Q) Three phase transformer having supply voltage 15 Kv (Line voltage). Determine the secondary phase…

A: Given data, Line voltage VL=15 KV Phaser diagram of line voltage and phase voltage is given by below…

Q: 18.a. Distribution transformers are generally protected from damage due to excessive internal…

A: Temperature increases in transformer is possible when transformer operating in overload condition.

Q: Which is the first equipment seen in the substation while coming from transmission system: a)…

A: A lightning arrester (also known as a lightning isolator) is a equipment is the first device…

Q: 22. In a single phase transformer Eddy current losses can be found by open circuit test Select…

A: to analyze the given condition

Q: Berry type transformer has has more than two magnetic circuits. Select one: O True False

Q: Single phase transformer rated for 24 kVA Primary is 12 kV, secondary is 480 kV • If a 10 Ohm load…

Q: A three phase, wye-delta connected, 345/34.5 kV transformer has an emergency rating of 60 MVA.…

A: Transformer is a device which is used to increase or decrease the input or output voltage which are…

Q: What is the difference between transformer and 3ph asynchronous motor

A: The primary and secondary windings of a transformer are known as the stator and secondary windings…

Q: what do you call an equipment that changes the voltage higher or lower without changing the…

A: => Capacitor bank :- It is used to improve the power factor of the system. => Switchgear…

Q: For three phase motor control the type of wire used for control wiring Select one: O 2.5 mm square,…

A: This question is related to Control wire size of the three phase motor.

Q: Identify statement below if its true or false. Statement I.Rotor frequency is independent of slip.…

A: To provide true or false statements from given

Q: Draw the connections for three phase transformer configuration listed below using single phase…

A: The three-phase transformer configure using three single-phase transformers as below, (a) Star/star…

Q: Auto transformer windings are wound on two separate limbs of the iron core True False 00

A: The explanation is as follows.

Q: Current situation analysis about transformer oil spew and due to stoms.

A: Transformer oil: It also called insulating oil. It is an oil that is unchanging at high…

Q: In which portion of the transmission system is the occurrence of faults more common a alternator B…

A: Answer:C transmission line

Q: Type of voltage control method which will reduce inductive reactance of the line is O booster…

A: In this question we will define which method reduce inductive reactance of line..

Q: Problem #2: A transformer is fed from a 100 MVA, 18 kV generator via a 5-cycle breaker. Generator…

A: Given S =100 MVA V =18 KV Xd'' =18%Xd' =25%Xd =120%

Q: In shall type of transformer windings are wound on two separate limbs of the iron core True False

A: We need to tell about the shall type transform winding .

Q: 3. When an alternator connected to a particular load the calculated voltage regulation is -10.6%.…

Q: 17.a. For commercial tests on transformers, direct current may be used for the A. induced-voltage…

A: 17.a. For commercial tests on transformers, direct current may be used for the polarity kick back…

Q: 7 In transformer, the open circuit test is used to determine the core loss. Select one: True False

A: Short circuit test in transformers is used to determine copper losses at full load.

Q: Ql-phase step down transformer 1250 KVA, 11000/2200 V, 50 Hz .The resistance /phase and leakage…

Q: A three-phase transformer bank has its low voltage terminals connected to a generator, rated 2.1 MVA…

Q: Voltage control method which works by improving voltage at any point in a line is .......... series…

A: Given Voltage control method is improve voltage at a point by

Q: Primary of Current Transformer is having large number of turns. Select one: True False

A: Current transformer is used to measure current in high voltage transmission line system. So…

Q: A three phase A-Y connected transformer with 50 MVA, 33:11 kV is protected with a differential…

A: When designing a relay, circuit breaker, or other protective equipment, keep in mind that power…

Q: Three phase transformer having supply voltage 15 Kv (Line voltage). Determine the secondary phase…

A: In the Delta type of winding connection, the line voltage and phase voltage both are the same but…

Q: Spiral type transformer has more than two magnetic circuits. Select one: O True False

A: Right Answer option True

Q: 25 kVA, single-phase transformer has 250 turns on the primary and 40 turns on the secondary winding.…

A: Transformer is static device which work on Faraday's Law of electromagnetic induction. The secondary…

Q: Duonse What will be the corresponding CT connection configuration for differential protection…

A: A current transformer is basically a transformer which steps down the main current through its…

Q: Which of the following pressure transducer works based on change in magnetic field? Question 9…

Q: A 3-phase, 6 MVA, 6.6 kV generator has a reactance of 0.1 pu. It is connected through a 6 MVA,…

Q: Calculate the primary leakage reactance of a transformer, supplying a load current of 10 A and 60…

A: Inductance = No. of turns×FluxCurrent Leakage inductance in primary = No. of primary turns×rms value…

Q: The shunt branches of are neglected to draw the reactance diagram. Generators O Transformer O Static…

A: Second option is correct. The explanation is provided below.

