Trial 1 Trial 2 12. Molarity of hydrochloric acid, M: 0.02M 0.02M I. 13. Initial buret reading before HCI addition, ml: OmL OmL 14. Final buret reading after HCl addition, ml: 31.5mL 30.2mL 15. Volume of hydrochloric acid used, ml: 31.5mL 30.2mL 16. [OH]in saturated Ca(OH)2 solution, M: 17. Calculated solubility product from titration: 18. Average value of solubility product from titration: 19. Literature value for solubility product of calcium hydroxide: 5.5x10-6

Q: Trial 1 Trial 2 Volume analyte (mL) 52.8 54.68 Volume titrant, final (mL) 14.68 14.55 Volume…

A: Given: Volume of analyte(citric acid) is 54.68 mL. The volume of titrant(NaOH) is 14.04…

Q: In the next part of the experiment, you used the standard solution of sodium oxalate to standardize…

A:

Q: Part A: Complete the flow chart with the steps necessary for preparing the pH probe. pH Probe…

A: pH probe cleaning and reading: (i) Electrode is rinsed with water. (ii) Then it is Blot dried by…

Q: How many milliliters of 0.10 M Pb(NO 3 )2 should be used to make ni(en)(h2o)4so4 10% mole excess?

A: This question must have a known value of the amount of Pb(SO4)2 produced.... So see the complete…

Q: TITRATION DATA In the next part of the experiment, you used the standard solution of sodium oxalate…

A: The given reaction is, 2 MnO4-+5 C2O42- + 16 H+ →2 Mn2+ + 10 CO2 + 8 H2O Given that: Molarity of…

Q: Find % error in your experiment if theoretical molarity of HC2H3O2 is 0.975 M. Show work. 5mL of…

A: For Acid-Base titrationMolarity is given

Q: Titration data   Trial 1 Trial 2 Trial 3 Initial burette reading (mL) 1.19   2.26   2.39   Molarity…

A: To calculate ,we would use the give data values.

Q: lews SEC # Evaluation of Commercial Bleaching Solutions 22 DATA SHEET Brand name of commercial…

A: Concentration of NaOCl = M1 = 0.175M VOlume of NaOCl = V1  Concentration of KI = M2 = 0.225M Volume…

Q: Trial 1: Initial pH= 3.92mL Mass of KHP and Paper= 0.868g Mass of paper= 0.357g Mass of KHP= 0.511g…

A: The titration curves given for both the trials are,

Q: Name Date Lab Section Results and Discussion - Experiment 3 - Acids and Bases: Analysis A. Analysis…

A: The balanced equation for the reaction of vinegar (CH3COOH) with NaOH(aq) is: CH3COOH(aq) + NaOH(aq)…

Q: I'm not sure how to solve for Molarity of NaOH and average molarity of NaOH

A: Molarity = no of moles per unit volume  Given  Volume.of acid = 25 mL  Molarity of acid = 0.0762 M…

Q: 1 pause ↑ shift pg dn end del Mg2+. Ammonium sulfate is added to the known cation solution and the…

A: The white precipitate, in test tube #1, is BaSO4 and on addition of HCl it gives green flame test it…

Q: With the attached data, how do I calculate the number of moles of HC2H3O2 in 5.00mL of vinegar?

A: Given:Molarity of NaOH = 0.2012Volume of NaOH = 21.20 mLVolume of HC2H3O2 = 5.00 mLChemical reaction…

Q: A drug is ordered to be administered IV at the initial rate of 4 mU/min, and may increase by 2…

A: Initial rate = 4 mU/min. Rate in 15 min. = 4 mU × 15                           = 60 mU  Rate in 60…

Q: Molar concentration of KMNO 0.02000 M 0.2189 3 7mL 0.3 mL 36.7mL Branhish Weight of complex iron…

A:

Q: Table 1: Volumes in of iodine in mL used to titrate mixtures of 10 mL of reaction mix and 10 mL of…

A: Given :            CF = 1.06           TVS (mg/hour) = x (ml) X CF ( mg vit.C/ mL iodine ) X TV (mL/…

Q: 1. Molarity of the NaOH solution 0.238 mol/L Trial 1 Trial 2 Trial 2. Volume of H;PO4 added to flask…

A: The given problem is titration of NaOH Vs H3PO4. Given Molarity Of NaOH=0.238mol/L

Q: Why is it necessary to immerse and store the pH meter in saturated KCl? What is the purpose of…

A: pH meter is an instrument which is used to measure the pH of any solution. Since it is an instrument…

Q: Phenolphthalein Trial Bromcresol Green Trial Final Volume 26 Initial 50 50 Volume Volume Used…

A: Calculation of moles for NaOH, H3PO4 can be calculated as given below.

Q: I need to know: 1. moles FeNCS2+ at equilibrium (10mL) (mol) 2. moles Fe3+, reacted (mol) 3.…

A: Solution: Here first we write the given reaction for the reference.  Fe3+ (aq) + SCN- (aq) ====>…

Q: Methodology: Make schematic diagram for the procedure below B. % SO3 determination Dry the soluble…

A: We need to make a schematic diagram for the given procedure.

