The results of two consolidated-drained test triaxial tests on a clay are given below: Specimen No. Chamber Pressure Deviator Stress 105 210 220 400 1. Determine the angle of internal friction. 2. Determine the cohesion of the clay. 3. Determine the normal stress on the point on the failure plane of the 2nd specimen. O Question 1: A. 26.744 O Question 1: B. 26.042 O Question 1: C. 27.871 O Question 1: D. 27.486 O Question 2: A. 10.737 O Question 2: B. 12.141 O Question 2: C. 17.372 O Question 2: D. 14.836 O Question 3: A. 317.694 O Question 3: B. 232.575 O Question 3: C. 230.306 O Question 3: D. 322.194

The results of two consolidated-drained test triaxial tests on a clay are given below: Specimen No. Chamber Pressure Deviator Stress 105 210 220 400 1. Determine the angle of internal friction. 2. Determine the cohesion of the clay. 3. Determine the normal stress on the point on the failure plane of the 2nd specimen. O Question 1: A. 26.744 O Question 1: B. 26.042 O Question 1: C. 27.871 O Question 1: D. 27.486 O Question 2: A. 10.737 O Question 2: B. 12.141 O Question 2: C. 17.372 O Question 2: D. 14.836 O Question 3: A. 317.694 O Question 3: B. 232.575 O Question 3: C. 230.306 O Question 3: D. 322.194

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter12: Shear Strength Of Soil

Section: Chapter Questions

Problem 12.13P

See similar textbooks

Similar questions

9. A consolidated drained test was carried out on a sandy clay under a cell pressure of 250 kPa. A constant back pressure of 120 kPa applied throughout the test. The dimensions of the sample were 76 mm x 38 mm. Addional test data recorded at failure were: Load transducer force = 368 N 3 Measured change in volume = 2.42 x 10 m³ Axial deformation = 2.05 mm Determine the major principal stress, o, at failure. (455 kPa)
A series of drained tri-axial tests were carrierd aut on a specimens of a sand prepared at the same porosity and the following results wer obtained at failure All Around Pressure, kPa 50 100 Principal Stress Difference, kPa 180 285 Calculate the value of the angle of shearing resistance What is the value of coliesion, Pa The maximum principal stress in kPa for a chamber pressure of 135 kPa
Can TRIAXIAL TESTS be performed on sand samples? Briefly explain. The results of an undrained triaxial test on a clay soil sample are given in table below Cell Pressure (kN/m2) 200 400 600 Additional Axial Load at Failure (N) 342 388 465 Each sample, originally 76mm long and 38mm in diameter, experienced a vertical deformation of 5.1mm. Evaluate the stress at failure for each cell pressure given in table above. Draw Mohr Circles and determine the shear strength parameters of the soil.
A triaxial shear test was performed on a well-drained sand sample. The normal stress on the failure plane and the shear stress on the failure plane, at failure were determined to be 6100 psf and 4600 psf, respectively. a. Determine the angle of internal friction of the sand? b. Determine the angle of the failure plane? c. Determine the maximum principal stress? Please answer this asap. For upvote. Thank you very much
A drained triaxial test on the normally consolidated clay showed that the failure plane makes an angle of 58 with the horizontal. If the sample was tested with a chamber confining pressure of 103.5kPA, what was the major principal stress at failure? (Unit in kPa) (Answer only number(whole number without unit)
: In a tri-axial test of a silty soil, the sample failed at normal stress of 475 kPa and a shear stress of 350 kPa. Which of the following gives the angle of internal friction? Compute the angle that the failure plane makes with the x-axis. Compute the maximum failure stress.
d) An oedometer test was also performed on a (saturated) reconstituted sample obtained at the site. The initial void ratio was calculated as 1.005 and the initial sample height was 20 mm. The following measurements were reported for each of the 24-hr stress increments: Table 4. Oedometer test measurements Normal stress (kPa) 1.5 13 26 52 104 208 416 Change in sample height (mm) 0.419 0.199 0.229 0.209 0.208 0.199 Plot the evolution of the void ratio resulting from the data above using semi-logarithmic axes (i.e. produce an e-log o'y plot). Is there anything you can comment on the stress history and consolidation state of the soil?
Question 42 The results of two consolidated-drained test triaxial tests on a clay are given below: Specimen No. Chamber Pressure Deviator Stress 105 220 210 400 1. Determine the angle of internal friction. 2. Determine the cohesion of the clay. 3. Determine the normal stress on the point on the failure plane of the 2nd specimen. Question 1: A. 26.744 O Question 1: B. 26.042 Question 1: C. 27.871 O Question 1: D. 27.486 Question 2: A. 10.737 O Question 2: B. 12.141 Question 2: C. 17.372 Question 2: D. 14.836 Question 3: A. 317.694 O Question 3: B. 232.575 Question 3: C. 230.306 O Question 3: D. 322.194
3 A sample of soil was subjected to a series of triaxial tests. The results were as shown in the table. If a third test is made with a cell pressure of 250 kPa. Determine the value of the maximum principal stress (in kPa) for the third test. 03 (kPa) 60 01 (kPa) 165 130 280 The value must be a number
1. Triaxial compression tests are done on quartzite rocks, the results are shown below. (0₁+03)/2 -964.25 14500 19575 23200 29000 43210 63075 psi (01-03)/2 964.25 14500 18850 21750 26100 35960 48575 psi Comment on the applicability of each of the Mohr-Coulomb, Griffith, and Hoek-Brown criteria for the testing results.
A sand sample is subjected to direct shear testing. Two tests areperformed. For test 1, The sample shears at a stress of 2500 psf whenthe normal stress is 4000 psf.Test 2, The sample shears at a stress of 3500 psf when the normalstress is 6000 psf. Determine the following:a) Angle of Internal frictionb) Value of cohesionc) Compute the shear stress at a depth of 12 ft. if the unit weight ofthe soil is 150 pcf
Two undrained triaxial tests were conducted on soil specimen, and they gave the following results: Sample Confining Pressure Deviator Stress A 350 kN/m² B 500 kN/m² 150 kN/m² 300 kN/m² The shear strength of sample A in the plane of it's normal stress is A 588 kPa B 283 kPa C 730 kPa D 165 kPa Correct Option