To solve the problem concisely using smulink in MATLAB. 8. Build the following communication system model. The model, shown in the following figure, contains the most basic elements of a communication system: a source for the signal, a channel with noise, and means of detecting errors caused by noise. Bernoulli Binary Bernoulli Binary Generator BSC Tx Error Rate Rx Calculation Error Rate Calculation Binary Symmetric Channel Display Set the Error probability for the Binary Symmetric Channel Block 0.01, 0.05, 0.1 and 1.0, and the sampling rate for Bernoulli Binary Generator Block 0.001. Connect the blocks and display the following information for each value of Error probabilities: . The bit error rate. . The number of errors. The total number of bits that are transmitted. Hint: See example-4, page (6-16).

1) A 5 turn, 100 K2 potentiometer shaft is turned 720 degree, the voltage Vout between the arm and ground changes by 16 volts. a. What is the gain (Kp) of the potentiometer in volt/degree? b. What is the ER, the maximum voltage? c. If the measured resistance at midpoint is 50.5 K2, what is its linearity?

How does the concept of duality apply to electrical circuits?

How do you find the values for a combination circuit?