Q: If pH (± 0.5 pH units) strips were used to determine the equivalence point at pH=8.5. What is the…

A: The method you have done and all this is fine and correct. There may be some other problem like…

Q: Table 8.1 Hardness determination of water samples. mL of Volume of NazH2Y 2 H2O, mL Ca2+, mg/L…

A: First you have to standardize the EDTA solution before the titration of hard sample solution. Let…

Q: Given the following data Dissolved Oxygen Titration Data Trial 1 Preparation of titrant 0.4455 g…

A:

Q: Trial 1: Initial pH= 3.92mL Mass of KHP and Paper= 0.868g Mass of paper= 0.357g Mass of KHP= 0.511g…

A: 1)   At half-equivalence point of the titration, pH=pKa

Q: With the attached data, how do I calculate the mass percent of vinegar?

A:

Q: Trials 1 2 Volume of aliquot of standard CaCO, solution 25.00 25.00 25.00 (ml) Volume of titrant,…

A: Given ; Volume of CaCO3 solution = 25.00 mL = 0.02500 L                             (since 1 L =…

Q: In the next part of the experiment, you used the standard solution of sodium oxalate to standardize…

A: The data given is,

Q: REPORT SHEET Trial Volume of Acid used ( mL) 20.0 20.C 1. 0.10 0.10 2. Molarity of acid used (M) 3.…

A: At equivalence point : Equivalents of acid = equivalents of base For monovalent acid and base: moles…

Q: Titration Data KHP Mass of KHP: 0.5370 g Total volume of KHP solution: 25.00 mL Titration #1 –…

A: Vinegar is acetic acid dissolved in distilled water thus, the concentration of acetic acid in…

Q: Volume HCl (mL) 25.00 а. 0.00 b. Initial buret reading (mL) 25.40 c. Final buret reading (mL) 25.40…

A: Equation  NaOH(aq) + HCl (aq) ——> NaCl (aq) + H2O(l)   Molarity = no. of moles / volume (Lt)

Q: Assuming that the concentration of NaOH is 0.1M Analysis of acetic acid   Trial   1 2 Volume…

A: Given: Concentration of NaOH = 0.1 M

Q: TITRATION DATA In the next part of the experiment, you used the standard solution of sodium oxalate…

A: Calculation formula, 5M1V1= 2M2V2 M1=molarity of KMnO4 solution M2= molarity of oxalic Acid…

Q: STEPS IN A TYPICAL ANALYTICAL QUANTITATIVE ANALYSIS Select a method 2. Is sample soluble? 3. yes 5.…

A: Flow diagram Quantitative analysis.

Q: Test Tube Add First and note appearance Then add... 1 mL of 0.01 M KMNO4 plus 6 drops of 6 M H2SO,…

A: The given reactants are K2Cr2O7 and H2SO4.

Q: Solve for the dissolved oxygen content of the water sample in Day 1 if the Na2S2O3 titrant (0.1152…

A: Introduction :  Oxygen gas has some solubility in water,so the amount of oxygen which is present in…

Q: Data & Results: Complete the table. TRIAL 1 TRIAL 2 TRIAL 3 Wt. of vinegar sample Vol. of vinegar…

A: % CH3COOH = Normality of NaOH * Volume of NaOH * Eq wt of CH3COOH * 100 / Weight of sample

Q: solubility

A: Borax : Na2B  Na2B <-------> 2Na+(aq) + B^2-(aq)  At Equilibrium : [Na+] = 2s and [B^2-] = s…

Q: Typewritten for an upvote. No upvote for handwritten. Please skip if you have already done this.…

A:

Q: How do I find the total moles of Cl in 100 mL flask and the Cl concentration? I don’t know if I need…

A: Dilution factor:

Q: 40 mg of sodium hydroxide is required to saponify Igm sample, this means that (MW of NaOH= 40…

A: Given data contains, Milligrams of sodium hydroxide is 40mg. The correct option has to be given.

Q: Type of acid in unknown: H3A Balanced chemical equation for neutralization of acid with NaOH Saved…

A: Average concentration of NaOH    = 0.000105 M

Q: Trials 1 2 3 Volume of aliquot of standard CaCO, solution 25.00 (ml) 25.00 25.00 Volume of titrant,…

A: Titer for trial 1 is determined as shown below.

Q: Prepare a standard curve from the data below from a Bradford assay. Samples were prepared from a…

A: Use the conversion factor 1000 μg1 mg to convert amount of protein in mg to μg. Example:   2.5 mg…

Q: Phenyi Chromic Acid Semicarbizide mpt UNKNOWN DNP test Tollens Benedicts Schiffs derivative mpt…

A: IR spectroscopy and chemical tests are two important tools for the functional group determination of…

Q: According to Transport Phenomena experiment, answer the following A Initial weight Final weight (mg)…

A: An equation for absorbance is: A=εcl where A is the absorbance, ε is the molar absorptivity,c is the…

Q: Based on the following SAMPLE 2 data, calculate the concentration (M) of NaOH. Report answer with…

A: Given:   Sample 1 Sample 2 Mass of flask and KHP 94.7994 g 95.3800 g Mass of empty flask…

Q: Initial burette reading (mL) 2.29   1.41   1.95   Molarity of NaOH (M) 0.100   0.100   0.100…

A:

Q: Sample: Soditum AcetateM 9.65 pH (obtained by pH meter) = Reaction needed to predict pH: Equilibrium…

A: Sodium acetate is a salt of weak acid, acetic acid and strong base, sodium hydroxide. The…

Q: To which sample solution the spike will be add? the distillate>130C the mass standard the…

A: A spike is  a known quantity  of analyte added to a sample of test solution whether to redponse to…