Q: A 220-kVA transformer with .2% resistance and 4% reactance and another 120-kVA transformer with 3%…

Q: Autotransformer has separate winding for both primary and secondary. Select one: True False

A: Auto transformer transformer which can able to adjust the Lotus as per the desired application.…

Q: A 100 KVA, 4000V / 200V, 50 Hz single phase transformer has 100 secondary turns. Determine (a) the…

A: The primary winding parameters of the transformer are: S1=100 KVAV1=4000 VN1=?f=50 Hz The secondary…

Q: The plant capacity of a 3Ø generating station consists of two 10,000 KVA alternators of reactance…

Q: Which of the following loss is the main reason for not using the solid transformer core? O…

Q: Q)-Indicate whether the following statements are true or false True False During short circuit test…

A: During short circuit test iron losses are negligible because the voltage applied on the primary side…

Q: Part A: Transformers A transformer core is constructed from sheet steel and the manufacturer's data…

A: The solution is given below

Q: In single line diagram of substation, the following symbol is used for O Lightning arrester O…

A: For a three-phase electric power system, single line diagram is a symbolic representation. It is…

Q: Voltage control method which works by improving voltage at any point in a line is O tap changing…

A: To maintain a constant voltage profile in the transmission line, it is important to do compensation…

Q: a single phase transformer, when no-load voltage is 230V and full load terminal voltage is 220, then…

A: In this question , we have to find that given voltage regulation is correct or not...

Q: 4. A 220-kVA transformer with .2% resistance and 4% reactance and another 120-kVA transformer with…

A: Since question 5 is incomplete i solve only 4. Please explain what is a1 and a2

Q: 13. A generator rated 30 MVA, 11 kV has a direct-axis subtransient reactance of 0.3 p.u. the…

A: Fault current=(3×pre fault voltage)/(X1+X2+X0). Where X1 =positive sequence reactance…

Q: single-phase transformer with a voltage regulation of 4% has a secondary terminal voltage of 115.4…

A: We need to find out voltage under no load condition for given regulation

Q: A 5 KVA 220/110 transformer has the following parameters. Ri -0.25Ω , Χ -0.75Ω, Reι -720 Ω , Xm1-180…

Q: Q19 Complete the answer : .............. transformer has double magnetic circuit.

A: The core type transformer have double magnetic circuits.

Q: A 5 KVA, 200V/400 V, single-phase transformer has a secondary terminal voltage of 385.5 volts when…

A: Given data, A single phase transformer has S=5 kVAV1/V2=200V/400VV2fl=385.5 V

Concept explainers

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.

Question

Choose correct answer

Type of voltage control method which will
reduce inductive reactance of the line is
tap changing transformer
booster transformer
O Shunt capacitor
series capacitor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Seconday winding of transformer is made-up of material. O insulated CRGO conductor O insulated copper conductor O Cold Rolled Grain Oriented (CRGO) conductor Cold Rolled Grain Oriented (CRGO) Silicon Steel
Help me to solve the average current, peak current, transformer
In no load phasor diagram of practical transformer, the magnetizing current is with primary voltage Vp. O In phase O Leading by 60 Degrees O Lagging by 60 Degrees O 90 Degree out of phase
What is the relationship between primary induced emf( E1) and applied voltage (V1) of a Transformer? O a. Both are unequal and in phase O b. Both are unequal and 180 degree out of phase O c. Both are equal and 180 degree out of phase O d. Both are equal and inphase
A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 10N. The output voltage of the rectifier is 400 V DC. The rating of source side of three phase delta – star transformer is, (a) 14.875 kVA (b) 16.765 kVA (c) 15.475 kVA (d) 16.025 kVA
Voltage control method connected across the load, to supply part of VAR required is ..... O Shunt capacitor O tap changing transformer O series capacitor O booster transformer
A voltage multiplier has 12 stages Capacitances, all equal to 0.08 μF. Thesupply transformer secondary voltage is 150 kV at a frequency of 100 Hz. Load current 0,006A.What is the percentage ripple, the regulation and the optimum number of stages for minimumregulation or voltage drop.
How do i calculate secondary current in transformer analysis
In no load Phasor diagram of practical transformer, the iron loss current Ic is with flux 0. In phase O 30 degree out of phase 60 degree out of phase 90 degree out of phase
The direct electrical connection of the windings allows transient over voltages to pass through the auto transfonner more easily, and that is an important disadvantage of the autotransformer. (a) True (b) False
A single-phase, 50-kVA,2400/240-V,60-Hz distribution transformer has the following parameters: Resistance of the 2400-V winding: R1=0.75 Resistance of the 240-V winding: R2=0.0075 Leakage reactance of the 2400-V winding: X1=1.0 Leakage reactance of the 240-V winding: X2=0.01 Exciting admittance on the 240-V side =0.003j0.02S (a) Draw the equivalent circuit referred to the high-voltage side of the transformer. (b) Draw the equivalent circuit referred to the low-voltage side of the transformer. Show the numerical values of impedances on the equivalent circuits.
The ratings of a three-phase three-winding transformer are Primary(1): Y connected 66kV,15MVA Secondary (2): Y connected, 13.2kV,10MVA Tertiary (3): A connected, 2.3kV,5MVA Neglecting winding resistances and exciting current, the per-unit leakage reactances are X12=0.08 on a 15-MVA,66-kV base X13=0.10 on a 15-MVA,66-kV base X23=0.09 on a 10-MVA,13.2-kV base (a) Determine the per-unit reactances X1,X2,X3 of the equivalent circuit on a 15-MVA,66-kV base at the primary terminals. (b) Purely resistive loads of 7.5 MW at 13.2 kV and 5 MW at 2.3kV are connected to the secondary and tertiary sides of the transformer, respectively. Draw the per- unit impedance diagram, showing the per-unit impedances on a 15-MVA,66-kV base at the primary terminals.