Two alternators A and B operates in parallel and supply a load of 10MW at 0.8 lag power factor. By adjusting the steam supply of A and its power was adjusted to 6000kW and by adjusting its excitation, its power factor is now 0.92 lag. What is the power factor of alternator B

Two alternators A and B operates in parallel and supply a load of 10MW at 0.8 lag power factor. By adjusting the steam supply of A and its power was adjusted to 6000kW and by adjusting its excitation, its power factor is now 0.92 lag. What is the power factor of alternator B

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Related questions

Q: A DC series generator delivers a load of 20 kW at 400 V. The armature and field resistances are 0.3 ...

A: A DC generator is an electrical device used to produce current. The primary function of this device ...

Q: +20 V Re || R A, : Rc 12 KΩ R 150 k R 50 k hFE = 200 R2 20 k RE 2.2 k

Q: Which of the following is used to reduce the compounding of a DC generator? O Inverter Diverter Comm...

Q: 10. Determine I. + - 21 12V 203 V 6A

Q: For the circuit in Fig. 4.76, find the terminal voltage Vab using superposition. 4.8 3V ab 102 o a 4...

Q: Calculate the total impedance (Zin) in the circuit shown below. Assume the given frequency is 50 Hz ...

Q: What is a pmos current mirror?

A: The current mirror is an analog circuit that detects the current reference and produces a copy or nu...

Q: estion 2-) Assume an aluminum line runs diagonally from one corner of a 30 mm x 30 mm con material t...

A: Given thatResistivity ρ=2.82μΩ-cmArea =thickness×width A=2×10-6×4×10-6A=8×10-12m2l1=30mml2=30mm

Q: PROBLEMS this data and Vth, determine the Thévenin resistance, Rth, for our original circuit. A TB R...

A: As per the guidelines of bartleyby I have to answer first question only. Here the first question is ...

Q: c. Amplitude spectrum of x(n) for 0 <= n <= 1 with x(0) = 1, x(1) = 1 is Ak with AO = 2, A1 = 0. %3D...

A: (c) Amplitude spectrum of x(n) for 0 <= n <= 1 with x(0) = 1, x(1) = 1 is Ak with A0 = 2, A1 =...

Q: What is threshold voltage?

Q: Calculate the total impedance (Zin) in the circuit shown below. Assume the given frequency is 50 Hz ...

Q: V1 D1 R1 R2 1ka 2k0 10 V Figure 3.

Q: A three phase, 4 - pole, 50 Hz induction motor has full load speed of 1455 rpm. What will be the fre...

Q: Design a full-wave rectifier with LC filter to provide 10 V dc at 100 mA along with maximum ripple o...

Q: Find the electric field at P( 6,-3, -4) due to Q1 = -30uC at (2,3, -6) Group of answer choices a...

Q: a. Determine AVNL, Zi, and Zo b. Determine AVL and AVS C. Change RS to 1kQ. What is the effect on AV...

A: We need to find gain, input, output impedance for given circuit

Q: A three-phase, 4-pole, 1,500 rpm alternating having a double layer-windings with 18 turns per coil. ...

Q: Please Answer: Itotal I2 I1 Vtotal

Q: 2. Draw and label the Thévenin equivalent circuit that represents the circuit shown below, as seen f...

Q: In a parallel RL circuit, R = 10 , L = 40 mH and v = 110 sin(377t + 45) V. Find i.

Q: (a) In a 3-phase balanced system shown in Figure 3(a), two wattmeters are used to measure the power ...

A: (a) The load is delta connected and line current in each phase is given as: Ia=Ib=Ic=15A as the load...

Q: 1. A building, supplied by a public utility, contains three balanced loads connected to the three-ph...

A: SOLUTION:- V3-ϕ =4.16 KV , V1-ϕ =4.16K3=2.402KVSdelta = 500KVA ,0.85 lag ; ...

Q: 39. Using branch current analysis, find the voltage drop across the 1 kN resistor in the figure show...

A: If we consider I1 as current flowing in the first loop in clockwise direction and I2 is the current ...

Q: ductance of 0.4HH. On being connected to a 220-Vdc supply, it draws 1.0 A from the mains sand runs a...

A: Given, Armature resistance(R) = 20 ohm Inductance (L) = 0.4H DC ...

Q: In a superheterodyne receiver, the incoming RF signal is at 25 dBµ, the RF amplifier has a 30 dB gai...

Q: Procedure: 1- Generation of AM- DSB-SC with multiplier: • Connect the circuit as shown in Fig.(4-6) ...

A: As per our company guidelines we are supposed to answer only first question kindly repost other ques...

Q: d) Given the following ASK signal (Note: vertical lines denote bit divisions): (single bit)) (Lower ...

Q: Treat D1 as silicon diode. Solve for ID, VR2, and IR1.

A: Given circuit, As D1 as silicon diode, so VD1=0.7 V

Q: 10Ω 0.05 Η : 10 Ω 5Ω V 400 μF 0.02 Η

Q: Find out the Laplace Transform of the following function: z(1) = e u(t) -551

Q: Find out the Laplace Transform of the following function: z(1) = e s, z(1) = e $'u(t) -551 n.

