The soil profile at a site is given in figure below. Water in a stand pipe inserted in the sand layer rise to an elevation of +20 m. A real estate company proposes to reclaim the area at this site by pumping out water from the lake and lowering the water level to EL = 0 and then proposes to construct a housing colony at this site. Which of the following observation is correct? -EL = +20 m EL-+10 m EL=0 EL = -20 m EL--30 m- Lake Silt Sand Rock Y=20 kN/m² k= 10 m/s Uniform pore pressure throughout the depth

The soil profile at a site is given in figure below. Water in a stand pipe inserted in the sand layer rise to an elevation of +20 m. A real estate company proposes to reclaim the area at this site by pumping out water from the lake and lowering the water level to EL = 0 and then proposes to construct a housing colony at this site. Which of the following observation is correct? -EL = +20 m EL-+10 m EL=0 EL = -20 m EL--30 m- Lake Silt Sand Rock Y=20 kN/m² k= 10 m/s Uniform pore pressure throughout the depth

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter16: Soil Improvement And Ground Modification

Section: Chapter Questions

Problem 16.12P

See similar textbooks

Similar questions

For a given soil, derive the following relation by drawing the three-phase diagram: Y: = Gs yw (1 - n) (1 + w)
For a given soil, show that 1+20 Yeat = n Wsat For o nivan show chat vthat
For a given soil, derive the following relation by drawing the three-phase diagram: γt = Gs γw (1 − n) + n S γw
The head of a groundwater aquifer is described in Cartesian coordinates by 1 h(x, y) = 1+ x2 + y2 + x + xy Which of the following(s) is/are the correct strategy for determining the maximum value of the head of a groundwater aquifer. (Choose all that apply!) A) Ater putting the equation in an appropriate tonm we can apply Bisection Method B) After pasting the eigualicon in an uppoprkate fum we cian apply Ciauss Seldel Meshud C) Alliti putting tie tli inan appipriate fonm we tan apply Newien Methed for systems O D) After putting the equation in an appropriate form we can apply Lagrange Interpolation E) Alser puting thqutn in an appropriate fam we can ply Newton Dividesd Nfferne
Water flows through a sand filter as shown on the figure. The soil has a cross sectional area of 0.39 m². d1=d2=d3=0.58 m. Head difference is 0.84 m. Inflow h Outflow Soil A Soil B Soll C d2 d3- Coefficient of Permeability for Each Soil: Soil A Kax 2.15 x 10-² cm/s Soil A Kaz 1.51 x 10-3 cm/s Soil B Kbx 1.67 x 10.2 cm/s Soil B Kbz 2.86 x 10-³ cm/s Soil C Kcx|3,30 x 102 cm/s Soil C Kcz 3.31 x 10-3 cm/s Compute the interstitial velocity if the soil has a void ratio of 0.77 in meters per minute.. Use 4 decimal places.
As shown in the figure given below, a 5 m thick layer of silty sand overlies a clay layer 3 m in thickness. Below the clay layer, there lies a 4 m thick gravelly sand layer underlain by pervious bedrock. The ground water table is at the ground surface. GWT Silty Sand 5 m Ya = 18 kN/m³ Ys = 19 kN/m3 Clay 1.5 m 3 m Ys = 18 kN/m3 x A Gravelly Sand Ys = 20 kN/m3 2 m 4 m x B WXXX a) Calculate the total stress (0), pore water pressure (u) and effective stress (o') at points "A" and “B". Show your work and tabulate the results in the following form. Point A Point B o (kPa) u (kPa) o' (kPa) b) If ground water table is lowered by 2 m for foundation excavation purposes, calculate the total stress, pore water pressure and effective stress at points "A" and "B" (i) immediately after, (ii) long time after lowering the water table. Show your work and tabulate the results in the following form.
A sample of clay (weight = 13.2 N) is brought back from the field and trimmed to the following dimensions: height = 150 mm and diameter = 75 mm. The water content has been determined to be 25%. The Gs value for the solids is 2.75. Show and complete your phase diagram and find the following parameters: a. Draw a phase diagram b. Complete the phase diagram by finding the parameters of VT, Va, Vw, Vs, MT, Ma, Mw, and Ms. Volume should be expressed in the unit of m' and mass in grams. Show all calculations to receive full credits.
Water flows through a sand filter as shown on the figure. The soil has a cross sectional area of 0.25 m². d1=d2-d3=0.58 m. Head difference is 0.93 m. 7 Inflow Outflow Soil A Soil B Soil C d3 Coefficient of Permeability for Each Soil: Soil A Kax 2.71 x 10-² cm/s Soil A Kaz 1.58 x 10-³ cm/s Soil B Kbx 1.40 x 10-² cm/s Soil B Kbz 2.56 x 10-³ cm/s Soil C Kcx 3.23 x 102 cm/s Soil C Kcz 3.19 x 10-³ cm/s Compute the interstitial velocity if the soil has a void ratio of 0.76 in meters per minute.. Use 4 decimal places.
Example 5.4 The clay layer below was subjected to a surcharge that would a total settlement of 10 inches. If C, = 50ft²/yr, then determine the amount of time required to produce 5 inches of settlement for the two cases below. Sand Sand Clay Har = h/2 Clay Case A 50' Case B 50' h Har Sand Bedrock
Please solve fastly You are an oil and gas exploration reservoir engineer and your manger asked you to calculate the porosity for the following reservoir. Seismic data have been used to delineate reservoir structure (The length of this reservoir is about 200 meter, thickness is 1 meter and width is 0.8 km). A- Calculate the bulk volume of the reservoir in m3 . Make sure all the unit is consistent with each other. B- Assume that the pore spaces of the sediment in the oil-bearing unit are full of oil 32000m3. Calculate the porosity of the reservoir. C- Based on the porosity value. Is this negligible, poor, fair , or very good reservoir ( try to find table for reservoir classification based on porosity value)
Water flows through a sand filter as shown on the figure. The soil has a cross sectional area of 0.33 m². d1=d2=d3=0.52 m. Head difference is 0.92 m. Inflow Outflow Soil A Soil B Soil C -d1- -d2- Coefficient of Permeability for Each Soil: Soil A Kax 2.99 x 10-² cm/s Soil A Kaz 1.44 x 10-³ cm/s Soil B Kbx 1.63 x 10-2 cm/s Soil B Kbz 2.22 x 10-³ cm/s Soil C|Kcx|3.15 x 102 cm/s Soil C Kcz 3.17 x 10-3 cm/s Compute the flow of water through the soils in liters/sec. Use 4 decimal places.
3.15 In a site consisting of normally consolidated clean sands, the water table is at 10 ft depth. The average unit weight of the sand above and below the water table is 111.5 lb/ft3 and 125.0 lb/ft3, respectively. At a 25 ft depth, Nso was reported as 26. Determine the following: a. (N160 using Liao and Whitman's (1986) equation for CN [Eq. (3.13)] b. D, using Skempton's (1986) correlation [Eq. (3.28)] c. Friction angle using Schmertmann's (1975) correlation [Eq. (3.30)] d. Modulus of elasticity using Kulhawy and Mayne's (1990) correlation [Eq. (3.32)]