The thermodynamic properties of refrigerant R22 mixture of liquid and vapor leaving the expansion device and entering the evaporator are; pressure of 498 kPa, temperature of 0 °C. fraction dryness (x) of 0.238, saturated liquid enthalpy of 200 kJ/kg, and saturated vapour enthalpy of 405 kJ/kg. The pressure of this refrigerant at the entrance of the condenser is measured to be 19.3 bar. After the subcooling process, the enthalpy in (kJ/kg) and the pressure in (MPa) of this - refrigerant have been measured and were found to be 199.47 kJ/kg and 2.3 MPa O 239.68 kJ/kg and 1.96 MPa O 248.79 kJ/kg and 1.93 MPa 110 52 kJ/kg and 3.1 MPa

The thermodynamic properties of refrigerant R22 mixture of liquid and vapor leaving the expansion device and entering the evaporator are; pressure of 498 kPa, temperature of 0 °C. fraction dryness (x) of 0.238, saturated liquid enthalpy of 200 kJ/kg, and saturated vapour enthalpy of 405 kJ/kg. The pressure of this refrigerant at the entrance of the condenser is measured to be 19.3 bar. After the subcooling process, the enthalpy in (kJ/kg) and the pressure in (MPa) of this - refrigerant have been measured and were found to be 199.47 kJ/kg and 2.3 MPa O 239.68 kJ/kg and 1.96 MPa O 248.79 kJ/kg and 1.93 MPa 110 52 kJ/kg and 3.1 MPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Evaporator single effect is used to upgrade the concentrate 10000 kg/h of tomato juice than 5% solids the total to 30% solids total. Juice enters the Evaporator at 15 °C. The Evaporator is operated with Steam (quality 80%) in 143.27 kPa. The condition of vacuum in the Evaporator allow the juice to a boil on the 75 °C. The hot kind of material dilute is 4.1 kJ/(kg °C) and the product the concentrate is a 3.1 kJ/(kg °C). Count a. The Rate of the needs of steam = ...kg/h. b. The economic steam if the temperature is condensate is released at 75 °C. = ...(kg water evaporated/kg of steam)
(4) all öf th (b) dry saturated liquid refrigerant The refrigerant supplied to a compressor must be (a) superheated vapour refrigerant (c) a mixture of liquid and vapour refrigerant (d) none of these ant compressor is called
Atmospheric air condition of certain locality is at 28 C wet bulb temperature and its moisture content is 18 grams/kilogram of dry air. It is cooled through a R-22 DX type cooling apparatus and leaves the apparatus at 2 OC lower than the air dewpoint temperature. For ideal process, flowing at 1,000 liters/min determine the following: plot the process on the psychrometric chart and label it properly air dry bulb temperature leaving the cooling apparatus how much moisture is dripping in kg/s refrigeration needed in tons
Determine the type of steam, given: Enthalpy: 3423 kJ/kg Pressure: 500 kPa O subcooled Liquid O Wet vapor Saturated Vapor O Superheated Vapor
Q3/ An auditorium is to be maintained at a temperature of 26°C dry bulb and 50% relative humidity. Air is to be supplied at a temperature not lower than 15°C dry bulb. The sensible heat gain is 110 kW and the latent heat gain is 37.5 kW. Take ventilating air as 25% by weight of the air from the room and is at 35°C dry bulb and 60% relative humidity. Determine the refrigeration capacity in tons of refrigeration (TR). Recirculated Air Auditorium 4 m. Conditioner 15°C m mo Qutside Air 3 Fan 26°C Cool Air 50%RH 35°C 60%RH
5. Dry winter atmospheric air at latm, 8°C and 50% bumidity enter an HVAC system at a rate of 10m/hr, where it is isobarically conditioned to 21°C, 50% humidity. A water line supplies saturated water vapour. Determine heating or cooling rate required to accomplish this process. Also determine the rate wat which water must be supplied in the system in KW. Take heat of vaporization of water to be 2539.9kJ/kg. Note IKJ/S = 1KW
using EES, plot the enthalpy of vaporization of refrigerant 134a as a dunction of temp over the temp range -20 C to 80 C by using the clapeyron eqyation and the refrigerant 134a data in the software. Discuss your result give EES CODE
Combined separating and throttling calorimeter is used to find out dryness fraction of steam, following readings were taken: Main pressure = 12 bar abs. Mass of water collected in separating calorimeter = 2 kg. Mass of steam condensed in throttling calorimeter = 20 kg Temperature of steam after throttling calorimeter = 110°C Pressure of steam after Throttling = 1 bar abs. Assume Cp of steam = 2.1 kJ/kg K. Calculate dryness fraction.
An ammonia compressor has a volumetric efficiency of 85%, operating condensing & evaporating temperatures of 40 C & 10 C respectively for a cooling capacity of 10 tons with compression index of 1.2, mean piston speed of 2 m/s, 5% clearance & bore to stroke ratio of 0.7. Determine the following 1. Draw the PH Diagram indicating the temperatures, enthalpies & initial specific volume 2. Refrigerating Effect in kJ/kg 3. Mass flow rate in kg/s
What is the mass flow rate in hot stream kg/s?
Air is to be conditioned to have a final humidity ratio of 0.0194. If 50 cu. meter/min of this saturated air enters the conditioner at 15.64 C and increases its temperature by 20.35.C, using the thermodynamic properties of air formula determine the: NOTE: DO NOT USE PSYCHROMETRIC CHART!!! -Draw the schematic diagram of the problem -the total amount of heat transferred in kW -amount of latent heat added in kW -the sensible heat ratio.
This is for my thermodynamics review problems can you show the full solution... 7. Water vapor at 100 kPa and 150°C is contained in a rigid vessel. At what temperature will the vapor start to condense when the container is cooled slowly? How much heat will have to be removed per kilotram in this cooling process? Ans. 95.68°C, -81.4 kJ/kg