Q: H.W 5: Evaluate the steady-state error for the system described by the following equation for unit s...

A: SOLUTION- Transfer function (T(S)) = C(SI-A)-1B FIRST CALCULATE (SI-A)-1 SI-A = s000s000s--5100-21...

Q: Find the electric filed intensity at P(4, -3, 1) due to: Ps1= -3nC/m2 at y=2 Ps2= 5 nC/m2 at y=-4 ...

A: We need to find out electric field at given point due given surface charge density.

Q: Find out the Laplace Transform of the following function: z(1) = e **u(t) -551

Q: 2. A voltage source of v(t) = 340sin(2n60t) V is applied to a nonlinear load, resulting a current i(...

Q: Oil flows full bore at a velocity of 2 m/s through a nest of 16 tubes in a single pass cooler. The i...

A: we have givenOil flows full bore at a velocity of 2 m/snumber of tubes =16diameter of the tubes is 3...

Q: At 300 K, an ideal solar cell has a short circuit current of 3A and an open circuit voltage of 0.6V....

Q: For a silicon pn junction with T = 300 K, determine the diode current. The Is (reverse saturation cu...

Q: A DC series generator delivers a load of 20 kW at 400 V. The armature and field resistances are 0.3 ...

Q: A 0.05 S B 0.02 S 0.2 AT 0.01 S 0.5 A

Q: Calculate the percent voltage drop in a 500 KVA transformer having 2% resistance and 4% reactance wh...

Q: Find Io

Q: Whats oms law??

A: Given: Ohm's law

Q: Let f = xy'z' + x'yz' + xy'z + xyz + x'y'z a) Write f as sum of minterms m¡ i.e.f = > m( , ,...) b) ...

Q: Question 4. Z, = (10+ jl7.32)N , Z, = (20+ j34.6)N, Z,=(25+ j43.3)N, %3D Z, = (10+ j17.3)N, Determin...

Q: b) Forthenetwork shownin the belowfigure, a voltmeteris connected across terminals A and B. Thevoltm...

Q: 4. For the network of Figure 4, determine: a. VB b. VC c. VE d. IE e. IB f. IC g. VCE

A: The given circuit diagram is shown below:

Q: R1 9V 3Ω R3 10 +1

A: Brief description : In the above given question they have mentioned an electrical circuit which cons...

Q: 23. A coil of copper wire has resistance of 90 Q at 20°C and is connected to a 230 V supply. By how ...

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The winding data for three different alternators are as follows I. 60 slots, four poles, span 1 to 9 II. 120 slots, six poles, span 1 to 16 III. 144 slots, eight poles, span 1 to 11 The windings having a pitch factor less than 0.9 are O a. I, I and II. O b. I and III only O c. I and II only O d. I and III only
The winding data for three different alternators are as follows 1. 60 slots, four poles, span 1 to 9 II. 120 slots, six poles, span 1 to 16 II. 144 slots, eight poles, span 1 to 11 The windings having a pitch factor less than 0.9 are a. I and II only b. I, Il and III. c. I and II only d. Il and III only
The winding data for three different alternators are as follows I. 60 slots, four poles, span 1 to 9 ed dout of II. 120 slots, six poles, span 1 to 16 III. 144 slots, eight poles, span 1 to 11 The windings having a pitch factor less than 0.9 are O a. Il and III only O b. I and Il only O .I, Il and II. Od.l and III only
The regulation of an alternator is likely to be negative in case of resistive load O True O False
An alternator is at lagging power factor when it is normally excited O True O False
Two 800kW alternators A and B operating in parallel. The speed regulation of A is 100% to 103% from full load to no-load and that of B is 100% to 104%. Determine the kW share of A if the total load is 1200kW.
The reactive power output of an alternator is limited by load angle True False
The voltage generated across one inductor of an alternator is 8.11V. There are 120 slots and 4 turns in every coil. The conductors are all in series and connected in double layer lap windings distributed sinusoidally in several slots. The coil pitch is 10 slots, frequency is 60 Hz and synchronous speed is 720 rpm. Calculate the line-to-line generated voltage if the alternator windings are connected wye.
A three phase star connected alternator has a resistance of 0.5 ohms per phase and a synchronous reactance of 5 ohms per phase. It is exited to give 6600 V (line) on open circuit. Determine the terminal voltage and voltage regulation on full load current of 130 A when the load pf is (i) 0.8 lagging (ii) 0.6 leading pf
A three-phase, star-connected alternator has 8 number of poles, armature with 160 slots and 2 conductors per slot. The speed of rotation is 1000 rpm. The flux per pole is 0.06 weber. If the winding factor is 0.94 and all the conductors in each phase are in series. Calculate a) Frequency of generation b) Number of turns c) EMF generated (phase voltage) d) EMF generated (Line voltage)
A single phase alternator has a rated output of 500 KVA at a terminal voltage of 3300 V. The stator winding has a resistance of 0.6 ohm and synchronous reactance of 4 ohms. Calculate the voltage regulation for full load at a pf (i) unity (ii) 0.8 leading (ii) 0.8 lagging
What are factors on which induced EMF of an alternator depends? h (United States)